Feasibility of using solid sampling graphite furnace atomic absorption spectrometry for speciation analysis of volatile and non-volatile compounds of nickel and vanadium in crude oil

A method for the direct determination of volatile and non-volatile nickel and vanadium compounds in crude oil without previous treatment using direct solid sampling graphite furnace atomic absorption spectrometry is proposed. The crude oil samples were weighed directly onto solid sampling platforms using a microbalance and introduced into a transversely heated solid sampling graphite tube. In previous work of our group losses of volatile nickel and vanadium compounds have been detected, whereas other nickel and vanadium compounds were thermally stable up to 1300 and 1600 °C, respectively. In order to avoid this problem different chemical modifiers (conventional and permanent) have been investigated. With 400 μg of iridium as permanent modifier, the signal started to drop already after two atomization cycles, possibly because of an interaction of nickel (which is a catalyst poison) with iridium. Twenty micrograms of palladium applied in each determination was found to be optimum for both elements. The palladium was deposited on the platform and submitted to a drying step at 150 °C for 75 s. After that the sample was added onto the platform and submitted to the furnace program. The influence of sample mass on the linearity of the response and on potential measurement errors was also investigated using four samples with different nickel content. For the sample with the lowest nickel concentration the relationship between mass and integrated absorbance was found to be non-linear when a high sample mass was introduced. It was suspected that the modifier had not covered the entire platform surface, which resulted in analyte losses. This problem could be avoided by using 40 μL of 0.5 g L⁻¹ Pd with 0.05% Triton X-100. Calibration curves were established with and without modifier, with aqueous standards, oil-in-water emulsions and the certified reference material NIST SRM 1634c (trace metals in residual fuel oil). The sensitivity for aqueous standards and emulsions was close to that for SRM 1634c, making possible the use of aqueous standards for calibration. The limits of detection and quantification obtained for nickel and vanadium under this condition were found to be 0.02 and 0.06 μg g⁻¹, respectively, for both elements, based on 10 mg of sample. Nickel and vanadium were determined in the samples with (total Ni and V) and without the use of Pd (thermally stable compounds), and the concentration of volatile compounds was calculated by difference. The results were compared with those obtained by high-resolution continuum source graphite furnace atomic absorption spectrometry by emulsion technique; no significant differences were found for total Ni and V at the 95% confidence level according to a Student's t-test.     

ADSORPTION OF 2,4-DICHLOROBENZOXYACETIC ACID ONTO HYPERCROSSLINKED RESIN MODIFIED BY PHENOLIC HYDROXYL GROUP (AM-1)

INTRODUCTIONAdsorption has been considered to be the best available technology for removing organics from water in the USSafe Drinking Water Act[1]. Due to many drawbacks of activated carbon[2-7], the most widely used adsorbent,hypercrosslinked polymeric adsorbents developed by Tsyurupa and Davankov[8] have been increasingly viewedas an alternative to activated carbon for selective removal of specific organic substances from contaminatedwater[9-12], and series of researches have been do…     

一个新颖三维配位聚合物Pb(1，4-napdc)(DMF)的合成、结构及热稳定性研究

A novel 3D metal-organic coordination polymer Pb(1,4-napdc)(DMF) (1,4-napdc=naphthalene-1,4-dicarboxylate) was synthesized at room temperature using slow vapor diffusion method to grow single crystal that has been analyzed by X-ray diffraction. The crystal belongs to orthorhombic with space group P2₁2₁2₁. The unit cell parameters are as fellows: a=0.701 3(2) nm, b=1.407 6(3) nm, c=1.521 5(4) nm, V=1.501 8(6) nm³ and Z=4. In the crystal structure of Pb(1,4-napdc)(DMF), the square grids constructed with paddle-wheel units of Pb(Ⅱ) and 1,4-napdc links stack over each other to generate infinite 3D network, which has square apertures (1.158×1.158 nm²) along the crystallographic a-axis. The thermal stability of compound was investigated by differential scanning calorimetry and thermogravimetric analysis. CCDC: 293617.     

Vapor pressure,speciation, and chemical activities in highly concentrated sodium borate solutions at 277 and 317°C

The system H₂O-B₂O₃-Na₂O has been studied experimentally at 277 and 317°C. The activities of water and boric acid have been determined at mole ratios Na/B from 0 to 1.5, and total dissolved solids 3 to 80 weight percent. The activity of boric acid has been fitted to within experimental error using a speciation model with eight complex species. This model is consistent with the model previously published by Mesmer et al. The electrolyte properties of the liquid are modeled using the Pitzer-Simonson model of very concentrated electrolyte solutions. The calculated values of water activity agree with experiment, and the activity of NaOH and pOH have also been calculated. The potassium borate system also was briefly studied at 317°C, and is adequately described by a model with five complex species. The potassium borate liquid is more alkaline at K/B= 1 than a sodium borate liquid at the same mole ratio, but pOH in the two systems is the same at lower mole ratios.     

Semiempirical calculation of electronic spectra of organic compounds by using the improved method of new-γ electron repulsion integral. Part 2. Polycyclic aromatic hydrocarbons (PAHs)

Excitation energies of 123 polycyclic aromatic hydrocarbons were calculated by incorporating the improved method of new-γ for the two-center electron repulsion integral into two semiempirical molecular orbital methods (CNDO/S and INDO/S). This variable method well reproduced experimental excitation energies of them. The average error of the improvement is about 0.162 (CNDO/S) or 0.237 eV (INDO/S) though the average error without the improvement is about 0.541 (CNDO/S) or 0.536 eV (INDO/S). The improvement was useful for the calculations of other organic compounds including hetero atoms, such as organic dye.     

丙酮肟与某些芳烃相互作用的~1H核磁共振研究

Hatton和Richards通过对酰胺分子的~1H NMR谱溶剂效应的研究,提出了DMF与苯生成分子络合物的模型.如果络合物按1:1生成,那么将出现一个“饱和点”,在这点上甲基的芳香溶剂诱导位移(ASIS)的变化趋势或程度将出现一个明显的变化,事实上随着苯的摩尔分数从0到1逐渐增加时,化学位移总是有规则的逐渐移向高场.这就显示了分子络合物观点的局限性.它能被一些研究者所支持和接受,是因为它能够解释两个甲基共振峰先重合而后又分离的现象.     

Geometry,stability and aromaticity of β-diketiminate-coordinated alkaline-earth compounds

Alkaline-earth (Ae) metals have attracted a wealth of interdependent research from synthetic chemists. In Ae-catalyzed organometallic reactions, β-diketiminate is a typical ligand used to stabilize Ae catalysts by forming six-membered rings comprising Ae metals. Herein, studies focusing on the configuration of β-diketiminate-coordinated Ae compounds observed that the CC and CN bonds are homogeneous and unchanged. Furthermore, energetic studies observed that the formation of the Ae-incorporated six-membered rings results in enhanced stability of >20 kcal/mol. The nucleus-independent chemical shifts, anisotropy of the induced current density, and molecular orbital analyses demonstrated the non-aromaticity of the β-diketiminate-coordinated Ae compounds. The improved stability of these compounds can be explained by the delocalization of the π electrons derived from the β-diketiminate moiety.     

Adsorption Isotherm of Water Vapor and Its Large Hysteresis on Highly Ordered Mesoporous Silica

The first and second adsorption–desorption isotherms of water vapor on a new mesoporous material derived from kanemite have been measured. The isotherms show unusual type V isotherms and large hysteresis. The type V isotherms, which have never been observed for the other adsorbates, suggest that the mesoporous material has a hydrophobic surface, although the hydrophobicity decreased after treatment with water vapor because of rehydration of the surface. The significantly large hysteresis could be explained by the difference in contact angle between adsorption and desorption.     

Deposition of Oral Bacteria and Polystyrene Particles to Quartz and Dental Enamel in a Parallel Plate and Stagnation Point Flow Chamber

The aim of this paper is to determine to what extent (i) deposition of oral bacteria and polystyrene particles, (ii) onto quartz and dental enamel with and without a salivary conditioning film, (iii) in a parallel plate (PP) and stagnation point (SP) flow chamber and at common Peclet numbers are comparable. All three bacterial strains showed different adhesion behaviors, and even Streptococcus mitis BMS, possessing a similar cell surface hydrophobicity as polystyrene particles, did not mimic polystyrene particles in its adhesion behavior, possibly as a result of the more negative ζ potentials of the polystyrene particles. The stationary endpoint adhesion of all strains, including polystyrene particles, was lower in the presence of a salivary conditioning film, while also desorption probabilities under flow were higher in the presence of a conditioning film than in its absence. Deposition onto quartz and enamel surfaces was different, but without a consistent trend valid for all strains and polystyrene particles. It is concluded that differences in experimental results exist, and the process of bacterial deposition to enamel surfaces cannot be modeled by using polystyrene particles and quartz collector surfaces.     

化学蒸气沉积硅氧化合物调变HZSM－5沸石的研究

本文研究了正硅酸乙酯分别在无胺法和有胺法制得的ＨＺＳＭ－５沸石上的沉积过程，并用吸附，ＮＨ３－ＴＰＤ及异丙醇探针反应等手段表征了沉积后的样品，发现沉积仅在外表面上进行，可使孔口变小但不影响孔道内性质，显示有对于二甲苯分子的择形吸附能力，且在甲苯甲醇烷基化反应和二甲苯异构化反应中表现出良好的择形催化性能．