Precision measurement of vector and tensor analyzing powers in elastic deuteron-proton scattering

High-precision vector and tensor analyzing powers of elastic deuteron-proton ( d + p) scattering have been measured at intermediate energies to investigate effects of three-nucleon forces. Angular distributions in the range of 70^°-120^° in the center-of mass frame for incident-deuteron energies E _d ^lab = 130 and 180 MeV were obtained using the RIKEN facility. The beam polarization was unambiguously determined by measuring the ^12C (d, α)^10B(2⁺) reaction at 0^°. Results of the measurements are compared with state-of-the-art three-nucleon calculations. The present modeling of nucleon-nucleon forces and its extension to the three-nucleon system is not sufficient to describe the high-precision data consistently and requires, therefore, further investigation.     

19F-NMR进展

19F-NMR技术由于其化学位移范围大、不易出现峰重叠及灵敏度高等优点,自上个世纪50年代出现以来,在分析光学异构体,生命科学等研究中有其特殊意义.在体内核磁共振技术中,19F-NMR与其他方法相比,在不损伤样品的条件下,就可进行实时定量监测.近30年,引人氟代指示剂进行体内19F-NMR的研究,含氟生物活性物质以及含氟材料的研究受到很大的重视,19F-NMR技术及其应用发展起来.从近10年的情况来看,含氟生物活性物质的研究以及在医药、农药和具有优异性能的含氟材料的研究应用受到很大的重视,这是近期19F-NMR研究发展的一个主要特点.     

大学物理实验开放式教学的实现

提出了开展大学物理实验开放式教学的具体实现方法及步骤。     

少子寿命和表面形貌与多孔硅发光性能的关系

研究了不同时间腐蚀的多孔硅的光致发光性能与多孔硅的表面形貌和少子寿命之间的关系。结果表明,多孔硅的发光来自与氧空位有关的缺陷,而多孔硅表面的氢原子能够钝化多孔硅表面的非辐射中心从而提高多孔硅的发光效率。多孔硅的空隙度随腐蚀时间的延长而增大,这也导致了多孔硅的少子寿命的降低,从而造成多孔硅的光致发光效率随多孔硅空隙度的增大以及少子寿命的降低而提高。另外,原子力显微照片表明长时间的腐蚀使多孔硅表面层被化学腐蚀,从而降低了多孔硅表面的粗糙度。     

Temporal and spectral properties of ultrashort pulsed Laguerre-Gaussian beams in dispersive media

The temporal and spectral properties of ultrashort pulsed Laguerre-Gaussian (LG) beams propagating in dispersive media are studied both theoretically and numerically. It is shown that the on-axis pulse broadens with increasing propagation distance and the on-axis spectrum is blueshifted. For the off-axis spectrum the blueshifts decrease and then the spectrum becomes redshifted as the radial distance increases. The propagation of ultrashort pulsed LG beams in free space and of ultrashort pulsed Gaussian beams can be regarded as special cases of our results, and some interesting properties are discussed.     

一维随机激光器中准态模的饱和特性研究

针对随机激光器的半经典理论是应用电磁场时域有限差分法数值求解半经典随机激光模型方程组，基于半经典理论数值研究了一维随机激光器中准态模式的饱和特性，获得了不同准态模的空间分布和频谱分布图。计算结果分析显示：准态模式的某些特征参数如局域程度将会影响系统的饱和特性。利用这一结果，可以通过单频抽运方法选择具有低阈值、高饱和强度的准态模式作为整个激光系统的稳态输出模式。     

双间隙输出腔开放腔的高频特性分析

 建立了S波段相对论速调管放大器双间隙输出腔开放腔的3维模型。采用时域有限差分法，通过监测激励电流源的响应计算了该双间隙输出腔的谐振频率、有载Q值、场分布以及特性阻抗，并分析了腔体结构尺寸对谐振频率、有载Q值和特性阻抗的影响。研究表明：腔体半径对开放腔的谐振频率影响很大，耦合孔尺寸对腔体谐振频率的影响较小；随着耦合孔张角增加，有载Q值逐渐减小；随着腔体半径增大、间隙的减小，腔体特性阻抗降低。研究结果可为S波段强流相对论速调管放大器双间隙输出腔的设计提供理论依据。     

单分子荧光检测在生命科学中的应用

文章对单分子荧光检测在分子马达、离子通道、信号分子、蛋白折叠、蛋白构象变化动力学、酶活性反应、细胞过程实时观察等生命科学领域中的应用进行了介绍.这些研究结果表明,单分子荧光检测在研究生物大分子的活动规律与机制方面不但有着无法替代的优越性,而且有着广阔的发展空间.     

Multiaxial deformation of polyethylene and polyethylene/clay nanocomposites: in situ synchrotron small angle and wide angle X‐ray scattering study

A unique in situ multiaxial deformation device has been designed and built specifically for simultaneous synchrotron small angle X‐ray scattering (SAXS) and wide angle X‐ray scattering (WAXS) measurements. SAXS and WAXS patterns of high‐density polyethylene (HDPE) and HDPE/clay nanocomposites were measured in real time during in situ multiaxial deformation at room temperature and at 55 °C. It was observed that the morphological evolution of polyethylene is affected by the existence of clay platelets as well as the deformation temperature and strain rate. Martensitic transformation of orthorhombic into monoclinic crystal phases was observed under strain in HDPE, which is delayed and hindered in the presence of clay nanoplatelets. From the SAXS measurements, it was observed that the thickness of the interlamellar amorphous region increased with increasing strain, which is due to elongation of the amorphous chains. The increase in amorphous layer thickness is slightly higher for the nanocomposites compared to the neat polymer. © 2011 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys, 2011     

Crystallization and stereocomplexation behavior of poly(D‐ and L‐lactide)‐b‐poly(N,N‐dimethylamino‐2‐ethyl methacrylate) block copolymers

The thermal properties, crystallization, and morphology of amphiphilic poly(D ‐lactide)‐b‐poly(N,N‐dimethylamino‐2‐ethyl methacrylate) (PDLA‐b‐PDMAEMA) and poly (L ‐lactide)‐b‐poly(N,N‐dimethylamino‐2‐ethyl methacrylate) (PLLA‐b‐PDMAEMA) copolymers were studied and compared to those of the corresponding poly(lactide) homopolymers. Additionally, stereocomplexation of these copolymers was studied. The crystallization kinetics of the PLA blocks was retarded by the presence of the PDMAEMA block. The studied copolymers were found to be miscible in the melt and the glassy state. The Avrami theory was able to predict the entire crystallization range of the PLA isothermal overall crystallization. The melting points of PLDA/PLLA and PLA/PLA‐b‐PDMAEMA stereocomplexes were higher than those formed by copolymer mixtures. This indicates that the PDMAEMA block is influencing the stability of the stereocomplex structures. For the low molecular weight samples, the stereocomplexes particles exhibited a conventional disk‐shape structure and, for high molecular weight samples, the particles displayed unusual star‐like shape morphology. © 2011 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 49: 1397–1409, 2011