太赫兹波段Smith-Purcell辐射的介质加载光栅高频特性

提出了一种用于Smith-Purcell效应器件的介质加载光栅慢波结构,通过研究该结构的注-波互作用过程,推导出带电子注的色散方程,并数值求解出波的线性增长率.利用色散方程,结合电磁场传播的边界条件,推导出Smith-Purcell效应振荡器工作所需的起振电流.详细研究了高频结构长度、电子注主要参数和介质相对介电常数对起振电流的影响,并与普通金属光栅结构进行了比较.结果表明:保持其他参数不变时,高频结构长度越短,起振电流越大;保持高频结构参数不变时,起振电流随电子注厚度和注-栅距离的增大而增大,随电子注电压的增大而减小;与金属光栅相比,介质的引入提高了注-波互作用的增长率,有效减小了振荡器的起振电流.理论计算结果与软件CHIPIC的模拟结果比较符合.     

Theoretical study of surface plasmons coupling in transition metallic alloy 2D binary grating

The excitation of a surface plasmon polariton (SPP) wave on a metal–air interface by a 2D diffraction grating is numerically investigated. The grating consists of homogeneous alloys of two metals of a formula A_xB_1−x, or three metals of a formula A_xB_yC_z, where A, B and C could be silver (Ag), copper (Cu), gold (Au) or aluminum (Al).It is observed that all the alloys of two metals present a very small change of surface plasmon resonance (SPR) irrespective of composition x. Moreover, the addition of 25% of Al to two metals alloy is insufficient to change the SPR curves. The influence of the different grating parameters is discussed in details using rigorous coupled-wave analysis (RCWA) method. Furthermore, the SPR is highly dependent on grating periods (d_x and d_y) and the height of the grating h. The results reveal that d_x= d_y= 700 nm, h=40 nm and duty cycle w=0.5 are the optimal parameters for exciting SPP.     

In-plane ESPI using an achromatic interferometer with low-coherence laser source

The use of an achromatic interferometer is explored as a means of doing in-plane ESPI measurements using a laser diode as the light source. This interferometer type, which uses a diffraction grating in place of the conventional beamsplitter, has two features that make it suitable for making ESPI measurements over extended areas, even when using a low-coherence laser diode source. First, the parallelogram optical geometry of the interferometer causes all rays passing through to have the same optical path lengths. Second, the interferometer is achromatic, whereby the piezo-actuated mirror that steps the illumination light does so by the same phase angle, independent of wavelength. This latter feature accommodates the spectral impurity of a laser diode source. A periodic variation of fringe visibility is observed in experiments, where narrow ranges of high visibility occur at regular spatial intervals. This behavior derives from the clustered discrete spectral character of laser diode light output. A method to “tune” the interferometer by slightly rotating the diffraction grating is described so as to achieve consistent high fringe visibility throughout the measured images.     

Upgrade of beamline BL08B at Taiwan Light Source from a photon‐BPM to a double‐grating SGM beamline

During the last 20 years, beamline BL08B has been upgraded step by step from a photon beam‐position monitor (BPM) to a testing beamline and a single‐grating beamline that enables experiments to record X‐ray photo‐emission spectra (XPS) and X‐ray absorption spectra (XAS) for research in solar physics, organic semiconductor materials and spinel oxides, with soft X‐ray photon energies in the range 300–1000 eV. Demands for photon energy to extend to the extreme ultraviolet region for applications in nano‐fabrication and topological thin films are increasing. The basic spherical‐grating monochromator beamline was again upgraded by adding a second grating that delivers photons of energy from 80 to 420 eV. Four end‐stations were designed for experiments with XPS, XAS, interstellar photoprocess systems (IPS) and extreme‐ultraviolet lithography (EUVL) in the scheduled beam time. The data from these experiments show a large count rate in core levels probed and excellent statistics on background normalization in the L‐edge adsorption spectrum.     

980nm半导体激光器输出光谱特性的改善

为了改善980nm半导体激光器的输出光谱特性,采用传输矩阵分析法推导了双布喇格光纤光栅谐振腔的传输表达式,对布喇格光纤光栅长度和谐振腔腔长对输出光谱的影响进行模拟仿真,结果表明布喇格光纤光栅长度对输出光谱的影响大于谐振腔腔长对输出光谱的影响,加长布喇格光纤光栅长度能压缩输出光谱线宽.在980nm半导体激光器尾纤上写入不同布喇格光纤光栅长度的双布喇格光纤光栅谐振腔,验证了引入双布喇格光纤光栅谐振腔在压缩980nm半导体激光器输出光谱线宽的同时改善了其输出光谱的稳定性.当环境温度在0~75℃范围内变化时,980nm半导体激光器输出中心波长仅变化0.06nm.     

基于光楔阵列产生光学涡旋阵列的研究

在研究光楔衍射法产生单涡旋的基础上,基于长条形光楔阵列,提出了利用光束阵列衍射产生涡旋阵列的方法.该方法要求光束阵列在平行于光楔边缘方向上的光束间距等于光束直径的整数倍.利用超精密机床采用一体化加工法加工了光楔阵列元件,验证了该方法的可行性.利用空间光调制器快速灵活调整光束阵列的优点,搭建了借助空间光调制器加载达曼光栅衍射产生所需光束阵列的实验光学系统.针对光束阵列与光楔阵列的匹配问题,研究了达曼光栅掩模图基本单元对光束阵列的调控,获得了可调结构的光束阵列.实验产生了拓扑荷一致的光学涡旋阵列,与仿真结果相一致,证明所提方法的有效性.     

光栅投影相位法系统模型及标定方法

本文针对传统投影光栅相位法的光学三角法模型进行了改进,采用直入射光路并配合使用一种简便易行的标定方法,只需使用相移公式求取相位差,而不会引入与系统几何位置关系有关的量,简化了求取高度矩阵的要求。实验结果表明,新系统模型精度良好,测量误差为0.107 mm。采用该模型和标定方法可以克服传统方法系统模型的局限性,最大限度减少误差源并提高抗干扰性。     

分光仪测衍射光栅常量的实验设计与数据处理

不等精密度测量在实验中是很普遍的现象,而在现行的本科基础实验教学中对此的强调是不足的.本文以分光仪测衍射光栅常量的实验为例,针对光学实验在设计与数据处理上强化不等精密度测量进行探索研究.     

Surface profile optimization of antireflection gratings for solar cells

The solar cell efficiency can be improved by antireflection gratings. In this paper, the antireflection gratings with different symmetrical surface profiles are investigated by numerical simulations based on the Rigorous Coupled-Wave Analysis. Simulated results show that the antireflection performance of sharp profile such as quadratic profile has a significant improvement compared with triangular and parabolic profiles, while the top cutoff in the grating tip will severely influence the antireflection performance. Meanwhile, proper length of flat region between grating features in the nonclose-packed triangular antireflection grating can have better antireflection performance than the close-packed counterpart for the same grating period and height. Such antireflection gratings with different surface profiles may offer attractive solutions to current commercial silicon solar cell, as well as organic and other semiconductor material based solar cells.     

Improvement on peak-to-trough ratio of sampled fiber Bragg gratings with multiple phase shifts

Via a cascaded structure, the peak-to-trough ratio is considerably improved for sampled fiber Bragg gratings （SFBGs） based on multiple-phase-shift （MPS） technique. This cascaded filter is composed of two identical SFBGs which are inserted with the increasing or decreasing arrangement of phase shifts. With this inverse arrangement of MPS in grating design, the phase fluctuation of individual SFBG can be compensated, and as a result an excellent phase matching condition is realized. In this way, the peak-to- trough ratio in reflection spectra is improved from 6 to 12 dB when multiplication factor m = 4, and from 5dBto 10dBwhenm=8.