静电场中零电势点的确定和电势的计算

在静电场中,零电势点位置的确定,对电势计算的方便与否起着致关重要的作用.下面就4种情况,简述零电势点位置的确定及相应电势的计算公式.1 点电荷电场中各点电势的计算 例1 设一带电量为Q的点电荷,放在相对电容率为εT的无限大均匀电介质中,求空间各点的电势.     

用改进嵌入原子法计算Cu晶体的表面能

用改进嵌入原子法(MEAM)计算了Cu晶体12个晶面的表面能.结果表明，密排面(111)的表面能最小.其他晶面的表面能随其晶面与(111)晶面夹角的增加而增加，据此可以粗略地估计各晶面表面能的相对大小.给出的几何结构因子的确定方法及结果可以直接用于计算其他面心立方晶体的表面能及其他特性.在Cu,Ag等面心立方薄膜中出现(111)择优取向或织构的机理是表面能的最小化. 关键词： 改进嵌入原子法 铜 表面能 计算     

Calculation of the Specific Heats for the Ⅱ—Ⅲ and Ⅱ—Ⅳ Phase transitions in NH4I

This study gives our calculation for the specific heats CVI due to an Ising model using the observed Cp data for the Ⅱ-Ⅲ and Ⅱ-VI phase transitions in NH4I.By fitting to the CP data we determine the values of the critical exponent for the pressure of 0.14GPa(Ⅱ-Ⅲ phase transition)and for the pressures of 0.75,1.35and 1.97 GPa (II-IV phase transition)in NH4I.Our exponent values values are close to the predicted values of the specific heat in a three-dimensional Ising model.Our calculated CVI are in good agreement with the experimental CP for NH4I in most cases.     

Numerical Calculation and Analysis of Track Etching Process

Heavy ion irradiated polymers can be chemically etched to form track membrane with pores in the micro and sub-micro ranges. It has been reported that pore growth during etching can be related to track structures. A latent track has a track core inside and a track halo surrounding the track core. By single track etching it is observed that etching in the track core is much faster than in the track halo where the etching rate is even lower tlian that of bulk material. For multi-track etching, no such stages can be seen by the conductance measurements.     

轴流泵端壁区域流动三维粘性数值计算

本文采用通用流场分析软件FLUENT,基于N-S方程,选用RNG κ—ε湍流模型与SIMPLEC算法,对轴流泵叶轮内部(及端壁间隙)流动进行了三维粘性数值计算。通过实验验证,表明数值计算结果和实测数据吻合较好。详细分析了叶顶附近流场形态以及叶轮出口轴向、周向速度分布,进行了性能预估。并给出了实验装置图。     

一致P-函数非线性互补问题的宽邻域不可行内点算法及其计算复杂性

1引言与记号单调线性互补问题和线性规划问题的原始-对偶路径跟踪算法,1989年的文献[1、2]分别首先提出。以后又出现了一些改进的算法。早期的原始-对偶路径跟踪算法及其改进算法的迭代点列大都是在包含中心路径C的一个2-范数的窄邻域里,这种可行内点算法通常理论上具有最好的迭代复杂性O(n~(1/2)L),但是由于窄邻域极大地限制了迭代步长,实     

Feynman propagator for an arbitrary half-integral spin

Based on the solution to Bargmann-Wigner equation for a particle with arbitrary half-integral spin, a direct derivation of the projection operator and propagator for a particle with arbitrary half-integral spin is worked out. The projection operator constructed by Behrends and Fronsdal is re-deduced and confirmed and simplified, the general commutation rules and Feynman propagator with additional non-covariant terms for a free particle with arbitrary half-inteRzal spin are derived, and explicit expressions for the propagators for spins 3/2, 5/2 and 7/2 are provided.     

副品红共振光散射法测定脱氧核糖核酸

本文基于脱氧核糖核酸 (DNA)对有机染料副品红的共振光散射的增强效应 ,拟定了一种测定DNA的共振光散射法。在pH =0 5～ 1 5范围内 ,有机染料副品红于 35 5nm处的共振光散射强度被DNA强烈增强 ,且增强程度与DNA浓度呈线性关系 ,线性范围为 0 10～ 15 μg·mL- 1 ,检出限可达 36ng·mL- 1 。该方法简便、快速、具有较高的灵敏度和准确度 ,且线性范围较宽。将该方法用于混合样品中DNA的测定 ,结果令人满意。     

Sound Field Calculations of Elliptical Pistons by the Superposition of Two—Dimensional Gaussian Beams

We present an alternative approach to calculate the sound field of ultrasonic transducers.The distribution function of sources is expanded into the superposition of a series of two-dimensional Gaussian functions.The corresponding radiated sound field is expressed as the superposition of these two-dimensional Gaussian beams and is then reduced to the computation of these simple functions.This treatment does not require the condition that the shape of the source is of circular axial symmetry.A numerical example is presented for the uniform elliptical piston transducer and this is in good agreement with the results given by complicated computation.