铺层参考方向选取对大展弦比机翼静气弹特性影响

以大展弦比机翼为研究对象，利用流固耦合方法对复合材料机翼铺层参考方向进行了数值模拟研究，分析了铺层参考方向轴偏角的改变对大展弦比机翼静气动弹性的影响．研究表明：铺层参考方向轴偏角的改变会对机翼气动弹性产生显著的影响．机翼的总体变形与扭转变形随着参考方向轴偏角的改变呈现周期分布；沿着机翼各个方向的挠度也会因为参考方向轴偏角的改变而产生不同的响应．     

考虑几何非线性的复合材料机翼气动弹性分析

本文研究结构几何非线性与气动力非平面效应对大展弦比复合材料机翼的气动弹性行为的影响．将非线性有限元法与曲面涡格法结合，计算机翼静气动弹性变形；通过曲面偶极子格网法结合静气动弹性平衡位置处的结构切线刚度，建立气动弹性方程并求解得到机翼颤振速度．针对板模型机翼，分析了迎角对机翼几何非线性气动弹性特性的影响．结果表明：本文复合材料板模型机翼的颤振形式不受水平弯曲模态影响，属于经典弯扭颤振；在几何非线性的影响下，机翼扭转频率随结构变形增大而明显减小，颤振速度随迎角增大而减小．     

A Reduced Order Cyclic Method for Computation of Limit Cycles

A reduced order cyclic method was developed to compute limit-cycle oscillations for large, nonlinear, multidisciplinary systems of equations. Method efficacy was demonstrated for two simplified models: a typical-section airfoil with nonlinear structural coupling and a nonlinear panel in high-speed flow. The cyclic method was verified to maintain second-order temporal accuracy, yield converged limit cycles in about 10 Newton iterates, and provide precise estimates of cycle frequency. This method was projected onto a low-order space using a set of variables governing the amplitudes of empirically derived modes, which were computed with the proper orthogonal decomposition. In this reduced order form, the cyclic Jacobian was greatly compressed, allowing accurate limit cycle solutions to be very efficiently computed.The U.S. Governments right to retain a non-exclusive, royalty-free licence in and to any copyright is acknowledged.     

An Investigation of Internal Resonance in Aeroelastic Systems

Although the study of internal resonance in mechanical systems has been given significant consideration, minimal attention has been given to internal resonance for systems which consider the presence of aerodynamic forces. Herein, the investigators examine the possible existence of internal resonances, and the related nonlinear pathologies that such responses may have, for an aeroelastic system which possesses nonlinear aerodynamic loads. Evidence of internal resonance is presented for specific classes of aeroelastic systems, and such adverse response indicates nonlinearities may lead to aeroelastic instabilities that are not predicted by traditional (linear) approaches.     

无黏流场中结构振动的气动非阻尼现象

研究跨音速飞行航天器的流-固耦合振动非阻尼现象的作用机理.研究表明,流场中的跨音速激波过程是此类非阻尼现象不可忽略的基本原因之一;由于流场对物体振动响应的滞后,形成了周期变化的分布气动力与物体运动之间有规律的相位差异,这种相位差可以引发局部的非阻尼的脉动力作用.这一机制与流场中的黏性过程如边界层和分离流动无关.单纯考虑黏性现象对非阻尼作用影响的认识是有缺陷的.     

飞行器非线性气动弹性和颤振主动控制研究进展

首先，针对发展性能先进的新一代飞行器所涉及到的非线性气动弹性理论与分析技术，结合国内外研究进展情况，着重从建模技术、求解方法、非线性气弹特性分析几个方面进行概括总结。其次，对在飞行器设计中一直颇受关注的、智能材料在飞行器结构颤振及振动主动控制中应用研究现状也给予简要的介绍。最后指出一些尚待进一步研究的问题。     

Effect of multiple engine placement on aeroelastic trim and stability of flying wing aircraft

Effects of multiple engine placement on flutter characteristics of a backswept flying wing resembling the HORTEN IV are investigated using the code NATASHA (Nonlinear Aeroelastic Trim And Stability of HALE Aircraft). Four identical engines with defined mass, inertia, and angular momentum are placed in different locations along the span with different offsets from the elastic axis while fixing the location of the aircraft c.g. The aircraft experiences body freedom flutter along with non-oscillatory instabilities that originate from flight dynamics. Multiple engine placement increases flutter speed particularly when the engines are placed in the outboard portion of the wing (60–70% span), forward of the elastic axis, while the lift to drag ratio is affected negligibly. The behavior of the sub- and supercritical eigenvalues is studied for two cases of engine placement. NATASHA captures a hump body-freedom flutter with low frequency for the clean wing case, which disappears as the engines are placed on the wings. In neither case is there any apparent coalescence between the unstable modes. NATASHA captures other non-oscillatory unstable roots with very small amplitude, apparently originating with flight dynamics. For the clean-wing case, in the absence of aerodynamic and gravitational forces, the regions of minimum kinetic energy density for the first and third bending modes are located around 60% span. For the second mode, this kinetic energy density has local minima around the 20% and 80% span. The regions of minimum kinetic energy of these modes are in agreement with calculations that show a noticeable increase in flutter speed if engines are placed forward of the elastic axis at these regions.     

Evaluation of linear,inviscid, viscous,and reduced-order modelling aeroelastic solutions of the AGARD 445.6 wing using root locus analysis

Reduced-order modelling (ROM) methods are applied to the Computational Fluid Dynamics (CFD)-based aeroelastic analysis of the AGARD 445.6 wing in order to gain insight regarding well-known discrepancies between the aeroelastic analyses and the experimental results. The results presented include aeroelastic solutions using the inviscid Computational Aeroelasticity Programme–Transonic Small Disturbance (CAP-TSD) code and the FUN3D code (Euler and Navier–Stokes). Full CFD aeroelastic solutions and ROM aeroelastic solutions, computed at several Mach numbers, are presented in the form of root locus plots in order to better reveal the aeroelastic root migrations with increasing dynamic pressure. Important conclusions are drawn from these results including the ability of the linear CAP-TSD code to accurately predict the entire experimental flutter boundary (repeat of analyses performed in the 1980s), that the Euler solutions at supersonic conditions indicate that the third mode is always unstable, and that the FUN3D Navier–Stokes solutions stabilize the unstable third mode seen in the Euler solutions.     

热过屈曲功能梯度壁板的气动弹性颤振

功能梯度材料的宏观物理性能随空间位置连续变化,能充分减少不同组份材料结合部位界面性能的不匹配因素.功能梯度壁板用作高速飞行器的热防护结构,能有效消除气动加热带来的壁板内部热应力集中.本文考虑热过屈曲变形引入的结构几何非线性,分析功能梯度壁板的气动弹性颤振边界.基于幂函数材料分布假设,采用混合定律计算功能梯度材料的等效力学性能.根据一阶剪切变形板理论、冯·卡门应变-位移关系和一阶活塞理论,基于虚功原理建立超声速气流中受热功能梯度壁板的非线性气动弹性有限元方程.采用牛顿-拉弗森迭代法数值求解壁板的热屈曲变形,分析超声速气流对热屈曲变形的影响机理.在壁板热过屈曲的静力平衡位置分析动态稳定性,确定了壁板的颤振边界.研究表明,当陶瓷-金属功能梯度壁板的组份材料沿厚度方向梯度分布时,会破坏结构的对称性导致壁板在面内热应力作用下发生指向金属侧的热屈曲变形.超声速气流中壁板热屈曲变形最大的位置随气流速压增大向下游推移,并伴随屈曲变形量的减小.热过屈曲壁板的几何非线性效应会提高壁板的颤振边界,这种影响在高温、低无量纲速压且壁板发生大挠度热屈曲变形时表现显著.较高无量纲气流速压下由于壁板的热屈曲变形被气动力限定在小挠度范围,几何非线性效应不明显.      

基于随机森林算法的非定常气动力建模研究

针对现有的非定常气动力建模方法对气动弹性预测的准确性和效率问题,将随机森林算法引入非定常气动力建模研究领域,构建了基于随机森林算法的非定常气动力降阶模型。将所得模型用于预测气动弹性,选择二维NACA0012翼型进行颤振边界的预测,选用NACA64A010翼型预测LCO特性,并说明了该降阶模型建模的详细过程,将其计算结果与CFD/CSD耦合计算结果及试验结果进行了对比。研究结果表明,该模型可行、高效且精确,可以快速准确地预测飞行器气动弹性特性。