Energy transfer in solution of lanthanide complexes

The lanthanides with their well-defined energy levels provide an excellent basis to study different Ln(III)-specific energy transfer processes in a variety of chemical environments. The studies concerning intramolecular and intermolecular energy transfer processes with participation of Ln(III) ions and a variety of ligand groups in solution are reviewed. Phenomena of energy transfer from ligands to Ln(III) ions, resulting consequently in a great enhancement of the Ln(III) ion luminescence (ligand sensitized luminescence), as well as from Ln(III) to other species and between Ln(III) ions are presented.     

Effect of the Structure of Nonuniform Conducting Polymer Films on Their Electrochemical Impedance Response

Electrochemical impedance spectroscopy is used to characterize thin p-doped polypyrrole (PPy) films in propylene carbonate (PC) solutions and poly(trifluorophenyl)thiophene (PTFPT), in solutions based on sulfolane (SF). It appears that the latter film is much less swelled compared to the former one. One consequence of this difference is that the PTFPT film shows a much higher bulk resistance compared to that for the PPy film. Another important consequence is that the swelling of the PTFPT film is essentially physically non-homogeneous. Two parallel, uncoupled paths, with different chemical diffusion coefficients, model the experimental results adequately. In order to quantify the impedance spectra for both polymer films, we use a model proposed by Rubinstein et al. explaining the difference in the diffusion coefficients of Ru(bpy)^3+/2+ ₃ within a thin Nafion film. The model can also predict the impedance spectra for composite powdery electrodes containing different particle sizes, such as composite cathodes and graphite anodes used in lithium batteries.     

靛红掺杂聚吡咯膜修饰电极的电荷传输

利用交流阻抗法研究了靛红掺杂聚吡咯膜内的电荷传输，通过非线性最小二乘法拟合，得出了体系的等效电路，并计算出其电荷扩散系数和异相电子传递反应速率常数。实验结果表明，随着膜厚的增加，活性点增多，异相电子传递反应速率常数增大，同时表观扩散系数也增大。     

Electrochemical Impedance Analysis of Thermogalvanic Cells

Thermogalvanic cells(also known as thermo-electrochemical cells) that convert waste heat energy to electricity are a new type of energy conversion device. However, the electron transfer kinetics and mass transfer of redox couples have not been thoroughly studied. Here, the ion reaction and charge transport in thermogalvanic cells are investigated by electrochemical impedance analysis. We first propose the detailed impedance model followed experimental verification on three types of electrode materials. Parameters including kinetic rate constants and ion diffusion coefficients for the electrodes are obtained by fitting the impedance data. Our study shows explicitly that impedance analysis can provide useful information on selecting suitable electrode materials for thermogalvanic cells.     

Synthesis of oligo(p-phenylene vinylene)-porphyrin-oligo(p-phenylene vinylene) triads as antenna molecules for energy transfer

The oligo(p-phenylene vinylene)-porphyrin-oligo(p-phenylene vinylene) (P-OPVn, n=2, 4, where n is the number of phenyl rings) and the complex with Zn²⁺ based on P-OPVn were synthesized for investigating their photophysical properties via UV-vis, voltammetry, steady-state and time-resolved fluorescence spectra. In these molecules two OPV moieties as energy donors were linked to porphyrin center by virtue of Wittig reaction. The detailed studies of photophysical properties indicate that OPV group can act as an antenna unit for effective intramolecular energy transfer.     

Study of Densities, Viscosities and Ultrasonic Speeds of Binary Mixtures Containing 1,2-Dimethoxyethane and an Alkan-l-ol at 298.15 K

The viscosity deviation (Δη), the excess molar volume (V ^E) and the ultrasonic speed (u) have been investigated from viscosity (η) and density (ρ ) measurements of binary liquid mixtures of 1,2-dimethyoxyethane with methanol, ethanol, propan-1-ol, butan-1-ol, pentan-1-ol, hexan-1-ol or octan-1-ol over the entire range of composition at 298.15 K. The excess volumes are negative over the entire range of composition for all of the mixtures with the exception of hexan-1-ol and octan-1-ol. The excess isentropic compressibilities (K _S ^E) and viscosity deviations are negative for all of the mixtures. The magnitudes of the negative values of V ^E decrease with the number of carbon atoms of the alkan-1-ol. The trend of increasing K _S ^E values with the chain length of the alkanol is similar to that observed in the case of V ^E. Graphs of V ^E, Δ η, K _S ^E, Δ u, L _f ^E and Z ^E against composition are presented as a basis for a qualitative discussion of the results.     

Self-assembled monolayers on Au microelectrodes

Long chain alkanethiols self-assembled monolayers (SAMs) formed on Au microelectrodes showed higher sensitivity towards defects than the same monolayers on macroelectrodes. The analysis of cyclic voltammetry and electrochemical impedance spectroscopy (EIS) experiments performed on covered microelectrodes were consistent with the formation of pinholes of about 10 nm in diameter. Moreover, the EIS data exhibited a specific behavior that was interpreted invoking the short circuiting of the pinholes impedance by the surrounding surface of the microelectrode in the high frequency domain, whereas in the low frequencies, the surface covered by the SAM was assume to act as an insulator.     

The blocking and structural properties of a Schiff base self-assembled monolayer on the surface of Au(111)

Electrochemistry and in situ electrochemical scanning tunneling microscopy (STM) were used to study the blocking and structural properties of Shiff base V-ape-V self-assembled monolayers (SAMs) on the surface of Au(111) in perchloric acid solution. The complex-plane impedance plots for the SAM covered Au(111) electrodes, with the redox couple of Fe(CN)₆^4–/3– present in solution, exhibit arc shapes, revealing that the electrochemical kinetics were controlled by the electron-transfer step. For bare Au(111), the electrode process was mass transport limited. The molecules adsorb on Au(111) with a flat-lying orientation and form a long-range well-defined adlayer. A new structure of was observed in the double-layer potential region. A structural model is proposed to interpret the molecular registry with Au(111) substrate.     

Dynamic electrochemical impedance spectroscopy measurements of passive layer cracking under static tensile stresses

Electrochemical impedance spectroscopy allows the examination of corrosion susceptibility and resistance for different construction materials, in particular the determination of the properties of their passive films. This technique makes possible the analysis of electrochemical processes in time domain, including rapid phenomena such as changes in the properties of passive films, but it has never been used for passive layer cracking examination. In many cases, fracture of the passive film under tensile stresses leads to stress corrosion cracking. Therefore, investigations of passive layer cracking on austenitic stainless steels under tensile stresses facilitate the understanding of the mechanism of stress corrosion cracking in these common engineering materials. The effect of static tensile stresses on the passive film cracking behaviour of type 304L stainless steel immersed in 0.5 M NaCl solution at room temperature has been investigated. This paper presents the impedance spectra obtained for 304L stainless steel samples at different potential values.Contribution to the 3rd Baltic Conference on Electrochemistry, Gdansk-Sobieszewo, Poland, 23–26 April 2003Dedicated to the memory of Harry B. Mark, Jr. (28 February 1934–3 March 2003)     

Effect of film thickness on the electro-reduction of molecular oxygen on electropolymerized cobalt tetra-aminophthalocyanine films

We studied the electrocatalytic activity of cobalt tetra-aminophthalocyanine (CoTAPc) for the reduction of molecular oxygen (O₂) on adsorbed monomeric and on electropolymerized films of different thicknesses on glassy carbon (GC) electrode. The polymeric films, denoted poly-CoTAPc, were first characterized by electrochemical impedance spectroscopy and it appears that the types of phenomena revealed to be occurring depend less on the film thickness in basic than in acid media. For O₂ reduction, the results showed that poly-CoTAPc is more active than the monomeric CoTAPc adsorbed on GC. Indeed, rotating ring-disk electrode data showed that polymeric CoTAPc promotes the four-electron reduction of O₂ to water in parallel to a two-electron reduction to give peroxide. On monomeric and thin films of poly-CoTAPc, a two-electron reduction mechanism predominates. In basic media the activity increases very slightly with thickness, whereas in acid media this increase is more pronounced. This parallels the observed behavior revealed by electrochemical impedance spectroscopy.