氧极谱催化波法测定二苯胺

本文报道一种极谱测定二苯胺的新方法,它是基于二苯胺引起的氧极谱催化波.这个氧极谱催化波是由于二苯胺催化了电生超氧离子O_2~(-)的歧化反应产生的.本方法简单方便,有良好选择性.应用本方法测定了化工原料二苯胺的含量,结果令人满意.     

镀铜铁屑-H_2O_2催化氧化降解含酚废水

采用镀铜铁屑代替传统Fenton体系中的FeSO4作为催化剂,通过改变H2O2与镀铜铁屑的投加量、溶液的pH值、反应温度、反应时间等条件,研究了该体系对处理苯酚废水的影响。结果表明,常温下处理实际含酚印染废水,在pH值为4~6,30%H2O2 12mL/L,镀铜铁屑5g/L,反应时间为45min时,COD去除率可达96%,其CODCr从5827mg/L降至419mg/L,色度从2000降至30,符合国家三级排放标准。     

Thermal Stability Of Folic Acid in the solid-state

This study attempts to identify the degradative process which folic acid undergoes in the solid-state under thermal stress. In order to facilitate the process, the various pieces of the chemical structure, namely, p-amino benzoic acid, pterin and glutamic acid as both its d- and l-isomers were investigated as separate entities. These structured solid-state pieces were then compared to the composite solid state folic acid degradative curves in order to identify the peaks seen and provide direction for the interpolation of the degradative mechanism. It was observed that none of the structural pieces could be superimposed as assumed earlier and hence an attempt was made to identify the decomposition products using various analytical techniques such as infrared spectroscopy, mass spectroscopy and X-ray diffraction which suggested that the glutamic acid fragment is lost first as evidenced by acid loss and amide enhancement in the IR spectra. The vitamin was ultimately degrading to carbon fragments and that further identification was not necessary. This revised version was published online in August 2006 with corrections to the Cover Date.     

The gas phase reaction between CO2 and lanthanide atoms. A test of a model for the isokinetic effect

Summary Co₃O₄, NiCo₂O₄ and LaCo₂O₄catalysts were synthesizedby the citric acid-ligated method. These catalysts containing Co-oxide active components can largely lower the temperature of soot combustion under tight contact conditions. Under the conditions of loose contact NiCo₂O₄ cannot promote soot combustion, but LaCo₂O₄ can effectively promote soot combustion because the nanometric perovskite-type catalyst LaCoO₃produced in the LaCo₂O₄sample.</o:p>     

二氧化碳氧化剂在烷烃催化转化反应中的应用研究进展

本文综述了近年来国内外有关利用二氧化碳作为氧化剂在烷烃催化转化反应中的研究状况。担载型的金属氧化物催化剂具有较好的催化活性。催化剂表面碱性位的存在可稳定活性中心并且有利于CO2的活化，CO2的作用是与烷烃脱氢产物H2和生成的表面积炭反应，从而提高反应活性及催化剂的稳定性。     

原位漫反射红外光谱研究氮氧化物在Ag-ZSM-5催化剂上的吸附态及选择性催化还原反应机理

利用原位分析方法对催化剂表面吸附态进行动态表征，对了解催化反应机理具有重要的意义。漫反射红外光谱是一种理想的原位方法，应用该方法在298－773K范围原位考察了以丙烯为还原剂，NO在Ag-ZSM-5催化剂上的吸附态及选择性催化还原过程。认为NO的选择性催化还原符合直接作用机理，还原的关键是形成有机－氮氧化物（R－NO2或R－ONO）中间体。O2的作用是使C3H6充分活化，并是有效产生有机－氮氧化物不可缺少的条件。     

镧掺杂粘土源含铜氧化物催化剂的制备、表征及催化性能

采用共沉淀和水热法合成了不同阴离子粘土前驱型复合氧化物催化材料,样品经XRD,FTIR,TPR,TG-DSC,SEM进行表征.同时考察了铜含量在掺杂和不掺杂稀土时对甲烷催化燃烧的影响,结果发现随含铜量增加催化活性增加;未掺杂La的催化剂在高温下出现失活现象,而掺杂型催化剂稳定性良好.同时,制备方法对催化剂的性能有显著影响,在不同制备前驱物pH的条件下,使用共沉淀和水热法合成的阴离子粘土材料,合成时的pH均对催化剂的活性影响较大;同时焙烧温度对催化活性有不同程度的影响.     

Sm修饰的Ni-MgO催化剂制备碳纳米管的研究

Carbon nanotubes (CNTs) have been synthesized over Ni-MgO and Ni-Sm-MgO catalysts by decomposition of CH₄ at 650 ℃. The addition of Sm into Ni-MgO catalyst not only promotes the catalytic activity and lifetime of the catalyst, but also improves the graphitization and heat stability of carbon nanotubes. The yield of CNTs obtained over the Ni-10Sm-MgO catalyst reaches 33 g C·(g Ni)^-1, being more than 5 times higher than that of the Ni-MgO catalyst. XRD and TPR results of the catalysts indicate that there is a remarkable interaction of Ni with Sm species, which facilitates the reduction of nickel and restrains the Ni particles from agglomerating.     

甲烷磺酸盐的合成、表征及其催化酯化反应的性能

Methane-sulfonate of copper, cobalt, zinc, lanthanide, praseodymium and neodymium are synthesized and characterized by FTIR and TGA. Methane-sulfonates are used as the catalysts in the esterification of chloroacetic acid with isopropanol. Catalytic activity of methane-sulfonates is studied and compared with other Lewis acids. Under the condition of 1.2/1 molar ratio of isopropanol to chloroacetic acid, 1% catalyst (molar percent of chloroacetic acid), 2.5h reaction time, 80～85℃ temperature and benzene as water-carrying agent. The experi-mental results showed that catalytic activity of Lanthanide methane-sulfonate was the best, the yield of isopropyl chloroacetate reaches 88.7%. Copper methane-sulfonate can be reused for three times without distinct loss of catalytic activity.     

Fe-Ni-B-O纳米合金的合成及其催化制氢性能的研究

Preparation and catalytic performance of Fe-Ni-B-O nano-alloy having crystal-palpus structure has been studied. Black powder was synthesized by reducing mixture solution of Fe²⁺, Ni²⁺ with KBH₄ as reducing agent and polyethylene glycol as dispersant. Fe-Ni-B-O nano-alloy of crystal-palpus structure was obtained after hydrogen reduction of black powder. TEM shows that crystal-palpus length is 200～400 nm, diameter is 2～4 nm. The analytic results indicate that the total content of Fe and Ni is 86.6%, B is 5.08%. The alloy exhibits excellent catalytic performance. Hydrogen generation rate can approach 100% especially when pH is 8.