乳化技术原子吸收光谱法测定汽油中的铅

本文以Span-80与Tween－20为复合乳化剂，将汽油分散成均匀的油水乳化液，可直接喷入空气－乙炔火焰中进行测定，本法简单快速，乳化液稳定时间长。回收率在97－103％之间，相对标准偏差在4％以内，本法测定结果与络合滴定法基本一致。     

电子直线加速器磁控管频率稳定的自适应线性神经元方法

 电子直线加速器电子束能量的稳定与否取决于功率源工作频率的稳定性,磁控管在短时间内的散谱和轻微跳谱造成稳频系统的控制精度下降,最后电子束的扫描均匀度下降。引入自适应线性神经元方法(ADALINE)和噪声对消技术以消除对工作频率长期稳定性的影响,从而保证了电子束的扫描均匀度。     

停流—荧光动力学分析法测定痕量钛的研究

利用自行组装的停流-荧光动力学分析仪,采用停流法汇合流体动力注入技术,研究了钛与3.5-二溴水杨基荧光酮的荧光增强动力学反应性质,讨论了流速、进样时间对方法灵敏度和精密度的影响,提出了一个快速、简便、精确测定钛的分析方法,并用于稀土样品及合成样品中痕量钛的测定.方法检测限为8×10~(-3)ppm,大多数元素的干扰均可用动力学方法消除.     

论流动稳定性中的弱非线性理论

弱非线性理论提出已有30多年,被广泛用于流动稳定性及其他领域的问题.但能与实验比较并证实其有效性的理论计算结果很少.本文研究了其原因,发现主要是平均流修正的计算方法有问题,导致它的结果与数值模拟的结果吻合得不好.提出了正确的算法,结果相当满意.     

稳态锁模产生4ps激光脉冲

首次利用ＧａＡｓ光电导开关，控制Ｎｄ：ＹＬＦ激光器腔内Ｑ值，实现稳态锁模，获得脉宽和能量稳定性极高的４ｐｓ激光脉冲。     

规则结构多孔填料塔两相流动特性实验研究

本文以空气和水为工质,对规则结构多孔填料塔的气-液逆向流动特性进行了可视化实验,研究了填料塔内气一液两相流动规律.实验结果表明:当液体流量一定时,随着气体流量的增加,压力损失增大;当气体流量一定时,随着液体流量的增加,气相压力损失增加.根据实验结果提出了采用水力雷诺数、韦伯数和无量纲流动参数的填料塔内气-液两相流动阻力系数实验关联式.     

钯作基体改进剂FIA－HG－GFAAS法测定锗及其机理研究

采用钯，钯－镁作基体改进剂，ＦＩＡ－ＨＧ－ＧＦＡＡＳ法成功地测定了锗。灵敏度、精密度和分析速度都得到很大的提高。峰值吸收的特征质量８．０ｐｇ，检出限１０．９ｐｇ，相对标准偏差０．３４％，同时探讨了基体改进剂钯的稳定作用机理及锗在石墨管中的原子化机理。     

Residual stress profiling of an aluminum alloy by laser ultrasonics

A residual-stress profile along the thickness of an aluminum alloy sheet is determined by laser-ultrasonic technique. Surface acoustic waves are generated by a Nd:YAG pulse laser and detected by a Heterodyne interferometer on a lateral free surface of the sheet. The distribution of residual stress is determined by measuring the relative variation of the wavevelocities at different location of the sample along its thickness. This technique is validated by three different residual stress profiles obtained experimentally.     

Field Emission from Silicon Nanocrystallite Films with Compact Alignment and Uniform Orientation

Patterned silicon nanocrystallite (SINC) films were fabricated on (100) orientation p-type boron-doped sificon wafer by the hydrogen ion implantation technique and the anodic etching method. The efficient field emission with low turn-on field of about 3.5V/μm at current density of 0.1μA/cm^2 was obtained. The emission current density from the SiNC films reached 1mA/cm^2 under a bias field of about 9.1V/μm. The experimental results demonstrate that there are great potential applications of the SiNC films for fiat panel displays. A surface treatment with hydrogen plasma was performed on the SiNC films and a significant improvement of emission properties was achieved.