Glucose biosensor based on immobilization of glucose oxidase in platinum nanoparticles/graphene/chitosan nanocomposite film

The bionanocomposite film consisting of glucose oxidase/Pt/functional graphene sheets/chitosan (GOD/Pt/FGS/chitosan) for glucose sensing is described. With the electrocatalytic synergy of FGS and Pt nanoparticles to hydrogen peroxide, a sensitive biosensor with a detection limit of 0.6 μM glucose was achieved. The biosensor also has good reproducibility, long-term stability and negligible interfering signals from ascorbic acid and uric acid comparing with the response to glucose. The large surface area and good electrical conductivity of graphene suggests that graphene is a potential candidate as a sensor material. The hybrid nanocomposite glucose sensor provides new opportunity for clinical diagnosis and point-of-care applications.     

Fabrication of a graphene–cuprous oxide composite

A composite of graphene–cuprous oxide (Cu₂O) was prepared using copper acetate-adsorbed graphene oxide (GO) sheets as precursors. In this composite, in-situ formed Cu₂O particles were derived from the adsorbed copper acetate which attached to graphene sheets and prevented the aggregation of the reduced graphene oxide sheets. The as-synthesized Cu₂O crystals were cube-like particles distributed randomly on the sheets due to the template effect of GO, consequently forming a graphene–Cu₂O cubes composite. A preliminary study on the electrochemical behavior of the graphene–Cu₂O composite used as anode material for lithium ion batteries was carried out.     

A theoretical consideration of the ballistic response of continuous graphene membranes

The remarkable properties of graphene, including unusually high mechanical strength and stiffness, have been well-documented. In this paper, we combine an analytical solution for ballistic impact into a thin isotropic membrane, with ab initio density functional theory calculations for graphene under uniaxial tension, to predict the penetration resistance of multi-layer graphene membranes. The calculations show that continuous graphene membranes could enable ballistic barriers of extraordinary performance, enabling resistance to penetration at masses up to 100× lighter than existing state-of-the-art barrier materials. The very high elastic wave speed and strain energy to failure are the major drivers of this increase in performance. However, the in-plane mechanical isotropy of graphene, as compared to conventional orthotropic woven textiles, also contributes significantly to the efficiency of graphene as a barrier material. This result suggests that, for barrier applications, isotropic membranes composed of covalently bonded two-dimensional molecular networks could provide distinct advantages over fiber-based textiles derived from linear polymers.     

化学改性氧化石墨烯交联的聚酰亚胺气凝胶

聚酰亚胺(PI)气凝胶是一类密度低、机械性能好、隔热性能优异的多孔材料, 通常使用昂贵的化学交联剂进行交联. 氧化石墨烯(GO)是近年来广受关注的用于聚合物增强的纳米功能填料. 以前报道的PI/GO 复合材料多是纤维或膜的形式. 为了获得PI/GO 复合气凝胶, 本文采用化学改性氧化石墨烯(m-GO)替代1,3,5-三(4-氨基苯氧基)苯(TAB)等常规的交联剂, 使之与4,4'-二氨基二苯基醚(ODA)和3,3',4,4'-联苯四羧酸二酐(BPDA)反应, 制得了m-GO交联的PI 气凝胶. GO的化学改性通过其与过量ODA在水热条件下反应实现. 通过扫描电子显微镜(SEM)研究了PI/m-GO气凝胶的微观结构. 分别通过氮气吸脱附测试、热重分析和热线法研究了m-GO对气凝胶的孔特性、热稳定性和热导率的影响. 测试结果表明, 所获得的PI/m-GO气凝胶保持了高的孔隙率、热稳定性和绝热性. 压缩测试结果显示, 与采用1.8% (质量分数, w)的TAB进行交联的PI 气凝胶相比,仅用0.6% (w)的m-GO交联所获得的气凝胶具有更高的比杨氏模量(杨氏模量/密度)、比屈服强度(屈服强度/密度)和更小的体积收缩率.     

石墨烯/类金刚石碳复合薄膜的电化学沉积及其场发射性能

采用液相电化学方法在硅基底上制备了石墨烯掺杂的类金刚石碳复合薄膜,探讨了电化学沉积复合薄膜的机理。利用扫描电子显微镜（SEM）、拉曼光谱（Raman）、透射电子显微镜（TEM）和傅里叶变换红外（FTIR）光谱技术对薄膜表面形貌和微观结构进行了分析表征。结果表明,石墨烯片均匀分散沉积在含氢类金刚石碳（a-C：H）基体中,沉积的石墨烯/类金刚石（G/a-C：H）复合薄膜表面相对均匀平整。场发射测试显示石墨烯掺杂使开启电场从4.7 V·μm^-1增加至5.8 V·μm^-1,场发射电流密度从384 μA·cm^-2显著增加至876 μA·cm^-2。     

水热法制备Fe3O4/rGO纳米复合物作为锂离子电池阳极材料

以氢氧化铁为四氧化三铁的前驱体,氧化石墨烯（GO）为还原石墨烯（rGO）的前驱体,以水合肼和二水合柠檬酸三钠为混合还原剂,采用水热法制备了还原石墨烯负载四氧化三铁纳米颗粒（Fe₃O₄/rGO）的复合材料。通过透射电子显微镜（TEM）、X-射线衍射（XRD）和热重分析（TGA）对产物的形貌、结构和组成进行了表征。以锂片为对电极进行了扣式电池的组装,通过恒电流充放电和循环伏安法对其电化学性能进行了测试。材料具有均一的形貌,rGO具有较高的还原程度且可以在充放电过程中缓冲Fe₃O₄纳米颗粒的体积变化,使得Fe₃O₄/rGO纳米复合物具有较好的电化学性能。     

氧化石墨烯掺杂PEDOT:PSS作为空穴注入层对有机发光二极管发光性能的影响

研究了氧化石墨烯(GO)掺杂聚(3,4-亚乙二氧基噻吩):聚(苯乙烯磺酸) (PEDOT:PSS)作为空穴注入层对有机发光二极管发光性能的影响. 在PEDOT:PSS水溶液中掺入GO, 经过湿法旋涂和退火成膜后, 不仅提高了空穴注入层的空穴注入能力和导电率, 透光率也得到了相应的提高, 从而使得有机发光二极管(OLED)器件的发光性能得到了提升. 通过优化GO掺杂量发现, 当GO掺杂量为0.8%(质量分数)时, 空穴注入层的透光率达到最大值(96.8%), 此时获得的OLED器件性能最佳, 其最大发光亮度和最大发光效率分别达到17939 cd·m^-2和3.74 cd·A^-1. 与PEDOT:PSS 作为空穴注入层的器件相比, 掺杂GO后器件的最大发光亮度和最大发光效率分别提高了46.6%和67.6%.     

Restored thermoluminescence in oxide crystals

In this paper, we present the results of a thermoluminescence study on several oxide crystals, including Y₃Al₅O₁₂ (YAG), Y₃Al₅O₁₂:Nd (YAG:Nd), Lu₂SiO₅:Ce (LSO:Ce), Y₂SiO₅:Ce (YSO:Ce), Gd₂SiO₅:Ce (GSO:Ce), PbWO (PWO), and PbWO:La (PWO:La). A phenomenon involving restoration of thermoluminescence (TL) glow peaks is found to occur in some of the crystals investigated; crystals γ-irradiated at room temperature and subsequently stored for some time in the dark at 77 K exhibit TL glow peaks in the range below room temperature. This phenomenon is caused not by a thermally or optically stimulated process, but rather as a by-product of a tunneling process. The intensity of the restored TL glow peaks measured in LSO:Ce crystals is found to be proportional both to the radiation dose and to the storage-time at low temperature. A phenomenological theoretical model is proposed, in which tunneling recombination occurs between deep electron and hole traps accompanied by the simultaneous ejection of an electron to the conduction band; some of these conduction electrons then repopulate shallow traps. An oxygen vacancy with two trapped electrons is assumed to be the deep electron trap in this model. The role of oxygen vacancies is confirmed by heating in air at 1000 °C. This model is applied specifically to LSO:Ce, and several possible candidates are suggested for shallow traps in that material.     

Initial nucleation of Au on the R45° reconstructed Fe3O4(0 0 1) surface

The initial nucleation of Au onto the R45° reconstructed Fe₃O₄(0 0 1) surface has been studied using scanning tunnelling microscopy. Au clusters are formed, with a typical lateral dimension of 0.9 nm. The measured corrugation height of the clusters, 0.1 nm, suggests that they are a single atomic layer in height. The clusters nucleate on a specific surface site, which lies at the centre of a R45° reconstructed unit cell. The size and spatial distribution of the Au clusters formed is shown to strongly correlate to the symmetry and periodicity of the reconstructed magnetite surface. It is also shown that even when the clusters are in close proximity they still only occupy this single nucleation site, and thus maintain the periodicity of the substrate. We relate the order and stability of this system to the fact that magnetite (0 0 1) is polar, and suggest that such surfaces offer ideal templates for self-assembly due to the stability of their polarity induced reconstructions.     

MWCNTs/Ionic Liquid/Graphene Quantum Dots Nanocomposite Coated with Nickel‐Cobalt Bimetallic Catalyst as a Highly Selective Non‐enzymatic Sensor for Determination of Glucose

In this work, a glassy carbon electrode (GCE) was modified with multiwall carbon nanotubes/ionic liquid/graphene quantum dots (MWCNTs/IL/GQDs) nanocomposite. Then, the nanocomposite was decorated with nickel‐cobalt nanoparticles (Ni?Co NPs), and it was used as a non‐enzymatic glucose sensor. Field emission scanning electron microscopy, X‐ray diffraction spectroscopy, and energy dispersive spectroscopy were employed to prove the electrodeposition of the Ni?Co NPs on the surface of MWCNTs/IL/GQDs/GCE. Also, cyclic voltammetric and amperometric methods were utilized for the investigation of the electrochemical behaviour of the Ni?Co NPs/MWCNTs/IL/GQDs/GCE for glucose oxidation. The novel amperometric sensor displayed two linear ranges from 1.0 to 190.0 μmol L^?1 and 190.0 to 4910 μmol L^?1 with a low detection limit of 0.3 μmol L^?1 as well as fast response time (2 s) and high stability. Also, the sensor showed good selectivity for glucose determination in the presence of ascorbic acid, citric acid, dopamine, uric acid, fructose, and sucrose, as potential interference species. Finally, the performance of the proposed sensor was investigated for the glucose determination in real samples. Ni?Co NPs/MWCNTs/IL/GQDs/GCE showed good sensitivity and excellent selectivity.