含吩噻嗪金属配合物的合成及非线性光学性质研究

本文报道了一种新的配体:10-乙基-3-甲酰吩噻嗪缩肼基二硫代甲酸甲酯(HL)及其金属配合物的合成。采用了元素分析、质谱、核磁共振、红外光谱对配体及其金属配合物进行了表征。此外,并应用紫外、荧光和Z-扫描技术,测定了配体及其金属配合物的荧光最佳发射波长(λ_max^em)、荧光量子产率(Φ_f)、寿命(τ)和非线性光学性质。结果表明它们在DMF溶液中都能发射出较强的橄榄色荧光,配体及其金属配合物都有双光子吸收,并且金属配合物的非线性光学效应比配体明显增强。用半经验量子化学方法(RHF/PM3)计算结果与实验值较为吻合。     

Evolution of Er^3＋ Distribution in the Oxyfluoride Glass Ceramics with Heating

The distribution characteristics of Er3+ ions doped in the oxyfluoride glass ceramics containing LaF3 nanocrystals heat-treated at 650 ℃ for different durations were investigated. The results of the integral absorption cross-section analysis demonstrated that the partition fraction of Er3+ in LaF3 nanocrystals increases with prolonging of heating time. The anomalous phenomena of Er3+ emissions in the up-and the down-conversion fluorescence spectra are well explained based on the calculated results.     

衬钽管石墨炉原子吸收法测定痕量镓时基体改进剂的研究及应用

提出用钒和铜混合基体改进剂衬钽管石墨炉原子吸收测定镓的方法。衬钽管使镓的灵敏度提高6倍左右,钒和铜混合基体改进剂不仅能进一步提高灵敏度,而且能提高灰化温度,降低原子化温度,增强抗干扰能力。测定 GSD 标准样品中的镓时,不需对样品进行预分离即可直接进行测定,结果与参考值相符。     

XPS,AFM, ATR and TPD evidence for terraced,dihydrogen terminated, 1×1 (100) silicon

Heating (100) silicon at high temperature (say, higher than 850 °C) in H₂, cooling to 670–700 °C in the same ambient, and quenching to room temperature in N₂ results in environmentally robust, terraced 1 × 1 (100) SiH₂. Evidence for this conclusion is based on angle‐resolved x‐ray photoelectron spectroscopy, atomic force microscopy, infrared absorption spectroscopy in the attenuated total reflection mode, thermal programmed desorption, and reflection high‐energy electron diffraction. Copyright © 2005 John Wiley & Sons, Ltd.     

关于meso—四苯基卟啉在冰醋酸中的存在形式

前言卟啉在生物化学、分析化学、药物化学等领域有着广泛研究和重要应用［１～３］。近年来虽然对卟啉类化合物的研究报道很多［４～６］，但对卟啉在酸性介质中的研究很少。较早期的研究工作认为卟啉类化合物在酸性介质中仅以其二酸形式存在［７］。本文实验结果显示ｍｅ...     

Structural and magnetic investigations of the mixed-valence Fe(II,III) two-dimensional layer complex, [Fe2(II) Fe2(III)(HCOO)10(C6H7N)6]n.

The structure of the complex, [Fe2(II)Fe2(III)(HCOO)10(C6H7N6)n, (1) exhibits a neutral two-dimensional layer network of alternating iron(II) and iron(III) ions, bridged equatorially by formate groups. All iron atoms are octahedrally coordinated, with iron(III) coordinating axially to one gamma-picoline and one formate group, while the iron(II) centers interact axially with two gamma-picoline groups, above and below the layer plane. The complex crystallizes in the triclinic space group P1 at all studied temperatures [at 120 K, the cell dimensions are: a = 10.228(1), b = 12.071(1), c = 12.072(1) A, alpha = 89.801(2), beta = 71.149(2), gamma = 73.371(2) degrees]. An intralayer antiferromagnetic exchange interaction of J = -2.8 cm(-1) between iron(II) and iron(III) was observed in the magnetic studies. Decreasing the temperature to close to 20 K causes a magnetic-ordering phenomenon to occur and a low-temperature phase with a long-range antiferromagnetic spin orientation appears. The magnetic phase transition was confirmed by M?ssbauer spectroscopic studies at temperatures above and below the critical temperature. Structural information of 1 from synchrotron X-ray diffraction data collected at room temperature and 16 K suggests that the antiferromagnetic ordering is caused by an enhanced pi-pi interaction between chi-picoline groups from adjacent layers.     

Feasibility of using solid sampling graphite furnace atomic absorption spectrometry for speciation analysis of volatile and non-volatile compounds of nickel and vanadium in crude oil

A method for the direct determination of volatile and non-volatile nickel and vanadium compounds in crude oil without previous treatment using direct solid sampling graphite furnace atomic absorption spectrometry is proposed. The crude oil samples were weighed directly onto solid sampling platforms using a microbalance and introduced into a transversely heated solid sampling graphite tube. In previous work of our group losses of volatile nickel and vanadium compounds have been detected, whereas other nickel and vanadium compounds were thermally stable up to 1300 and 1600 °C, respectively. In order to avoid this problem different chemical modifiers (conventional and permanent) have been investigated. With 400 μg of iridium as permanent modifier, the signal started to drop already after two atomization cycles, possibly because of an interaction of nickel (which is a catalyst poison) with iridium. Twenty micrograms of palladium applied in each determination was found to be optimum for both elements. The palladium was deposited on the platform and submitted to a drying step at 150 °C for 75 s. After that the sample was added onto the platform and submitted to the furnace program. The influence of sample mass on the linearity of the response and on potential measurement errors was also investigated using four samples with different nickel content. For the sample with the lowest nickel concentration the relationship between mass and integrated absorbance was found to be non-linear when a high sample mass was introduced. It was suspected that the modifier had not covered the entire platform surface, which resulted in analyte losses. This problem could be avoided by using 40 μL of 0.5 g L⁻¹ Pd with 0.05% Triton X-100. Calibration curves were established with and without modifier, with aqueous standards, oil-in-water emulsions and the certified reference material NIST SRM 1634c (trace metals in residual fuel oil). The sensitivity for aqueous standards and emulsions was close to that for SRM 1634c, making possible the use of aqueous standards for calibration. The limits of detection and quantification obtained for nickel and vanadium under this condition were found to be 0.02 and 0.06 μg g⁻¹, respectively, for both elements, based on 10 mg of sample. Nickel and vanadium were determined in the samples with (total Ni and V) and without the use of Pd (thermally stable compounds), and the concentration of volatile compounds was calculated by difference. The results were compared with those obtained by high-resolution continuum source graphite furnace atomic absorption spectrometry by emulsion technique; no significant differences were found for total Ni and V at the 95% confidence level according to a Student's t-test.     

Synthesis, Structure and Optical Properties of Cerium(Ⅲ) Triphosphate CeP3O9

The single crystal and crystallized powder of triphosphate CeP3O9 have been synthesized, and the space group of CeP3O9 has been determined to be C2221 with the cell parameters ofa = 8.6059, b = 11.2437, c = 7.3518 (A), V= 711.4(3) (A)3, Z= 4, Dc = 3.520 g/cm3, F(000) = 700,R = 0.0377 and wR = 0.0930. The absorption and emission spectra have been measured, for which the strongest absorption and emission peaks are located at 280 and 320 nm, respectively. The density of state (DOS) and dielectric function have been calculated by the DFT method. The crystal is transparent provided the wavelength is larger than 341 nm, and the observed ultraviolet cut-off edge is at about 350 nm for a polycrystalline power sample. It is possible that the triphosphate CeP3O9 will become an ultraviolet emission material.     

5,9,14,18,23,27,32,36-八烷氧基2,3-萘酞菁镍(Ⅱ)的结构与光谱性质关系的研究

测定了一组八烷氧基萘酞菁镍（Ⅱ）配合物Ni（Ⅱ）（RO）8NPC（R＝C4H9，C8H17，C12H25，NPC＝C48H16N8）在5种有机溶剂（Py、DMSO、DMF、CH2Cl2、C6H12）中的电子吸收光谱和荧光光谱，研究了这些配合物的结构与光谱的关系。结果表明该系列RO取代萘酞菁镍（Ⅱ）配合物的Q带吸收光谱比无取代的红移75nm左右，荧光光谱屯相应红移50～80nm，而溶剂对其影响不大。     

若干中性配体对Mo—Fe—S簇合物自兜的影响

通过电子吸收光谱的变化研究了一些含N和含P中性配体对MoS_4~(2-)-nFeCl_2-DMF体系形成立方烷型Mo-Fe-S簇合物的可能影响。