KIO3-KI混合液中各组分含量的测定

对武汉大学主编《分析化学实验》教材中KIO3-KI混合溶液各组分含量的测定作了较详细的探讨，获得了较高的回收率，且重复性好，对学生掌握分析方案设计有着较好的指导意义。     

Investigation on the Performance of Supported Molybdenum Carbide for the Partial Oxidation of Methane

The performance of uspported and unsupported molybdenum carbide for the partial oxidation of methane (POM) to syngas was investgated.An evaluation of the catalysts indicates that bulk molybdenum carbied has a higher methane conversion during the initial stage but a lower selectivity to CO and H2/CO ratio in the products.The rapid deactivation of the catalyst is also a significant problem.However,the supported molybdenum carbide catalyst shows a much higher methane conversion,increased selectivity and significantly improved catalytic stability.The characterization by XRD and BET specific area measurements depict an improved dispersion of molybdenum carbide when using alumina as a carrier.The bulk or the supported molybdenum carbide exists in the β-Mo2C phase,while it is transformed into molybdenum dioxide postcatalysis which is an improtant cause of molybdenum carbide deactivation.     

植入用Co—Cr—Mo合金与Ti—6Al—4V合金的电偶腐蚀研究

组件式设计常被用地人工髋关节，钴络钼合金（Ｃｏ－Ｃｒ－Ｍｏ）与钛合金（Ｔｉ－６Ａｌ－４Ｖ）的压配最常用，本文应用电化学方法研究了静态条件下两种合金的电偶腐蚀行为，浸泡实验表明，钴络钼合金为阳极，但电偶电流与其维钝电流相近，并无明显加速度腐蚀效应，钛合金为阴极，受到保护，失重及金相观察结果显示，在４５天的浸泡实验周期内，未发现腐蚀痕迹，混合电位理论和电位处于两种合金的钝化电位区，电偶电流为合金的维钝     

超细Mo／Al2O3催化剂（I）：催化及还原性质研究

研究两种不同制方法－浸渍法和超临界流体干燥法制得的超细Ｍｏ／Ａｌ２Ｏ３催化剂的加氢与加氢脱硫催化性质及还原性质，并与以普通Ａｌ２Ｏ３作载体体制得的Ｍｏ／ＡｌＯ３催化剂相比较。结果表明，超细粒子催化剂催化性质较大度的地受制备方法的影响。ＴＰＲ，ＸＲＤ，ＬＲＳ分析结果表明，超细氧化铝载体和超临界流体干燥法的使用均有利于Ｍｏ在Ａｌ２Ｏ３表面的分散。     

多中心d—pπ键与高氧化态钼簇合物的几何构型（I）“碎片结构”模型及分子轨

本文通过对不同构型的二核钼簇合物簇胳结构的分子轨道计算,揭示了Mo-B（T）原子间的多中心d-pπ键与该结构的稳定性及结构参数a,q和之间的内在联系，提出了2－6核高氧化态钼簇合物的簇胳由“碎片结构”组合而成的设想，该模型对以u2-S2为桥的三桥钼簇合物中的“共面－异面”规划的和簇胳为[Mo3S3O]^6 的钼簇中的反[常Mo-Mo键距级出合理解释，确认了桥原子对Mo-Mo键长和键强的决定作用。     

Keggin型磷钼杂多蓝的制备新方法——射频氢等离子体固相还原法

将射频等离子体技术应用于杂多蓝的制备中, 成功地制备出四电子还原的磷钼杂多蓝, 并对所制备的杂多蓝进行了结构表征及性质研究, 探讨了磷钼杂多酸在射频氢等离子体中的还原行为.     

Nonlinear Optical Properties of Tri—nuclear Transition Metal Clusters M—（μ—S）s—M′（M=Mo,W;M′=Cu,Ag,Au）

The static polarizabilities and the second-order hyperpolarizabilities of a series of tri-nuclear metal cluster models MS4(M′PPh3)2(M′PPh3)(M=Mo,W;M′=Cu,Ag,Au)have been calculated within the first-principle theoretical framework. The model clusters have two fragments of rhombic units and it is the charge ransfer from one of these moieties to the other that is responsible for nonlinear optical property. This kind of electronic delocaization, differentiated from that of planar π-system, is very interesting and is worthy for further investigation.     

K-Mo基催化剂的表面酸性与其合成醇选择性

对500℃和800℃焙烧制得的氧化态K－MoO3／γ－AlO3，K－MoO3／SiO2及非负载K－Mo催化剂进行硫化后，测试其合成醇活性．结果表明500℃焙烧制得的负载型催化剂显示较高的合成低碳烃活性和较低的合成低磷醇选择性，经800℃焙烧后，合成低磷醇的选择性大幅度提高．500℃焙烧的非负载K－Mo催化剂显示较高的合成醇选择性，经800℃焙烧后，促碳醇的选择性保持不变．用氨的吸附及TPD方法测定了各样品的酸性，并与催化剂活性对照，发现催化剂酸性越强，酸量越大，则其合成醇选择性越低．催化剂上的乙醇分解实验证实，催化剂的酸量大小与它的醇分解活性成正变关系，这些结果说明催化剂酸性对其合成醇性能有直接的影响．     

Synthesis and Crystal Structure of Mo(CO)_4(NNP) (NNP=2-(N-Cyclohexyl-N-diphenylphosphinomethyl)aminopyridine)

1 INTRODUCTION The pyridyl-phosphine ligands have been widely used for many years to synthesize hetero- or homo-nuclear metal complexes[1], as electronic differentiation associated with the hard (N) and soft (P) donor atoms dictates their unique reactivities and coordination modes. One of the most common pyridylphosphines studied to date is (2-C5H4N)PPh2 which displays numerous ligating modes ranging from P-coordination and P,N-chelation to the more common P,N-bridging of two metal …     

丁基罗丹明B—钼酸盐光度法连续测定铈和钪

在聚乙烯醇（ＰＶＡ）存在下，丁基罗丹明Ｂ（ＢＲＢ）分别与铈钼、钪钼杂多酸络阴离子形成离子缔合物，其最大吸收均位于５７０ｎｍ，表面摩尔吸光度分别为εＣｅ＝３．９６×１０＾６Ｌ．ｍｏｌ＾－１．ｃｍ＾－１，εＳｃ＝４．７１×１０＾５Ｌ．ｍｏｌ＾－１．ｃｍ＾－１，服从比耳定律范围分别为０－２４μｇ／Ｌ Ｃｅ和０－６０μｇ／ＬＳｃ，测定极限为Ｃｅ１．０μｇ／Ｌ（ｎ＝１２）和Ｓｃ１．９μｇ／Ｌ（ｎ＝１０），对