Preparation and Characterization of Activated Carbon from Microwave and Conventional Heated Almond Shells Using Phosphoric Acid Activation

Activated carbon production from almond shells using phosphoric acid activation agent was achieved by applying both conventional heating and microwave heating in succession. The morphology and surface properties of activated carbon were studied using thermogravimetric and differential gravimetric analysis, Fourier-transform infrared spectroscopy, scanning electron microscopy, and Brunauer–Emmett–Teller analysis. A surface area of 1128 m²/g was achieved by optimizing the microwave power (500?W), microwave application time (15?minutes), conventional heating time (45?minutes), conventional heating temperature (500?°C), and the phosphoric acid:sample ratio (0.7:1). An adsorption capacity of methylene blue of 148?mg/g and an iodine value of 791?mg/g was obtained for the prepared activated carbon.     

Negative compressibility property in hinging open-cell Kelvin structure

A new three-dimensional(3 D) cellular model based on hinging open-cell Kelvin structure is proposed for its negative compressibility property. It is shown that this model has adjustable compressibility and does exhibit negative compressibility for some certain conformations. And further study shows that the images of compressibility are symmetrical about the certain lines, which indicates that the mechanical properties of the model in the three axial directions are interchangeable and the model itself has a certain geometric symmetry. A comparison of the Kelvin model with its anisotropic form with the dodecahedron model shows that the Kelvin model has stronger negative compressibility property in all three directions.Therefore, a new and potential method to improve negative compressibility property can be derived by selecting the system type with lower symmetry and increasing the number of geometric parameters.     

General Formation of Macro-/Mesoporous Nanoshells from Interfacial Assembly of Irregular Mesostructured Nanounits

Mesoporous core–shell nanostructures with controllable ultra-large open channels in their nanoshells are of great interest. However, soft template-directed cooperative assembly to mesoporous nanoshells with highly accessible pores larger than 30 nm, or even above 50 nm into macroporous range, remains a significant challenge. Herein we report a general approach for precisely tailored coating of hierarchically macro-/mesoporous polymer and carbon shells, possessing highly accessible radial channels with extremely wide pore size distribution from ca. 10 nm to ca. 200 nm, on diverse functional materials. This strategy creates opportunities to tailor the interfacial assembly of irregular mesostructured nanounits on core materials and generate various core–shell nanomaterials with controllable pore architectures. The obtained Fe,N-doped macro-/mesoporous carbon nanoshells show enhanced electrochemical performance for the oxygen reduction reaction in alkaline condition.     

Lagrangian for the t–J Model Constructed from the Generators of the Supersymmetric Hubbard Algebra

In order to describe the dynamics of the t–J model, two different families of first-order Lagrangians in terms of the generators of the Hubbard algebra are found. Such families correspond to different dynamical second-class constrained systems. The quantization is carried out by using the path-integral formalism. In this context the introduction of proper ghost fields is needed to render the model renormalizable. In each case the standard Feynman diagrammatics is obtained and the renormalized physical quantities are computed and analyzed. In the first case a nonperturbative large-N expansion is considered with the purpose of studying the generalized Hubbard model describing N-fold-degenerate correlated bands. In this case the 1/N correction to the renormalized boson propagator is computed. In the second case the perturbative Lagrangian formalism is developed and it is shown how propagators and vertices can be renormalized to each order. In particular, the renormalized ferromagnetic magnon propagator coming from our formalism is studied in details. As an example the thermal softening of the magnon frequency is computed. The antiferromagnetic case is also analyzed, and the results are confronted with previous one obtained by means of the spin-polaron theories.     

Linearization of column responses by correlation chromatography. Separation improvement and reduction of undesired adsorption effects

Summary Experiments and simulations prove that correlation chromatography can greatly reduce the disadvantage of a non-linear response of the chromatographic column. A factor that has been accepted as being an important source of error in correlation or multiplex chromatography, has been shown not to be. Separations affected, improve dramatically when correlation chromatography is used, and a substantial amount of correlation noise only arises when there is a large difference in separation between a conventional chromatogram and a correlogram.A model has been developed for simulating these nonlinearities. It is shown that, especially for correlation chromatography, the simulation results match the practical measurements very well.     

Polarized Spacetime Foam

An approximate model of a spacetime foam is presented. It is supposed that in the spacetime foam each quantum handle is like to an electric dipole and therefore the spacetime foam is similar to a dielectric. If we neglect of linear sizes of the quantum handle then it can be described with an operator containing a Grassman number and either a scalar or a spinor field. For both fields the Lagrangian is presented. For the scalar field it is the dilaton gravity + electrodynamics and the dilaton field is a dielectric permeability. The spherically symmetric solution in this case give us the screening of a bare electric charge surrounded by a polarized spacetime foam and the energy of the electric field becomes finite one. In the case of the spinor field the spherically symmetric solution give us a ball of the polarized spacetime foam filled with the confined electric field. It is shown that the full energy of the electric field in the ball can be very big.     

Recursive partition and amalgamation with the exponential family: Theory and applications

The theory of tree-growing (RECPAM approach) is developed for outcome variables which are distributed as the canonical exponential family. The general RECPAM approach (consisting of three steps: recursive partition, pruning and amalgamation), is reviewed. This is seen as constructing a partition with maximal information content about a parameter to be predicted, followed by simplification by the elimination of ‘negligible’ information. The measure of information is defined for an exponential family outcome as a deviance difference, and appropriate modifications of pruning and amalgamation rules are discussed. It is further shown how the proposed approach makes it possible to develop tree-growing for situations usually treated by generalized linear models (GLIM). In particular, Poisson and logistic regression can be tree-structured. Moreover, censored survival data can be treated, as in GLIM, by observing a formal equivalence of the likelihood under random censoring and an appropriate Poisson model. Three examples are given of application to Poisson, binary and censored survival data.     

Spontaneous magnetization of the Ising model on a 4–8 lattice

The spontaneous magnetization of the Ising model on a 4–8 lattice with six different coupling constants and two different magnetic moments is studied. A formula for the spontaneous magnetization is proposed. The result agrees with the exact low-temperature series expansions up to the 12th order.     

应力对M-Z型InP/InGaAsP-EAM偏振

采用Agilent 81910A光子全参量测试仪,首次实验研究了InP/In1－xGaxAs1－yPy-MQW（Multiple-Quantum-Well,MQW）材料与衬底间因应力而产生的M-Z型光调制器的PDL影响以及由此引起的由差分群时延(Differential Group Delay,DGD)表征的偏振模色散(Polarization Mode Dispersion,PMD).研究结果表明,半导体MQW光调制器的PDL与DGD是一致的.因此在半导体光器件的制作过程中,应尽可能地减小衬底与波导芯层之间的因残存应力的存在造成对光器件的高速性能的不利影响.     

Dominant modes of submerged thin cylindrical shells

The relationship between the dominant mode of the submerged thin cylindrical shell and the flexural wave velocity is investigated. The natural frequency corresponding to the vibration mode is obtained as the solution of characteristic equation of thin cylindrical shell. However, it is difficult to estimate the dominant mode, especially if two or more vibration modes are involved. To estimate the dominant mode of a thin shell in vacuo, the concept of “modified bending stiffness” has been introduced. In this paper, the concept of modified bending stiffness is extended to estimate the dominant mode of a submerged thin cylindrical shell. The dominant mode of a submerged thin cylindrical shell is theoretically discriminated from the other mode based on the smallness of the modified bending stiffness of the submerged shell. The validity of our theory is confirmed by a good agreement between theoretical and experimental results on flexural wave velocity.