Effect of Filtrated Osmotic Solution Based on Concentrated Chokeberry Juice and Mint Extract on the Drying Kinetics,Energy Consumption and Physicochemical Properties of Dried Apples

Background: Filtration of osmotic solution affects selective penetration during osmotic dehydration (OD), and after drying is finished, this can influence the chemical composition of the material, which is also modified by OD. Methods: Osmotic dehydration was carried out in filtrated and non-filtrated concentrated chokeberry juice with the addition of mint infusion. Then, this underwent convective drying, vacuum-microwave drying and combined convective pre-drying, followed by vacuum-microwave finishing drying. Drying kinetics were presented and mathematical models were selected. The specific energy consumption for each drying method was calculated and the energy efficiency was determined. Results and Discussion: The study revealed that filtration of osmotic solution did not have significant effect on drying kinetics; however, it affected selective penetration during OD. The highest specific energy consumption was obtained for the samples treated by convective drying (CD) (around 170 kJ·g⁻¹ fresh weight (fw)) and the lowest for the samples treated by vacuum-microwave drying (VMD) (around 30 kJ·g⁻¹ fw), which is due to the differences in the time of drying and when these methods are applied. Conclusions: Filtration of the osmotic solution can be used to obtain the desired material after drying and the VMD method is the most appropriate considering both phenolic acid content and the energy aspect of drying.     

单颗粒光散射显微成像技术在生化医药分析中的应用

等离子体纳米颗粒(PNPs)具有体积小、易表面修饰、生物相容性好、毒性低等优点,在生物传感、生物成像、疾病诊断、肿瘤治疗、材料科学等领域得到了广泛的应用。PNPs的光散射光学性质可以通过调节其大小、组成、形貌和微环境来控制,可用于生化和药物分析。此外,由于单粒子散射显微技术具有高空间分辨率和高灵敏度,借助PNPs具有的独特局域表面等离子体共振(LSPR)特性,可在单颗粒水平进行实时成像。根据PNPs的大小、组成、形态、微环境或耦合变化引起的信号变化,研究人员发展了多种显微成像分析方法,主要分为4种,包括散射光谱的波长位移、单粒子散射强度的变化、高通量RGB分析和计数方法。基于纳米颗粒LSPR散射光谱位移变化的方法准确、灵敏,但需要昂贵的单颗粒散射光谱仪和复杂的操作。基于纳米颗粒散射强度变化的方法简单可行,但易受纳米颗粒粒径和曝光时间等因素的影响。高通量RGB分析方法灵敏度高、成本低,但不适用于颜色变化不明显的单颗粒分析,且重复性差。单粒子计数法灵敏度高,但有时粒子分布不均匀,背景杂质的干扰限制了方法的准确度。因此,这4种定量方法各有优缺点。此外,近年来逐渐发展了一些新的定量方法。例如,研究人员开发了新的时间分辨分析定量方法,并将暗场显微镜与偏振器、滤光片等光学器件相结合以消除背景干扰,以及与电化学、拉曼等仪器相结合以扩大应用范围。此外,为提高分析方法的准确度和灵敏度,暗场显微镜与深度学习、云计算、人工智能等现代计算机科学技术的结合,越来越受到人们的欢迎。基于以上原因,该文重点介绍了单粒子光散射显微镜在生化和药物分析领域的应用,总结了近年来的最新研究进展,讨论了单粒子光散射显微镜在定量分析中的几种主要定量方法,提出了未来的发展趋势,以期为相关研究领域的新人提供一定的学术参考。     

First-principles study of fundamental properties and electronic structure of alloys

We have performed first-principles calculations using full-potential augmented-plane-wave method to investigate the fundamental properties of the Cd_1–xZn_xTe alloys. The composition dependence of the lattice constant and the bulk modulus have been estimated from total energy calculations. By means of the analytical fitting the band structures in the vicinity of the Brillouin center a complete set of effective electron- and hole-masses have also been derived. In order to further understand the effects of the chemical bonding on the above macroscopic properties we then studied the relaxation behaviors and the changes of the electronic states upon alloying for x=0.25 system. The results presented here yield a general understanding of the fundamental properties for the Cd_1–xZn_xTe crystals studies.     

水性颜料体系无树脂色浆的制备与应用

中性墨水属于热力学上不稳定的颜料悬浮体系,选择低黏度、高稳定性的色浆是保证墨水体系分散稳定性的重要手段之一。基于此,以颜料炭黑和酞菁蓝为着色剂,配合超分散剂(EK43)与协同增效剂(BM10),制备了两款适用于中性墨水体系的无树脂色浆。首次从色浆粒径与体系分散稳定性角度出发,确定了EK43、BM10用量以及最佳研磨时间,并对其理化性能、稳定性与书写性能进行分析测试。结果表明:在黑色浆中添加质量分数10.0%的EK43、2.5%的BM10,研磨时间为90 min;在蓝色浆中添加质量分数8.0%的EK43、2.0%的BM10,研磨时间为120 min时,两种色浆的粒径与分散稳定性均达到最佳。所制备的无树脂色浆颜料固含量高、黏度较低、储存稳定性好、着色力强,以其调配的中性墨水书写性能良好,且具有较好的离心稳定性和耐热稳定性。     

用于宽谱带发射白色发光二极管的黄色荧光粉Sr8MgAl(PO4)7∶xEu2+的制备及发光性能

通过高温固相反应合成了一系列宽谱带发射黄色荧光粉Sr_8MgAl(PO_4)_7∶x Eu~(2+)(SMAP∶x Eu~(2+)),并对其物质结构、发光性能及其在白色发光二极管(WLED)领域的应用进行了探究。X射线衍射(XRD)测试结果表明,SMAP∶x Eu~(2+)系列荧光粉具有单斜结构和C2/m空间群,激活剂Eu~(2+)离子能够很好地进入SMAP基质中并占据Sr~(2+)离子的晶格位点。漫反射光谱分析显示SMAP基质属于宽带隙材料,带隙宽度为3.60 e V。此外,SMAP∶x Eu~(2+)具有较宽的激发范围(280～500 nm),对应于Eu~(2+)离子的4f~7→4f~65d~1跃迁;在380 nm近紫外光激发下,呈现出450～800 nm的多发光中心的非对称黄光发射,发射峰位于590 nm处。基于高斯多峰拟合结果,得到3个发光中心,分别位于528、600和680 nm。最后,将已制备的黄色荧光粉SMAP∶0.05Eu~(2+)与商业化蓝粉Ba Mg Al_(10)O_(17)∶Eu~(2+)混合涂覆到400 nm芯片上制得色温较好(3 344 K)、显色指数较高(90.1)的WLED。     

Comparison of microbiological loads and physicochemical properties of raw milk treated with single-/multiple-cycle high hydrostatic pressure and ultraviolet-C light

The effects of ultraviolet-C radiation (UV-C, 11.8?W/m²), single-cycle and multiple-cycle high hydrostatic pressure (HHP at 200, 400 or 600?MPa) on microbial load and physicochemical quality of raw milk were evaluated. Reductions of aerobic plate count (APC) and coliform count (CC) by HHP were more than 99.9% and 98.7%, respectively. Inactivation efficiency of microorganisms increased with pressure level. At the same pressure level, two-cycle treatments caused lower APC, but did not show CC differences compared with single-cycle treatments. Reductions of APC and CC by UV-C were somewhere between 200?MPa and 400/600?MPa. Both HHP and UV-C significantly decreased lightness and increased pH, but did not change soluble solids content and thiobarbituric acid-reactive substances’ values. Two 2.5?min cycles of HHP at 600?MPa caused minimum APC and CC, and maximum conductivity. Compared with HHP, UV-C markedly increased protein oxidation and reduced darkening.     

Multi-way dual Cheeger constants and spectral bounds of graphs

We introduce a set of multi-way dual Cheeger constants and prove universal higher-order dual Cheeger inequalities for eigenvalues of normalized Laplace operators on weighted finite graphs. Our proof proposes a new spectral clustering phenomenon deduced from metrics on real projective spaces. We further extend those results to a general reversible Markov operator and find applications in characterizing its essential spectrum.     

Washing off intensification of cotton and wool fabrics by ultrasounds

Wet textile washing processes were set up for wool and cotton fabrics to evaluate the potential of ultrasound transducers (US) in improving dirt removal. The samples were contaminated with an emulsion of carbon soot in vegetable oil and aged for three hours in fan oven. Before washing, the fabrics were soaked for 3 min in a standard detergent solution and subsequently washed in a water bath. The dirt removal was evaluated through colorimetric measurements. The total color differences ΔE of the samples were measured with respect to an uncontaminated fabric, before and after each washing cycle. The percentage of ΔE variation obtained was calculated and correlated to the dirt removal. The results showed that the US transducers enhanced the dirt removal and temperature was the parameter most influencing the US efficiency on the cleaning process. Better results were obtained at a lower process temperature.     

Rationally Designed Axially Chiral Diarylethene Switches with High Helical Twisting Power

Three rationally designed axially chiral diarylethene switches were synthesized and their application as chiral dopants for phototunable cholesteric liquid crystal devices was investigated. Design of these molecules was based on the combination of photochromic dithienylcyclopentene core with bridged binaphthyl units as chiral precursors. Aromatic groups were introduced to the molecules at 6,6′‐positions of binaphthyls through a Suzuki–Miyaura coupling reaction. Their helical twisting powers (HTPs) are significantly higher than those of the known chiral diarylethenes reported as chiral dopants so far. Photocyclization of these molecules upon light irradiation brought out dramatic variation in HTPs between different states. The primary colors, red, green, and blue, were obtained in reflection on light irradiation and with thermal stability. Moreover, a multi‐switchable photodisplay was demonstrated using one of these chiral molecular switches.     

不同色浆质量分数的水性聚氨酯涂料对聚氯乙烯表皮低温爆破性能的影响

本文制备了一系列不同色浆质量分数的水性聚氨酯涂料,并将其喷涂在汽车仪表板聚氯乙烯(PVC)表皮的背面形成复合材料。 用旋转流变仪表征了涂料的粘度以评价其喷涂性能;用差示扫描量热仪表征了材料的玻璃化转变温度(T_g);利用万能材料试验机表征了材料在-30 ℃条件下的拉伸性能及抗撕裂性能;用动态热机械分析仪表征了材料的损耗比随温度的变化。 结果表明:不同色浆质量分数的涂料都能喷涂,含有涂层材料PVC表皮在-30 ℃低温爆破性能与涂层材料的T_g、低温拉伸性能、抗撕裂性能的关系并不大,而与涂层材料的阻尼性能直接相关。 材料的阻尼性能越好,其低温爆破性能越好。