光参量啁啾脉冲饱和放大的增益稳定性

 光参量啁啾脉冲放大（OPCPA）在饱和放大区存在一个增益稳定点，据此设计了一个输出稳定的三级OPCPA系统；第一、二、三级分别选用准相位匹配的周期极化钛氧磷酸钾（PPKTP）晶体、LBO晶体和KDP晶体作为增益介质。饱和放大时，增益随泵浦光强度变化时的增益输出稳定性明显改善，在泵浦光强度抖动低于6%的情况下，各级光参量放大器OPA输出的增益抖动小于1%。前级采用准相位匹配的PPKTP晶体作为增益介质，在远低于破坏阈值的30MW/cm²的泵浦功率密度下，可得到2×10⁵的饱和放大增益和20%的能量转换效率。     

强非线性吸收下高斯光束Z-扫描衍射理论模型

 摘要：在同时考虑非线性折射和非线性吸收的情况下，借助光的衍射理论，研究了Z-扫描技术的衍射理论模型，分析了非线性折射和非线性吸收同时存在时Z-扫描曲线的形状特征和变化规律。数值计算表明，非线性吸收相移和非线性折射相移的比值是影响接收小孔输出光功率的重要因素。要想得到好的光限幅效果，应选取非线性相移比值远小于1或远大于2的非线性材料。     

用楔形柱面光纤微透镜耦合的1.3μm SOA组件

运用激光模式耦合理论分析了半导体光放大器(SOA)与单模通信光纤的连接损耗,并设计制作了楔形柱面光纤微透镜用来实现两者的模斑匹配,有效地降低了器件的光耦合损耗.本文介绍了楔形柱面光纤微透镜耦合的1.3 μm半导体光放大器(SOA)组件及其制作方法.该组件的最大增益不小于14 dB,其偏振灵敏度小于1 dB,增益波动不大于0.5 dB.     

Electromagnetic energy flow near nanoparticles—I: single spheres

The electromagnetic (EM) energy flow near single spheres is investigated by applying Mie theory. From the patterns of the energy flow, the absorption and the scattering of light can be understood in the microscopic point of view. In the absorption profiles of metallic particles, most absorbed energy is consumed on the surface of the particles, which indicates that the resonance of surface plasmon is different from that of the bulk plasmon. Two mechanisms to enhanced local EM field are also distinguished. One is the surface plasmon resonance, and another one is the intensified energy flow.     

两段级联掺铒光纤放大器的优化研究

基于Giles模型,研究了980 nm和1480 nm泵浦的两段级联掺铒光纤放大器(EDFA)的设计,得出了掺铒光纤(EDF)的最佳长度和光隔离器的最佳位置随泵浦功率和信号功率的变化关系.比较980 nm和1480 nm泵浦的两段级联EDFA,可以发现,前者的最佳EDF长度短,而光隔离器最佳位置距EDFA输入端远.     

Filter-radiometer-based realization of candela and establishment of photometric scale at UME

The luminous intensity unit of candela was realized based on filter-radiometer, which is traceable to detector-based primary standard electrical substitution cryogenic radiometer (ESCR). In that realization the traditional Osram Wi41/G-type incandescent lamp and filter-radiometer consisting of an aperture, a V(λ) filter and a silicon photodiode based trap detector were used as light source and detection element, respectively. Measurement techniques of effective aperture area, spectral transmittance of V(λ) filter and absolute responsivity of trap detector are also presented.     

利用半导体光放大器进行光脉冲消基座的理论研究

提出了一种利用半导体光放大器(SOA)联合可调谐光滤波器进行高阶孤子压缩消基座的新方法.进行了详尽的理论分析和优化.数值计算表明,在一定条件下,这种方法能够在不展宽脉冲的前提下,对基座进行有效地抑制.     

New HPLC-chiral stationary phases for enantiomeric resolution of sulfoxides and selenoxides

Summary Enantiomers of several sulfoxides and some selenoxides can be easily separated by using a new chiral stationary phase (CSP-DACH-DNB) containing the 3,5-dinitrobenzoyl derivative of R,R-(-)1,2-diamino-cyclohexane as selector, covalently bonded to the siliceous matrix. The easy operative conditions and the high enantioselectivity values (α) allow a direct transfer of the analytical separations to a semi-preparative and preparative scale.     

Analysis of reflectance and modulation spectroscopic lineshapes in optoelectronic device structures

We discuss the spectral lineshapes of reflectance and modulated reflectance (MR) measurements on optoelectronic device structures such as epi-layers, quantum wells (QWs), vertical-cavity surface emitting-lasers (VCSELs) and resonant-cavity light-emitting diodes (RCLEDs). We consider the various methods for the extraction of built-in electric fields and band-gap energies from Franz-Keldysh oscillations (FKO), using the example of a tensilely strained InGaAs QW system, whose InGaAsP barriers yield strong FKO. We describe how critical point transition energies can be easily obtained by eye from Kramers-Kronig (KK) transforms of low field or QW modulation spectra, using the example of the modulated transmittance spectra of dilute-nitrogen InGaAsN p-i-n structures. We also discuss how the ordinary reflectivity spectrum, usually acquired at the same time as the MR signal, may also be exploited to extract layer thicknesses and compositions, and information about the active QW absorption spectrum in VCSEL and RCLED structures.     

Optical properties of cadmium sulfide nanocrystal film prepared by electrochemical synthesis at liquid-liquid interface

Dendritic nanocrystalline CdS film was deposited at liquid-liquid interface of surfactants and an electrolyte containing 4 mmol L⁻¹ cadmium chloride (CdCl₂) and 16 mmol L⁻¹ thioacetamide (CH₃CSNH₂) with an initial pH value of 5 at 15 °C by electrochemical synthesis. The nanofilm was characterized by transmission electron microscopy (TEM), field emission scanning electron microscope (FE-SEM), atomic force microscopy (AFM), ultraviolet visible (UV-vis) absorption spectroscopy and fluorescence spectroscopy. The surface morphology and particle size of the nanofilm were investigated by AFM, SEM and TEM, and the crystalline size was 30-50 nm. The thickness of the nanofilm calculated by optical absorption spectrum was 80 nm. The microstructure and composition of the nanofilm was investigated by X-ray diffraction (XRD) and X-ray photoelectron spectroscopy (XPS), showing its polycrystalline structure consisting of CdS and Cd. Optical properties of the nanofilm were investigated systematically by UV-vis absorption and fluorescence spectroscopy. A λ_onset blue shift compared with bulk CdS was observed in the absorption spectra. Fluorescence spectra of the nanofilm indicated that the CdS nanofilm emitted blue and green light. The nanocomposites film electrode will bring about anodic photocurrent during illumination, showing that the transfer of cavities produces photocurrent.