Conduction-radiation effect on transient natural convection with thermophoresis

This paper discusses the effect of thermophoretic particle deposition on the transient natural convection laminar flow along a vertical flat surface,which is immersed in an optically dense gray fluid in the presence of thermal radiation.In the analysis,the radiative heat flux term is expressed by adopting the Rosseland diffusion approximation.The governing equations are reduced to a set of parabolic partial differential equations.Then,these equations are solved numerically with a finite-difference scheme in the entire time regime.The asymptotic solutions are also obtained for sufficiently small and large time.The obtained asymptotic solutions are then compared with the numerical solutions,and they are found in excellent agreement.Moreover,the effects of different physical parameters,i.e.,the thermal radiation parameter,the surface temperature parameter,and the thermophoretic parameter,on the transient surface shear stress,the rate of surface heat transfer,and the rate of species concentration,as well as the transient velocity,temperature,and concentration profiles are shown graphically for a fluid(i.e.,air) with the Prandtl number of 0.7 at 20 C and 1.013 × 10 5 Pa.     

超燃冲压发动机等截面隔离段中流动的LBM模拟

采用耦合的双分布函数格子Boltzmann方法模拟超燃冲压发动机中隔离段的流动.计算结果反映了隔离段内流场的基本结构,表明LBM在隔离段的模拟中是-种具有潜力的数值计算方法.     

三角形网格上多介质流动问题界面处理方法

多介质流动问题的求解一般是在结构网格上实现,而三角形网格对于复杂计算区域具有更好的适应性,本文结合rGFM方法,给出三角形网格上多介质流动问题界面处理方法.利用level-set方法跟踪界面,在界面处构造Riemann问题,得到界面处流体准确的流动状态.通过定义界面边界条件,将多介质流动问题转化为单介质流动问题,利用高精度RKDG方法求解.采用多个算例验证该方法的稳健性和有效性,结果表明该方法能准确捕捉界面和激波的位置,保持界面清晰.     

轴向移动局部浸液单向板的1:3内共振分析

考虑单向板的轴向速度、轴向张力、流固耦合作用以及阻尼等因素, 基于由 von Kármán薄板大挠度方程得到的轴向移动局部浸液单向板的非线性振动方程, 研究了外激励作用下单向板在1:3内共振情况时的非线性振动特性. 首先利用Galerkin法对非线性振动方程离散化, 然后分别应用数值法和近似解析法对离散后模态方程组进行求解, 获得了系统内共振情况下复杂的幅频特性曲线, 并讨论了周期解的稳定性. 最后研究了1:3内共振系统平均方程组的运动分岔现象.     

Natural convection flow of a couple stress fluid between two vertical parallel plates with Hall and ion-slip effects

The Hall and ion-slip effects on fully developed electrically conducting couple stress fluid flow between vertical parallel plates in the presence of a temperature dependent heat source are investigated. The governing non-linear partial differential equations are transformed into a system of ordinary differential equations using similarity transformations. The resulting equations are then solved using the homotopy analysis method (HAM). The effects of the magnetic parameter, Hall parameter, ion-slip parameter and couple stress fluid parameter on velocity and temperature are discussed and shown graphically.     

FLUTTER INSTABILITY OF SUPPORTED PIPES CONVEYING FLUID SUBJECTED TO DISTRIBUTED FOLLOWER FORCES

In the past decades,it has been reported that divergence is the expected form of instability for fluid-conveying pipes with both ends supported.In this paper,the form of instability of supported pipes ...     

环形激波聚焦流场特性的数值研究

针对环形激波聚焦过程产生的高温、高压特性,采用间断有限元方法模拟了环形激波在同轴圆柱 形激波管内的聚焦流场特性。计算结果表明,采用间断有限元方法能够有效地捕捉激波聚焦过程形成的二次 激波、涡环、三波交点和球面双马赫反射等主要流动特征。此外,通过改变环形管道内外半径对聚焦流场进行 模拟发现,环形管道外径对中心轴线上聚焦峰值压力的大小和位置影响较小,环形管道内径对中心轴线上聚 焦峰值压力的大小和位置影响较大。计算结果可以为工程应用提供一定的理论指导。     

冲蚀磨损与冲蚀、空蚀交互磨损的对比研究

基于计算流体力学(computational fluid dynamics,CFD)方法,数值对比研究了在模拟水轮机工况中不同转速时,冲蚀与冲蚀、空蚀交互作用时,转盘表面的流场(压力场、流体浓度分布),然后在转盘式磨损装置上,进行了汽液固三相冲蚀与空蚀交互磨损试验.结果表明:对于冲蚀磨损来说,随着转速增加,压力增大,在冲蚀作用下加入空蚀磨损,压力增高,磨损加剧;而对于交互磨损来说,随着转速增加,转盘表面的空蚀磨损区域从空化孔附近开始沿着转盘旋转的反方向偏移,并且磨损程度加剧;数值计算的气泡较多且压力梯度较高区域和试验转盘磨损区域基本一致,数值计算结果和试验结果吻合得较好.     

用拉格朗日相关结构研究圆盘启动过程的流体输运

利用粒子成像测速(PIV)技术,得到了圆盘启动涡环流场的速度分布和涡量分布.圆盘启动涡环流场的有限时间李雅普诺夫指数场(Finit-time Lyapunov exponents,FTLE)以及拉格朗日相关结构(Lagrangian coherent structures,LCS)被计算出来.基于圆盘启动涡环流场的有限时间李雅普诺夫指数场以及拉格朗日相关结构,通过跟踪流体质点,对圆盘启动涡环流场的输运情况进行了分析.在圆盘启动涡环形成过程中,流体发现被圆盘和相互排斥的拉格朗日相关结构分成三部分.剪切流窗口(vorticity-flux window)被发现,涡量流通过剪切流窗口进入涡核.涡环的非定常边界被确定,它由相互排斥的拉格朗日相关结构背风面、圆盘以及剪切流窗口组成.     

Axial Couette flow of an Oldroyd-B fluid in an annulus

This paper establishes the velocity field and the adequate shear stress corresponding to the motion of an Oldroyd-B fluid between two infinite coaxial circular cylinders by means of finite Hankel transforms. The flow of the fluid is produced by the inner cylinder which applies a time-dependent longitudinal shear stress to the fluid. The exact analytical solutions, presented in series form in terms of Bessel functions, satisfy all imposed initial and boundary conditions. The general solutions can be easily specialized to give similar solutions for Maxwell, second grade and Newtonian fluids performing the same motion. Finally, some characteristics of the motion as well as the influence of the material parameters on the behavior of the fluid motion are graphically illustrated.