碳纤维悬挂支臂疲劳损伤实验研究

对碳纤维复合材料某型飞机垂直尾翼方向舵悬挂支臂完成了谱载疲劳、冲击损伤、损伤扩展和剩余强度试验，采用超声波检查方法对其全过程的损伤状态进行了跟踪实验研究，其结果与位移等试验一致．     

Probing the nature of the contact between fine particles by using ultrasound propagation

The propagation velocity (vs) of an ultrasonic signal through a granular material depends on the type of interparticle contact. For noncohesive glass beads, a power law behavior for consolidation stresses applied (σc) above 1 MPa has been measured in previous work. This equation is compatible with Hertz's interaction law between elastic solids. In the present work, we have tested the propagation velocity of ultrasound signals through a sample of fine powder. The tensile strength and compactivity of the powder were previously measured by means of the Seville powder tester (SPT), indicating plastic deformation of the surface asperities in contact for small to moderate consolidation stresses. However, the measurements of ultrasound propagation at high consolidations presented here are compatible with Hertz's law. This finding suggests that for high consolidation stresses, surface asperities are flattened, and it is therefore the elastic deformation of the bulk of the particles that determines the transmission of ultrasonic pulses.     

超声波辐照和臭氧氧化协同降解废水中的结晶紫

采用超声波辐照、臭氧氧化以及超声波辐照-臭氧氧化降解废水中的结晶紫;考察了废水初始pH、超声波功率和频率、氧气流量、反应温度等因素对降解效率的影响.结果表明:超声波和臭氧对结晶紫的降解具有协同作用;当废水溶液初始质量浓度为200mg.L-1、pH为10.0时,控制超声波功率和频率分别为100 W和30kHz,氧气流量为0.4L.min-1,反应温度为25℃,反应时间为90 min,则总有机碳(TOC)的去除率可达89.2%,相应的一级反应速率常数为2.38×10-2min-1.     

超声波辅助提纯氢化枞酸的研究

以氢化松香为原料、乙醇胺为有机胺、乙酸乙酯为溶剂,在超声波辅助下进行胺化反应制备氢化枞酸乙醇胺盐,再经萃取、重结晶和酸化得到氢化枞酸,采用正交试验考察了超声功率、搅拌转速、反应温度、反应时间对氢化枞酸纯度的影响,结果表明,影响氢化枞酸纯度因素按显著程度依次为反应温度>反应时间>超声波功率>搅拌转速,确定了最佳的胺化反应条件为:反应温度40℃、反应时间40min、超声波功率400W、搅拌转速400r/min,所得氢化枞酸的纯度为94.5%。采用GC、GC-MS、FT-IR、熔点仪和旋光仪对氢化枞酸产品进行了分析鉴定。     

花状3D纳米Pd/CeO2催化剂的制备及其性能研究

以PdCl2为前驱体,十六烷基三甲基溴化铵为保护剂,用超声波膜扩散法制备了Pd纳米粒子溶胶(E,Pd负载量1.0 wt%)。采用水热法制备了3D纳米花状Pd/CeO2催化剂(F),其结构,形貌和物理化学性能经XRD,SEM和N2吸附-脱附表征。考察了晶化时间对F形貌和晶型的影响。结果表明,晶化时间72 h制备的F72具有较高的比表面积(108 m2·g-1)和较大的孔体积(0.11 cm3·g-1);晶化时间48 h制备的F48呈现花状形貌,由大量厚度(20 nm～30 nm)均匀的纳米单元自组装而成。     

超声波燃气表矩形流道的雷诺修正系数仿真研究

在超声波流量计测量技术中, 雷诺修正系数相关的研究对于提高计量精度有重要作用. 为研究矩形流道的雷诺修正系数与雷诺数的关系, 对矩形流道在常温常压流量较小情况下进行仿真, 结果发现: 矩形流道层流状态下的雷诺修正系数与雷诺数呈线性相关. 保持压强、体积流量不变, 在不同温度下进行仿真及拟合, 结果表明: 在不同温度下雷诺修正系数与雷诺数的线性关系依然满足. 在上述实验基础上, 对矩形流道湍流状态下的雷诺修正系数与雷诺数关系进行研究, 通过改变温度、压强和体积流量进行仿真及拟合发现, 矩形流道湍流状态下雷诺修正系数与雷诺数呈非线性相关.     

An expedient one-pot synthesis of highly substituted imidazoles using supported ionic liquid-like phase（SILLP） as a green and effcient catalyst and evaluation of their anti-microbial activity

An effcient method for the synthesis of imidazole derivatives by a three-component condensation of benzil or 9,10-phenanthrenequinone,aldehydes and ammonium acetate using supported ionic liquidlike phase（SILLP）catalyst under ultrasonic irradiation or classical heating conditions is reported.The present methodology offers several advantages,such as excellent yields,simple procedures,short reaction times,simple work-up and mild conditions.The catalyst is easily separated from the products by fltration and also exhibits remarkable reusable activity.These highly substituted imidazoles were also evaluated for their anti-microbial activity.     

Ultrasound-assisted Extraction of Kamebakaurin from Rabdosia excisa by Response Surface Methodology

For the efficient extraction of kamebakaurin（KA）, the ultrasound-assisted extraction（UAE） of KA from Rabdosia excisa（R, excisa） via response surface methodology（RSM） was investigated with high-performance liquid chromatography（HPLC）. Effects of the experimental parameters such as extraction solvent, ratio of liquid to plant material, extraction time and extraction temperature on the extracting efficiency of KA from R. excisa were evaluated, and the purity of KA in residual was calculated. The optimized conditions were 65.5%（volume fraction） acetone, 35 ℃, time of 24.6 min with ultrasound of 80 W/L, 40 kHz, ratio of liquid to plant material at 30：1（mL/g）. The maximum yield of KA is 0.708 mg/kg, with mean purity of 6.09%, indicating that ultrasound-assisted extraction is a feasible and useful method for extracting KA from R. excisa.     

基于超声波换能器的钢筋机械损伤与锈蚀损伤检测及其对比研究

超声导波检测技术有检测耗时少、覆盖范围大等优点.为检测钢筋混凝土结构中钢筋损伤,采用超声波换能器研究不同深度和位置的机械损伤对超声导波传播的影响,建立损伤程度与导波特征关系.通过反射系数C定量分析损伤程度,并结合损伤反射回波判断损伤位置.在钢筋点锈蚀以及均匀锈蚀损伤检测中,锈蚀程度达到最大时,L波实际波速分别为4 738.1 m·s^-1和5 069.7 m·s^-1,以此区分锈蚀损伤与机械损伤,最后基于小波变换的时频分析判断损伤状况.研究成果可为钢筋损伤检测研究提供参考.     

扬州大学成功研制环境监测机器人

据扬州时报报道，扬州大学能动学院成功研制出一款无线环境监测智能机器人，该智能机器人能够对一些要求严苛的特殊环境进行巡视、监控、数据采集、自动分析等工作。机器人监测车载有摄像头、超声波传感器及各种环境参数传感器，车身小巧灵活，适于完成机舱、管道等狭窄区域的环境监测工作。国内研发的移动智能小车，一般都定点安装监测器件或大型移动车载监测器件，而这款无线环境监测智能机器人则具备无线遥控的优势，可以“随心所欲”地进入任何不适合人类进入的危险区域或情况未知区域的环境监测场所。