Developing AMS measurement of 59Ni at CIAE

Accelerator mass spectrometry (AMS) measurement of ⁵⁹Ni has been established at CIAE with the HI-13 tandem accelerator and the recently developed ΔE-Q3D detection system. ⁵⁹Ni standard and commercial NiO samples were measured to check the performance of the ΔE-Q3D detection system on ⁵⁹Ni isobar separation and suppression. An overall suppression factor of about 10⁷ for the interfering isobar ⁵⁹Co resulting in detection sensitivity as low as 3.8×10^-13 atomic ratio (⁵⁹Ni/Ni) has been obtained. Based on these techniques, the AMS measurement method of ⁵⁹Ni with high sensitivity is developed.     

多层高温超导薄膜研究

文中以LaAlO3为衬底,制作了一层Tl-2212高温超导薄膜,并在薄膜上生长一层较薄的CeO2缓冲层,然后再在上面生长一层Tl-2212高温超导薄膜。经过测量,研究了多层膜结构对超导薄膜临界电流密度的影响。结果显示,在缓冲层的结晶过程中超导薄膜的晶格受到影响,结晶过程中的处理很容易诱导上面一层Tl-2212超导薄膜产生杂相,导致临界电流密度降低。     

高温超导四工器的设计与仿真

文中基于单端口群时延设计了一款高温超导四工器。该四工器为四个四阶的滤波器并联,采用半波长开环耦合结构和L型谐振器,最终仿真回波损耗可以达到-24.4dB以下,与理想曲线吻合良好。本设计方法很好的解决了以往多工器占用面积过大、不同信道之间影响严重、仿真时间较长的问题,实现了超导多工器小型化,并缩短了多工器的设计周期。     

嵌入Fabry-Perot谐振腔的高温超导双晶约瑟夫森结的毫米波辐照特性研究

采用嵌入Fabry-Perot谐振腔的方式,研究了Tl2Ba2CaCu2O8(Tl-2212)高温超导薄膜双晶约瑟夫森结的毫米波辐照特性.重点研究了双晶约瑟夫森结与Fabry-Perot谐振腔的耦合特性,发现放置在谐振腔中的结的位置、角度、结的图形以及Fabry-Perot谐振腔中两镜面间的距离等对耦合都有很大的影响.通过精细调节这些参数,可使双晶约瑟夫森结与外加毫米波达到最佳耦合.在最佳耦合情况下,能观察到9级明显的夏皮罗台阶.利用Fabry-Perot谐振腔技术,解决了约瑟夫森结与毫米波的耦合问题,为高温超导约瑟夫森结的毫米波及太赫兹波的辐射和检测研究奠定了基础.     

高温超导双晶约瑟夫森结阵列毫米波相干辐射

研究了嵌入Fabry-Perot谐振腔的高温超导双晶约瑟夫森结阵列毫米波相干辐射的实验结果.相干辐射是通过约瑟夫森结阵列与基片(作为一个介质谐振器)和Fabry-Perot(FP)谐振器的共同作用实现的.由166个高温超导双晶约瑟夫森结串联阵列在77 K温度下产生的相干辐射,辐射峰的中心频率为75.84 GHz,功率大约为10 pW. 关键词： 高温超导薄膜 Fabry-Perot谐振腔 约瑟夫森结 毫米波辐射     

Recent progress in AMS measurement of 182Hf at the CIAE

In order to improve the accuracy of accelerator mass spectrometry (AMS) measurement for ¹⁸²Hf/¹⁸⁰Hf, a series of measurements have been taken in the AMS laboratory at the China Institute of Atomic Energy (CIAE). The major ones include the instantaneous monitoring of ¹⁸⁰HfF₅^- current, testing the stability of transmission, the alternate measurements of an unknown sample and standard, and the origin identification and minimization of background ¹⁸²W. The experimental details and the improvement in the measurement accuracy, as well as some useful suggestions for better satisfying the requirements of certain practical applications, are presented in this paper.     

基于Rb原子电磁诱导透明的量子干涉实验研究

报道了基于85RbD2线电磁诱导透明(EIT)的量子干涉现象,发现当一耦合光和探测光之间满足拉曼共振条件时出现电磁诱导透明现象,在某些条件下也观察到电磁诱导吸收(EIA).而当用一束耦合光和一束泵浦光共同作用于5S1/2,F=3→5P3/2,F′=3和5S1/2,F=3→5P3/2,F′=4能级上时,探测光的吸收谱表现出三峰结构,并且峰强弱与两耦合光之间的相对强度有关.     

利用加速器质谱方法测量14N(16O,α)26Al反应截面

Al是核天体物理非常重要的一个核素,14N(16O,α)26Al的反应截面可能是天体26Al的一个来源.介绍了利用AMS方法测量14N(16O,α)26Al反应截面的过程,包括靶的照射、化学分离、26Al原子数的AMS方法测量及最后的核反应截面值.The~(26)Al is one of the important nuclide in the astrophysics. The reaction, namely~(14)N(~(16)O, α)~(26)Al, may be one of the origin of the source of~(26)Al in the cosmic. The procedures of the cross section measurement with accelerator mass spectrometry (AMS) method are discussed, In this paper, the irradiation experiment, chemical separation and~(26)Al measurement are described. The results of cross-section (around) sub-barrier energies are also represented.     

Direct Measurement of Light Speed Reduction in a Rubidium Vapour Medium Coherently Prepared by Electromagnetically Induced Transparency

We have experimentally observed the reduction of light speed in a rubidium vapour medium coherently preparedby electromagnetically induced transparency. The light speed reduction was deduced by directly measuring thetime delay of a probe light when it passed through the medium. The time delay varies with the intensity of thecoupling laser, and the typical time delay we recorded was 1.8 μs, corresponding to a light speed of 56000 m/s.     

加速器质谱法测量41Ca及其应用研究

Ca在自然界中含量丰富，其长寿命放射性同位素^41Ca不仅是理想的生物医学示踪剂，同时在地质年代的测定、环境科学和核天体物理的实验研究等方面都有着非常重要的作用．加速器质谱法目前是测量^41Ca的理想方法．文章介绍了用加速器质谱测量^41Ca的方法，介绍了目前的国际研究现状和潜在的应用研究领域以及中国原子能科学研究院在加速器质谱测量^41Ca方面的研究情况。