ICP－MS用于Eu_2O_3标准物质中铝和锌的定值分析

报道了用电感耦合等离子体质谱法测定氧比铕标准物质中Ａｌ_２Ｏ_３和ＺｎＯ的方法。考察了谱干扰和基体影响，采用Ｒｈ为内标较好地补偿了基体铕的影响。方法简便、快速，定值准确、可靠。     

双波长K系数—标准加入吸光光度法同时测定锰和锌

研究应用双波长K系数—标准加入吸光光度法同时测定锰和锌二组分混合物.试验确定了锰和锌测定中K_(Mn)与K_(Zn)的回归方程.对合成试样、人发试样测定,结果满意.     

A new approach for the sequential injection spectrophotometric determination of the total antioxidant activity

A sequential injection system based on the ABTS (2,2′-azino-bis-(3-ethylbenzothiazoline-6-sulphonic-acid) methodology was developed. The proposed method, incorporating a mixing chamber in the side port of the selection valve, was evaluated to measure the total antioxidant activity of several beverages and foods.The ABTS⁺ is generated by oxidation of ABTS with potassium persulfate and is reduced in presence of hydrogen-donating antioxidants converting into a colourless product. The applicability of the developed method was tested by measurement of the antioxidant activity of pure compounds as well as by analysing complex food and beverage samples. The antioxidant activity was presented as l(+) ascorbic acid equivalence. The values obtained by this methodology were not significantly different from the results obtained by the original spectrophotometric ABTS assay. For most of the studied antioxidants, antioxidant activity varied with pH and dilution. The proposed SIA system is suitable for screening direct or diluted total antioxidant activity of pure compounds or food samples.     

Developing a sequential injection-square wave voltammetry (SI-SWV) method for determination of atrazine using a hanging mercury drop electrode

This paper describes the development of a sequential injection analysis method to automate the determination of atrazine by square wave voltammetry exploiting the concept of monosegmented flow analysis to perform in-line sample conditioning and standard addition. To perform these tasks, an 800 μL monosegment is formed, composed by 400 μL of sample and 400 μL of buffer/standard solution. To obtain an efficient homogenization, the sample solution is divided in five zones intercalated by four zones of the Britton-Robinson buffer (pH 2.0) in presence of appropriate concentration of NaNO₃ and varying atrazine standard concentrations. This mixture zone is isolated from the carrier solution by two 100 μL air bubbles. After homogenization in an auxiliary reaction coil the mixture zone is injected toward the flow cell, which is adapted to the capillary of a hanging drop mercury electrode, at a flow rate of 50 μL s⁻¹. After a suitable delay time, the potential is scanned from −0.5 to −1.2 V versus Ag/AgCl using a frequency of 300 Hz and pulse height of 25 mV. The linear dynamic range is observed for atrazine concentrations between 1.16 × 10⁻⁷ and 2.32 × 10⁻⁶ mol L⁻¹, obeying the linear equation i_p = (−6.91 ± 0.07) × 10⁸[atrazine] + (4 ± 8), with r² = 0.9996, for which the slope is given in nA L mol⁻¹. The detection and quantification limits of the method are 2.1 × 10⁻⁸ and 7.0 × 10⁻⁸ mol L⁻¹, respectively. The sampling frequency is 37 h⁻¹, when the standard addition protocol is followed. This frequency can be increased to 42 h⁻¹ if the protocol to obtain in-line calibration curve is used for quantification. The method was applied for determination of atrazine in spiked river water samples and its accuracy was evaluated by comparison with the batch standard addition approach, which revealed that there is no evidence of statistically significant differences between the two methods.     

ICP-MS法快速测定丙烯腈/乙腈中的铁、铜

采用带八级杆碰撞/反应池(ORS)的电感耦合等离子体质谱法(ICP-MS),直接测定丙烯腈或乙腈产品中的Fe、Cu,标准加入法定量.结果表明,方法的线性范围宽,线性相关系数均大于0.999.2种元素的相对标准偏差均低于5%,加标回收率在90%~110%.该方法简便、快速、准确.     

化学计量及其进展

扼要介绍了化学计量主要研究内容和量传方法。并从化学计量技术机构,基准、标准装置,标准物质,检定规程和化学计量学等方面,叙述了化学计量的进展概况。     

光度分析中协同系数补偿方法的研究──三次标准加入法同时测定钼、钨和钛

本文在两次标准加入法[1]的基础上，提出了三组份同时测定的三次标准加入法，并应用于钼、钨和钛的流动注射同时测定。测定条件：［水杨基荧光酮（SAF）］＝1．25　×10-4mol／L，［溴化＋六烷基三甲基铵（CTMAB）」＝2．5×10－3mol／L，pH1．35，25℃，采样、进样时间分别为10s和18s，进样频率128次／h。为消除组份间协同作用引起的吸光度加合性的偏离，定义了三组份协同系数。将其引入三组份同时测定方法，补偿了吸光度对线性的偏离。补偿后钼、钨和钛的测定范围分别为0．05～0．35，0．25～1．00，0．025～0．30mg／L。测定了钢样及模拟样品中钼、钨和钛含量，结果较好。     

ICP－AES中内标法的应用研究 Ⅲ．用内标法校正基体干扰

通过观测基体对分析元素发射强度的干扰情况，分析干扰机制，从而确定用来校正基体干扰的内标元素与分析元素的匹配条件。实验结果表明，只要选择合适的内标元素，可以校正基体干扰。     

Thermodynamics of phenylated polyphenylene between 0 and 340 K

In an adiabatic vacuum calorimeter, the temperature dependence of the heat capacity C _p of phenylated polyphenylene and initial comonomer 1,4-bis(2,4,5-triphenylcyclopentadienone-3-yl)benzene was studied between 6 and 340 K with an uncertainty of about 0.2%. In a calorimeter with a static bomb and an isothermal shield their energies of combustion DUcomb were measured. From the experimental data, the thermodynamic functions C _p ⁰ (T), H ⁰(T)-H ⁰(0), S ⁰(T)-S⁰(0), G ⁰(T)-H ⁰(0) were calculated from 0 to 340 K, and standard enthalpies of combustion ΔH _comb ⁰ and thermodynamic parameters of formation-enthalpies ΔH _f ⁰, entropies ΔH _f ⁰, Gibbs functions ΔG _f ⁰ - of the substances studied were estimated at T=298.15 K at standard pressure. The results were used to calculate the thermodynamic characteristics (ΔH _f ⁰ ,ΔS _f ⁰, ΔG _f ⁰) of phenylated polyphenylene synthesis in the range from 0 to 340 K. This revised version was published online in July 2006 with corrections to the Cover Date.     

The solubilization of alcohols in micellar solutions

The specific conductivities of dodecyldimethylbenzylammonium bromide (C12BBr) have been determined in aqueous butanol and aqueous benzyl alcohol solutions in the temperature range of 5-40°C. From these data the temperature dependent critical micelle concentration (cmc) was determined. The molar fraction of alcohol in the micelle was estimated using the theory suggested by Motomura et al. for surfactant binary mixtures. The thermal properties such as standard Gibbs free energy, enthalpy and entropy of solubilization of alcohols in the micelles were estimated for the phase separation model. The change in heat capacity upon solubilization of alcohol in the micelle has been estimated form the above properties. This revised version was published online in July 2006 with corrections to the Cover Date.