二氧化碳与丙烯直接合成甲基丙烯酸用CuPMo／TiO2催化剂的研究

 用溶胶－凝胶法以磷钼酸（MPA）的铜盐溶液水解钛酸四丁酯制备了CuPMo／TiO2催化剂，并用ICP，XRD，TG－DTA，IR，TPD－MS和微反技术研究了催化剂的化学组成、热稳定性、化学吸附性质和催化性能．结果表明：杂多钼酸盐与TiO2表面通过O2－桥发生键联．在623K下，杂多阴离子仍保持其原有的Keggin结构；CO2在Lewis酸位Cu（Ⅱ）和Lewis碱位Cu－O－Mo桥氧的协同作用下形成卧式吸附态Cu（Ⅱ）←O－（CO）←（O－－Cu）；丙烯以分子吸附态在催化剂上吸附；在空速1500h－1，压力1MPa和温度563K的反应条件下，丙烯的转化率为4．2％，甲基丙烯酸的选择性为96％．     

耐硫催化剂上合成混合醇的研究

通过改进制备方法和添加助剂，用浸渍－热分解法制得了具有高活性和高选择性的MoS2-K-C型耐硫低碳混合醇催化剂。在8.0-11.0MPa,290-340℃，6000-12000h^-1,H2 S 浓度为100ppm 左右的条件下，在直流反应器中对催化剂进行了性能测试，结果表明，醇得率为0.14-0.47gROH(gcat·h)^-1，选择性为89-98%。同时，考察了操作条件对催化剂性能的影响。1042h的试验，证明催化剂具有很好的稳定性。     

Evolution of Er^3＋ Distribution in the Oxyfluoride Glass Ceramics with Heating

The distribution characteristics of Er3+ ions doped in the oxyfluoride glass ceramics containing LaF3 nanocrystals heat-treated at 650 ℃ for different durations were investigated. The results of the integral absorption cross-section analysis demonstrated that the partition fraction of Er3+ in LaF3 nanocrystals increases with prolonging of heating time. The anomalous phenomena of Er3+ emissions in the up-and the down-conversion fluorescence spectra are well explained based on the calculated results.     

Studies of a new series of ion-pair complexes [Mo(dtc)_4][Ln(dtc)_4] (Ln=La-Er,exp.Pm)

A new series of ion-pair complexes [Mo(dtc)4][Ln(dtc)4] (Ln=La-Er, exp. Pm) were synthesized from MoCl5, LnCl3 and Nadtc in anhydrous methanol. The crystal structures of the four complexes, [Mo(dtc)4][Ln(dtc)4] (Ln=Nd, Sm, Ho and Er) have been determined by X-ray diffraction. Spectroscopic properties of all these complexes are also discussed here.     

磷钨钼钒杂多蓝光度法测定钼的探索

本文研究了磷钨钼钒四元杂多酸及其还原产物杂多蓝的形成条件、光度性质、组成和在测定高速钢中高钼的应用。试验表明,磷钨钼钒杂多蓝光度法测定钼具有新颖性、高选择性、较高准确性和简便性,适于高速钢中>1％Mo的测定。     

钇钼钨硅杂多配合物的合成稀土多元渗及导电性

用降解法合成了未见报道的标题配合物.通过化学分析、ICP和TG曲线确定了其化学式为K10H3[Y(SiW9Mo2O39)2];利用IR、XRD、183W-NMR、循环伏安等手段对其结构进行了表征.结果表明,杂多阴离子为α-型Keggin结构.采用稀土多元渗的方法对配合物进行了气相热扩渗,ICP和XPS测试表明,微量的稀土元素La,Sm和Dy可以渗入到配合物的体相,并与组分元素发生键合作用;导电性的测试结果表明,室温扩渗后,试样的电导率提高了约104倍,有望成为具有实际应用的固体电解质.     

Hydrothermal synthesis of potassium molybdenum oxide bronzes: structure-inheriting solid-state route to blue bronze and dissolution/deposition route to red bronze

The hydrothermal syntheses of the alkali metal molybdenum bronzes from starting solids (H_xMoO₃) with structural affinities to the desired products were investigated. Single-phase potassium blue and red bronzes were prepared by the hydrothermal treatments at around 430 K, and characterized by powder X-ray diffraction, IR spectroscopy, and SEM. The formation processes of these two bronzes during the hydrothermal treatments were found to differ. The blue bronze was formed by a structure-inheriting solid-state route from H_xMoO₃ with x<0.3, whereas the red bronze was formed for x>0.3 through a solution dissolution/deposition route via the formation of MoO₃+MoO₂.     

Chloroaqua Complexes [M3S4(H2O)9?xClx](4?x)+ (M = Mo, W; x = 4, 6, 7) and Their Supramolecular Compounds with Cucur[8]uril

Compounds of trigonal cluster chloroaqua complexes with cucurbit[8]uril were synthesized by slowly evaporating HCl solutions of chalcogenides heterometallic cubane cluster complexes of molybdenum and tungsten with cucurbit[8]uril in air; the complexes were characterized by X-ray diffraction analysis: (H₃O)₈[Mo₃S₄(H₂O)_2.5Cl_6.5]₂Cl(PdCl₄)·(C₄₈H₄₈N₃₂O₁₆)· 29H₂O (a = 13.3183(17) Å, b = 13.7104(18) Å, c = 18.225(3) Å; α = 80.263(3)°, β = 77. 958(3)°, γ = 87.149(4)°, V = 3207.4(7) ų, space group P , Z = 1, ρ(calc) = 1.900 g/cm³), (H₃O)₄ [Mo₃S₄(H₂O)₃Cl₆]₂·(C₄₈H₄₈N₃₂O₁₆)₃·68H₂O (a = 21.413(6) Å, c = 49.832(10) Å; γ = 120°, V = 19788(8) ų, space group R , Z = 3, ρ(calc) = 1.695 g/cm³), (H₃O)₆ [Mo₃S₄(H₂O)₃Cl₆]₂Cl₂·(C₄₈H₄₈N₃₂O₁₆)·12H₂O (a = 15.881(2) Å, b = 17.191(2) Å, c = 23.276(4) Å; β = 98.865(15)°, V = 6278.7(15) ų, space group P2₁/c, Z = 2, ρ(calc) = 1.638 g/cm³), [W₃S₄(H₂O)₅Cl₄]₂·(C₄₈H₄₈N₃₂O₁₆)₃·35H₂O (a = 21.038(3) Å; α = 61.20(1)°, V = 6762.0(14) ų, space group R , Z = 1, ρ(calc) = 1.582 g/cm³). The [Mo₃S₄(H₂O)₃Cl₆]²⁻ anion complex was isolated as three geometrical isomers.Original Russian Text Copyright © 2004 by E. V. Chubarova, D. G. Samsonenko, H. G. Platas, F. M. Dolgushin, A. V. Gerasimenko, M. N. Sokolov, Z. A. Starikova, M. Yu. Antipin, and V. P. Fedin__________Translated from Zhurnal Strukturnoi Khimii, Vol. 45, No. 6, pp. 1049–1058, November–December, 2004.     

A Novel Cu-Mo／ZSM-5 Catalyst for NOx Catalytic Reduction with Ammonia

The Cu-Mo/ZSM-5 catalysts with different Cu/Mo ratios were prepared by wet impregnation method, and their catalytic performance for selective catalytic reduction of NOx was studied. The results showed that Cu-Mo/ZSM-5 is a very effective catalyst for NOx catalytic reduction with ammonia, especially when Cu/Mo molar ratio is about 1.5. It not only exhibited the extremely high catalytic activity, but also showed good stability for 02. The bulk phase structure of Cu-Mo/ZSM-5 catalysts was determined by XRD technique, and the results indicated that there is a maximum dispersion for Cu species when Cu/Mo molar ratio is 1.5, and an interaction between Cu and Mo along with HZSM-5 may be present in Cu-Mo/ZSM-5, which may possibly result in a special structure favorable for the catalytic reduction of NOx over Cu-Mo/ZSM-5 catalyst.     

Anodic Stripping Voltammetry of Heavy Metals at Nanocrystalline Boron‐Doped Diamond Electrode

Boron‐doped Diamond (BDD) electrode has become one of the important tools for heavy metal detection. By studying some analytical parameters of DPASV method, like deposition time and potential in different electrolyte concentrations (acetate buffer), the conditions for detecting very low metal ion levels (Zn, Cd, Pb, and Cu) could be chosen. Diluted electrolyte (0.01 M buffer) was one of the factors favoring low detection and quantification limits, but its quantification range is short in comparison to more concentrated media. For ?1.7 V deposition potential, the detection of single metal at ppb levels was reached in 60 s deposition time. Understanding different metal‐metal interactions shows the limits to the simultaneous determination of heavy metals at BDD. Quantification was possible for the simultaneous determination of Zn, Cd and Pb despite the overlapping of Zn and Cd peaks. The performance of the BDD was compared with that of another C‐based solid electrode: the glassy carbon electrode (without mercury plating). A lower base line current, wider potential range, higher sensitivity (3 to 5 times higher than GC) and longevity of the material were noticed for the BDD.