Stability and Nonlinear Deformation of Cylindrical Grids

The general stability of single-layer cylindrical grids is studied in linear and nonlinear formulations. Dependence of the general buckling load on the geometry and stiffness parameters of a grid is established in an analytical form. Such grids are numerically analyzed for stability. It is established that the general buckling load is much less than the local buckling load. Typical general buckling modes are found. It is shown that such grids are weakly sensitive to imperfections     

Sensitivity analysis of an optimized bar-spring model with hill-top branching

Summary Characteristics of optimal solutions under nonlinear buckling constraints are investigated by using a bar-spring model. It is demonstrated that optimization under buckling constraints of a symmetric system often leads to a structure with hill-top branching, where a limit point and bifurcation points coincide. A general formulation is derived for imperfection sensitivity of the critical load factor corresponding to a hill-top branching point. It is shown that the critical load is not imperfection-sensitive even for the case where an asymmetric bifurcation point exists at the limit point.     

Cu~+、Ag~+、Au~+与乙硫醇的气相化学反应

利用激光溅射 分子束的技术 ,结合反射飞行时间质谱计 ,研究了Cu+、Ag+、Au+与乙硫醇的气相化学反应。结果显示这三种金属离子与 (CH3 CH2 SH) n 反应形成一系列团簇离子M+(CH3 CH2 SH) n,且团簇离子尺寸不一样。Ag+、Au+与乙硫醇的反应还生成了 (CH3 CH2 SH) +n ,由此推测Cu+、Ag+、Au+与乙硫醇团簇的反应存在两种通道 ,一种通道是生成M+(CH3 CH2 SH) n,另一种是生成 (CH3 CH2 SH) +n 。Cu+、Au+与乙硫醇的反应还生成了M+(H2 S) (M =Cu、Au) ,但是实验中没有观察到Ag+(H2 S) ,理论计算表明Ag+(H2 S)很不稳定。另外 ,分析产物离子M+(CH3 CH2 SH) n 的强度发现 ,n =1～ 2之间存在明显的强度突变现象     

Fully developed mixed convection in horizontal and inclined tubes with uniform heat flux using nanofluid

Fully developed laminar mixed convection of a nanofluid consists of water and Al₂O₃ in horizontal and inclined tubes has been studied numerically. Three-dimensional elliptic governing equations have been solved to investigate the flow behaviors over a wide range of the Grashof and Reynolds numbers. Comparisons with previously published experimental and numerical works on mixed convection in a horizontal and inclined tube are performed and good agreements between the results are observed. Effects of nanoparticles concentration and tube inclinations on the hydrodynamics and thermal parameters are presented and discussed. It is shown that the nanoparticles concentration does not have significant effects on the hydrodynamics parameters. Heat transfer coefficient increases by 15% at 4 Vol.% Al₂O₃. Skin friction coefficient continually increases with the tube inclination, but the heat transfer coefficient reaches a maximum at the inclination angle of 45°.     

Effective stability for generalized Hamiltonian systems

An effective stability result for generalized Hamiltonian systems is obtained by applying the simultaneous approximation technique due to Lochak. Among these systems, dimensions of action variables and angle variables might be distinct.     

资源有限的加权总完工时间单机排序问题

本讨论资源有限的加权总工时间单机排序问题，对现在仍为OPEN问题1｜pj=bj-ajuj，∑uj≤U｜∑wjCj给出了一个有关最优解中最优资源分配的重要性质，并利用该性质分别给出了三种情况bj=b,wj=w,aj=a；bj=b,wj=w,uj=u；aj=a,wj=w,uj=u的最优算法。     

多重休假的带启动--关闭期的Geom/G/1排队

本研究多重休假的带启动——关闭期的Geom／G／1离散时间排队，给出稳态队长，等待时间分布的母函数及其随机分解结果，推导出忙期的全假期的母函数，给出该模型的几个特例。     

非线性Schrdinger方程的高精度守恒差分格式

本文首先分析线性Schrodinger方程一种高阶差分格式的构造方法,得到方程的耗散项.在此基础上对三次非线性Schrodinger方程,提出了一种精度为O(r2 h2)的差分格式,证明了该格式保持了连续方程的两个守恒量,且是收敛的与稳定的.并通过数值例子与已有隐格式进行了比较,结果表明,本文格式在计算量类似的情况下,提高了数值精度.     

Survivability in IP-over-WDM Networks: WDM Lightpath Protection versus IP LSP Protection

This article compares the performance of WDM lightpath protection and IP LSP protection schemes for IP-over-WDM networks. A mathematical formulation of the maximum throughput problem is presented and analytical expressions for recovery time are derived for both schemes. The throughputs and recovery times are analyzed and compared. Results show that the IP LSP protection scheme presents higher throughputs then WDM lightpath protection. The IP LSP protection scheme, providing individual IP LSP protection has, however, scalability problems. This scheme presents high recovery times when a failure affects many lightpaths and many hops are allowed for the primary routes of IP LSPs.     

Bounds to optimal burn‐in and optimal work size

Burn‐in is a widely used method to improve the quality of products or systems after they have been produced. In this paper, we consider the problem of determining the optimal burn‐in time and optimal work size maximizing the long‐run average amount of work saved per time unit in the computer applications. Assuming that the underlying lifetime distribution of the computer has an initially decreasing or/and eventually increasing failure rate function, an upper bound for the optimal burn‐in time is derived for each fixed work size and a uniform (with respect to the burn‐in time) upper bound for the optimal work size is also obtained. Furthermore, it is shown that a non‐trivial lower bound for the optimal burn‐in time can be derived if the underlying lifetime distribution has a large initial failure rate. Copyright © 2005 John Wiley & Sons, Ltd.