Stabilization of Titanium Dioxide Nanoparticles at the Surface of Carbon Nanomaterials Promoted by Microwave Heating

TiO₂ is frequently combined with carbon materials, such as reduced graphene oxide (RGO), to produce composites with improved properties, for example for photocatalytic applications. It is shown that heating conditions significantly affect the interface and photocatalytic properties of TiO₂@C, and that microwave irradiation can be advantageous for the synthesis of carbon‐based materials. Composites of TiO₂ with RGO or amorphous carbon were prepared from reaction of titanium isopropoxide with benzyl alcohol. During the synthesis of the TiO₂ nanoparticles, the carbon is involved in reactions that lead to the covalent attachment of the oxide, the extent of which depends on the carbon characteristics, heating rate, and mechanism. TiO₂ is more efficiently stabilized at the surface of RGO than amorphous carbon. Rapid heating of the reaction mixture results in a stronger coupling between the nanoparticles and carbon, more uniform coatings, and smaller particles with narrower size distributions. The more efficient attachment of the oxide leads to better photocatalytic performance.     

制备工艺对Mn-Fe/ZSM-5催化剂在NH3-SCR催化还原反应中催化性能的影响

分别采用共沉淀法和浸渍法、不同铁前驱物以及不同焙烧温度等研究了制备工艺对Mn-Fe/ZSM-5催化剂的结构、化学组分及NH3-SCR活性的影响。结果显示,当采用Fe(NO3)3作为Fe前驱物,并用共沉淀法制备、300°C焙烧条件下得到的MFZ-CP-N-300样品低温活性最优,在120°C时,其NO的转化率达到96.7%,120-300°C范围内NO转化率始终保持在95%以上。同时利用XRD、NH3-TPD、XPS、SEM、TEM、氮吸附等手段对催化剂结构、晶相、酸位、锰铁氧化物的化学形态及表面的形貌特征进行表征分析。结果表明锰铁氧化物分别以MnO2-Mn2O3和Fe2O3的形式高度分散于催化剂表面,特别是当Mn4+/Mn3+比例为1.254时,有较强的表面中强酸和较多的酸位数,从而增加了NH3的吸附能力,提高NO的转化率。     

Direct Determination of Trace Dopamine in an Ascorbic Acid Solution at a Bare Glassy Carbon Electrode Using Differential Pulse Voltammetry

It is difficult to monitor dopamine (DA) accurately with a bare glassy carbon electrode because of the interference of ascorbic acid (AA). In this paper, a method for the determination of DA in an AA solution using differential pulse voltammetry was established. Because AA loses its electrochemical activity after being oxidized, hydrogen peroxide was used to oxidize AA, and the interference of AA was completely eliminated. As a result, trace DA could be directly determined in the AA solution with a bare glassy carbon electrode. When trace DA was determined in a 1.0 mmol L^?1 AA solution, there was a wide linear range from 3.0×10^?8 mol L^?1 to 1.0×10^?5 mol L^?1. The application of this method was demonstrated by the selective measurement of DA in an injection without pretreatment.     

Dual gold nanoparticle lateflow immunoassay for sensitive detection of Escherichia coli O157:H7

Two patterns of signal amplification lateral flow immunoassay (LFIA), which used anti-mouse secondary antibody-linked gold nanoparticle (AuNP) for dual AuNP-LFIA were developed. Escherichia coli O157:H7 was selected as the model analyte. In the signal amplification direct LFIA method, anti-mouse secondary antibody-linked AuNP (anti-mouse-Ab-AuNP) was mixed with sample solution in an ELISA well, after which it was added to LFIA, which already contained anti-E. coli O157:H7 monoclonal antibody-AuNP (anti-E. coli O157:H7-mAb-AuNP) dispersed in the conjugate pad. Polyclonal antibody was the test line, and anti-mouse secondary antibody was the control line in nitrocellulose (NC) membrane. In the signal amplification indirect LFIA method, anti-mouse-Ab-AuNP was mixed with sample solution and anti-E. coli O157:H7-mAb-AuNP complex in ELISA well, creating a dual AuNP complex. This complex was added to LFIA, which had a polyclonal antibody as the test line and secondary antibody as the control line in NC membrane. The detection sensitivity of both LFIAs improved 100-fold and reached 1.14 × 10³ CFU mL⁻¹. The 28 nm and 45 nm AuNPs were demonstrated to be the optimal dual AuNP pairs. Signal amplification LFIA was perfectly applied to the detection of milk samples with E. coli O157:H7 via naked eye observation.     

Experimental and theoretical study of thermodynamic properties of levoglucosan

The heat capacity of levoglucosan was measured over the temperature range (5 to 370) K by adiabatic calorimetry. The temperatures and enthalpies of a solid-phase transition and fusion for the compound were found by DSC. The obtained results allowed us to calculate thermodynamic properties of crystalline levoglucosan in the temperature range (0 to 384) K. The enthalpy of sublimation for the low-temperature crystal phase was found from the temperature-dependent saturated vapor pressures determined by the Knudsen effusion method. The thermodynamic properties of gaseous levoglucosan were calculated by methods of statistical thermodynamics using the molecular parameters from quantum chemical calculations. The enthalpy of formation of the crystalline compound was found from the experiments in a combustion calorimeter. The gas-phase enthalpy of formation was also obtained at the G4 level of theory. The thermodynamic analysis of equilibria of levoglucosan formation from cellulose, starch, and glucose was conducted.     

Gas-phase thermochemical properties of some tri-substituted phenols: A density functional theory study

The study of the energetics of phenolic compounds has a considerable practical interest since this family of compounds includes numerous synthetic and naturally occurring antioxidants. In this work, density functional theory (DFT) has been used to investigate gas-phase thermochemical properties of the following tri-substituted phenols: 2,4,6-trimethylphenol, 2,6-dimethyl-4-tert-butylphenol, 2,6-dimethyl-4-methoxyphenol, 2,4,6-tri-tert-butylphenol, 2,6-di-tert-butyl-4-methylphenol, 2,6-di-tert-butyl-4-methoxyphenol, 2,4,6-trimethoxyphenol, 2,6-dimethoxy-4-methylphenol and 2,6-dimethoxy-4-tert-butylphenol. Molecular structures were computed with the B3LYP and the ωB97X-D functionals and the 6-31G(d) basis set. More accurate energies were obtained from single-point energy calculations with both functionals and the 6-311++G(2df,2pd) basis set. Standard enthalpies of formation of the phenolic molecules and phenoxyl radicals were derived using an appropriate homodesmotic reaction. The OH homolytic bond dissociation enthalpies, gas-phase acidities and adiabatic ionization enthalpies were also calculated. The general good agreement found between the calculated and the few existent experimental gas-phase thermochemical parameters gives confidence to the estimates concerning the phenolic compounds which were not yet experimentally studied.     

Thermodynamic properties of xanthone: Heat capacities,phase-transition properties,and thermodynamic-consistency analyses using computational results

Heat capacities and phase-transition properties for xanthone (IUPAC name 9H-xanthen-9-one and Chemical Abstracts registry number [90-47-1]) are reported for the temperature range 5 < T/K < 524. Statistical calculations were performed and thermodynamic properties for the ideal gas were derived based on molecular geometry optimization and vibrational frequencies calculated at the B3LYP/6-31+G(d,p) level of theory. These results are combined with sublimation pressures from the literature to allow critical evaluation of inconsistent enthalpies of sublimation for xanthone, also reported in the literature. Literature values for the enthalpy of combustion of xanthone are re-assessed, a revision is recommended for one result, and a new value for the enthalpy of formation of the ideal gas is derived. Comparisons with thermophysical properties reported in the literature are made for all other reported and derived properties, where possible.     

Structure and electronic properties of hollow‐caged C60 fullerene‐derived (MN4)nC6(10 − n) (M = Zn,Mg, Fe,n = 1−6) complexes

Unique hollow‐caged (MN₄)_nC_{6(10 ? n)} (M = Zn, Mg, Fe, n = 1?6) complexes designed by introduction of n porphyrinoid fragments in C₆₀ fullerene structure were proposed and the atomic and electronic structures were calculated using LC‐DFT MPWB95 and M06 potentials and 6‐311G(d)/6‐31G(d) basis sets. The complexes were optimized using various symmetric configurations from the highest O_h to the lowest C₁ point groups in different spin states from S = 0 (singlet) to S = 7 (quindectet) for M = Fe to define energetically preferable atomic and electronic structures. Several metastable complexes were determined and the key role of the metal ions in stabilization of the atomic structure of the complexes was revealed. For Fe₆N₂₄C₂₄, the minimum energy was reported for C_2h, D_2h, and D_4h symmetry of pentet state S = 2, so the complex can be regarded as unique molecular magnet. It was found that the metal partial density of states determine the nature of HOMO and LUMO levels making the clusters promising catalysts. © 2014 Wiley Periodicals, Inc.     

Stereoselective Total Synthesis of Decytospolides A and B Starting from D‐Mannitol

The stereoselective total synthesis of decytospolides A and B, two naturally occurring pyran derivatives, has been achieved using D ‐mannitol as the starting material. The intramolecular oxa‐Michael reaction has been employed to construct the tetrahydropyran ring of the molecules and Weinreb amide formation to generate their side chain with a keto function.     

Standard enthalpies of formation of selected XYZ half-Heusler compounds

The standard enthalpies of formation of selected ternary half-Heusler type compositions XYZ (X = Au, Co, Fe, Ir, Ni, Pd, Pt, Rh, Ru; Y = Hf, Mn, Ti, Zr; Z = Ga, Sn) were measured using high temperature direct reaction calorimetry. The measured standard enthalpies of formation (in kJ/mole of atoms) of the half-Heusler compounds (prototype MgAgAs, Pearson symbol cF12, space group F-43m) are, IrMnSn (−29.4 ± 1.8); NiTiSn (−52.6 ± 2.4); PtHfSn (−98.8 ± 3.4); PtMnSn (−55.8 ± 2.6); PtTiSn (−93.6 ± 3.3); PtZrSn (−104.9 ± 3.8); for the B2 compound (prototype CsCl, Pearson symbol cP2, space group Pm-3m), RuMnGa (−26.9 ± 1.7); for the C1 structured (prototype CaF₂, Pearson symbol cF12, space group Pm-3m) or the C1_b structured compound IrMnGa (−40.9 ± 1.7). Indicative standard enthalpies of formation of the following compounds were obtained, half-Heusler compounds AuMnSn, CoTiSn, IrZrSn, NiHfSn, NiZrSn, PdHfSn, PdZrSn, RhTiSn; Heusler compound (prototype Cu₂MnAl, Pearson symbol cF16, space group Fm-3m) RhMnSn; hexagonal compound (prototype BeZrSi, Pearson symbol hP6, space group P6₃/mmc) PtMnGa and another type of hexagonal compound (prototype RhHfSn, Pearson symbol hP18, space group P-62c) RhHfSn, IrZrsn, RhZrSn. Values were compared with ab initio calculations from AFLOW and OQMD. Lattice parameters of these compounds were determined using X-ray diffraction (XRD) analysis. Microstructures were characterized using scanning electron microscopy (SEM) and energy dispersive spectroscopy (EDS). Selected alloys were further annealed to investigate phase transformations and phase relationships.