高频感应炉燃烧–红外吸收法测定银杏及银杏叶中的硫含量

采用高频感应炉燃烧–红外吸收法测定银杏叶、银杏果肉、银杏壳和银杏仁中的硫含量。样品以艾士卡试剂为熔融剂,在800℃马弗炉内熔融1 h,冷却后测定硫含量。硫的质量分数在0.40%~4.00%范围内与吸收峰面积呈良好的线性关系,线性相关系数为0.990 4,检出限为0.000 9%。测定结果的相对标准偏差为4.04%(n=11),平均加标回收率为101.03%。将红外吸收法与电感耦合等离子体原子发射光谱法及硫酸钡重量法进行比对试验,3种方法测定结果相一致。利用该方法测定了不同区域银杏叶中硫的含量,结果表明,风景区和居民区银杏叶干燥基全硫的含量较低,重工业区硫含量较高。对同一地区的银杏果肉、银杏壳、银杏仁中干燥基全硫的含量进行比较,结果表明银杏果肉硫含量最高,银杏壳次之,银杏仁最低。该方法灵敏度高,重现性好,可用于银杏及银杏叶中硫含量的准确测定。     

微波消解–石墨炉原子吸收光谱法测定空气中碲

建立微波消解–石墨炉原子吸收光谱法测定空气中的碲。采用微孔滤膜收集样品,以硝酸–双氧水混合体系微波消解滤膜,氯化钯为基体改进剂,在优化的仪器工作条件下测定。碲的质量浓度在0~15μg/L范围内与吸光度线性关系良好,相关系数为0.999 5,方法检出限为0.14μg/L。样品加标回收率在95.6%~104.0%之间,测定结果的相对标准偏差为1.15~1.37%(n=7)。该方法操作简单、灵敏度高,适用于空气中微量碲的测定。     

氧化石墨阳离子交换容量测定过程中结构的变化

氧化石墨(GO)结构层上的碳羟基(―C―OH)和边缘羧基(―COOH)在水介质中发生质子化反应解离出的H+具有阳离子可交换性。实验采用甲醛缩合法测量了GO的阳离子交换容量(CEC),用X射线衍射(XRD)、傅里叶变换红外(FTIR)光谱和X射线光电子能谱(XPS)分析测试手段对GO阳离子交换过程中间产物的结构变化进行了分析。结果表明,GO的CEC高达541.48 mmol/100 g。NH_4~+和Ca~(2+)交换后的GO,保持稳定的层状结构,c轴方向层间距分别增大了0.1499和0.2905 nm。NH_4+和Ca~(2+)主要以层间可交换阳离子形式存在于层间域中,并与水分子形成可交换水化阳离子层,部分以[NH_4(H_2O)_6]+和[Ca(H_2O)_6]_2+的形式存在于结构层的边缘附近,共同平衡结构层水解产生的负电荷。     

Catalytic Performance of Graphite Oxide Supported Au Nanoparticles in Aerobic Oxidation of Benzyl Alcohol: Support Effect

Various Au/GO catalysts were prepared by depositing Au nanoparticles on thermally- and chemically-treated graphite oxide (GO) supports using a sol-immobilization method. The surface chemistry and structure of GO supports were characterized by a series of analytical techniques including X-ray photoelectron spectroscopy, temperature-programmed desorption and Raman spectroscopy. The results show that thermal and chemical treatments have large influence on the presence of surface oxygenated groups and the crystalline structure of GO supports. A strong support effect was observed on the catalytic activity of Au/GO catalysts in the liquid phase aerobic oxidation of benzyl alcohol. Compared to the amount and the type of surface oxygen functional groups, the ordered structure of GO supports may play a more important role in determining the catalytic performance of Au/GO catalysts.     

Modeling of dynamics, heat transfer, and combustion in two-phase turbulent flows: 2. Flows with heat transfer and combustion

The objective of this part of the paper is to summarize the information concerning the authors' works in the field of simulation of two-phase gas-particle turbulent flows with heat transfer and combustion. A kinetic equation had been derived for the probability density function (PDF) of the particle velocity, temperature, and mass distributions in turbulent flows. This PDF equation is used for the construction of the governing conservation equations of mass, momentum, and heat transfer in the dispersed particle phase.The numerical scheme incorporates two-phase fluid dynamics, convective and radiative heat transfer, and combustion. The proposed models have been applied to the calculation of various particle-laden turbulent flows in jets, combustion and gasification chambers, and furnaces.     

Ca-intercalated graphite as a hydrogen storage material: Stability against decomposition into CaH2 and graphite

We have used calculations based on density functional theory to investigate the energetics of hydrogen absorption in calcium-intercalated graphites. We focus particularly on the absorption energy and the stability of the hydrogenated material with respect to decomposition into graphite and calcium hydride, which is essential if this material is to be used for practical H₂ storage. The calculations are performed with two commonly used approximations for the exchange-correlation energies. Our calculations confirm earlier predictions that the absorption energy is approximately −0.2 to −0.4 eV, which is favourable for practical use of Ca-intercalated graphite as a hydrogen storage medium. However, we find that the hydrogenated material is strongly unstable against decomposition. Our results therefore explain recent experiments which show that H₂ does not remain stable in CaC₆ but instead forms a hydride plus graphite.     

HBF4溶液中全铅液流电池

报道了一种HBF₄水溶液中的全铅液流电池,正、负电极电解液均采用Pb（BF₄）₂的HBF₄水溶液.在酸性的四氟硼酸铅电解液中考察了石墨电极和玻碳电极作为工作电极的循环伏安性能,石墨电极较适于用作全铅液流电池的正、负电极.采用石墨电极作为电池的正、负电极并在四氟硼酸铅酸性电解液中进行充放电实验,其中Pb（BF₄）₂浓度分别为0.5、1.0和1.5 mol·L^-1,且保持游离的HBF₄浓度为1.0 mol·L^-1.该电池为单液流电池,不需要隔膜分隔正、负极的电解液,电流密度为10、20和40 mA.cm^-2,当限定充电容量为7.0 mAh.cm^-2,放电电压截止到1.0 V时,平均库仑效率大于87%,平均能量效率大于68%;当电解液采用1.0或1.5 mol·L^-1 Pb（BF₄）₂+1.0 mol·L^-1HBF₄水溶液时,在10及20 mA.cm^-2电流下的能量效率最高可超过74%.     

Synthesis and application of imprinted polyvinylimidazole-silica hybrid copolymer for Pb determination by flow-injection thermospray flame furnace atomic absorption spectrometry

A novel ion imprinted polyvinylimidazole-silica hybrid copolymer (IIHC) was synthesized and used as a selective solid sorbent for Pb²⁺ ions preconcentration using an on-line solid phase extraction (SPE) system coupled to TS-FF-AAS. The ionic hybrid sorbent was prepared using 1-vinylimidazole and 3-(trimethoxysilyl)propylmethacrylate as monomers, Pb²⁺ ions as template, tetraethoxysilane as reticulating agent and 2,2′-azobis-isobutyronitrile as initiator. The best on-line SPE conditions concerning sorption behavior, including sample pH (6.46), buffer concentration (9.0 mmol L⁻¹), eluent (HNO₃) concentration (0.5 mol L⁻¹) and preconcentration flow rate (4.0 mL min⁻¹), were optimized by means of full factorial design and Doehlert matrix. The analytical curve ranged from 2.5 to 65.0 μg L⁻¹ (r = 0.999) with limit of detection of 0.75 μg L⁻¹; the precision (repeatability) calculated as relative standard deviation (n = 10) was 5.0 and 3.6% for Pb²⁺ concentration of 10.0 and 60.0 μg L⁻¹, respectively. From on-line breakthrough curve, column capacity was 3.5 mg g⁻¹. Preconcentration factor (PF), consumptive index (CI) and concentration efficiency (CE) were 128.0, 0.16 mL and 25.6 min⁻¹, respectively. The selective performance of the sorbent, based on relative selectivity coefficient, was compared to NIC (non imprinted copolymer) for the binary mixture Pb²⁺/Cd²⁺, Pb²⁺/Cu²⁺ and Pb²⁺/Zn²⁺. The results showed that ion imprinted polyvinylimidazole-silica hybrid polymer had higher selectivity for Pb²⁺ than NIC at 64.9, 16.0 and 8.8 folds. The developed method was successfully applied for highly sensitive and selective Pb²⁺ determination in different kinds of water samples, parenteral solutions and urine. Accuracy was also assessed by analyzing certified reference fish protein (DORM-3) and marine sediment (MESS-3 and PACS-2) with satisfactory results.     

Liquid phase microextraction applications in food analysis

Over the last years, liquid-phase microextraction (LPME) in its different application modes (single drop microextraction, dispersive liquid-liquid microextraction and hollow fiber-LPME) has been increasingly applied for the extraction of both inorganic and organic analytes from different matrices. Its advantages over conventional extraction procedures (simplicity, effectiveness, rapidity and low consumption of organic solvents) has also attracted its application in the complex food analysis field, in which it has clearly provided good and challenging results. A comprehensive review dealing with those articles published since its introduction till the end of March 2011 is presented, offering also a critical vision of the analytical potential of LPME for the analysis of foods.     

Improved Performance of On-line Atom Trapping in Flame Furnace Atomic Absorption Spectrometry by Chemical Vapor Generation: Determination of Cadmium in High-Salinity Water Samples

ABSTRACT

On-line atom trapping inside a nickel flame furnace using chemical vapor generation for sample introduction was proposed for the determination of trace cadmium by flame atomic absorption spectrometry (AAS). Cadmium volatile species was generated upon reaction with potassium borohydride and then flushed into a flame furnace for on-line trapping by a flow of nitrogen carrier gas. The middle part of the flame furnace, where the carrier gas impacts, is cooled by the gas flow, and this provides a fine strategy for on-line atom trapping for the purpose of preconcentration. A stainless steel plate is put on the top of the flame burner in the middle to form a flame-free zone, which also greatly lowers the temperature of the flame furnace and facilitates the atom-trapping process. Due to the introduction of chemical vapor generation, matrix effect was greatly alleviated compared with direct pneumatic nebulization for on-line atom trapping in flame furnace AAS. With trapping time of 35 s, the current approach achieved an excellent limit of detection of 20 ng L^?1. The proposed method was successfully applied for the quantification of cadmium in high-salinity samples.