Bis-tridentate IrIII Phosphors Bearing Two Fused Five-Six-Membered Metallacycles: A Strategy to Improved Photostability of Blue Emitters

Iridium complexes bearing chelating cyclometalates are popular choices as dopant emitters in the fabrication of organic light-emitting diodes (OLEDs). In this contribution, we report a series of blue-emitting, bis-tridentate Ir^III complexes bearing chelates with two fused five-six-membered metallacycles, which are in sharp contrast to the traditional designs of tridentate chelates that form the alternative, fused five-five metallacycles. Five Ir^III complexes, Px-21 – 23 , Cz-4 , and Cz-5 , have been synthesized that contain a coordinated dicarbene pincer chelate incorporating a methylene spacer and a dianionic chromophoric chelate possessing either a phenoxy or carbazolyl appendage to tune the coordination arrangement. All these tridentate chelates afford peripheral ligand–metal–ligand bite angles of 166–170°, which are larger than the typical bite angle of 153–155° observed for their five-five-coordinated tridentate counterparts, thereby leading to reduced geometrical distortion in the octahedral frameworks. Photophysical measurements and TD-DFT studies verified the inherent transition characteristics that give rise to high emission efficiency, and photodegradation experiments confirmed the improved stability in comparison with the benchmark fac-[Ir(ppy)₃] in degassed toluene at room temperature. Phosphorescent OLED devices were also fabricated, among which the carbazolyl-functionalized emitter Cz-5 exhibited the best performance among all the studied bis-tridentate phosphors, showing a maximum external quantum efficiency (EQE_max) of 18.7 % and CIE_x,y coordinates of (0.145, 0.218), with a slightly reduced EQE of 13.7 % at 100 cd m⁻² due to efficiency roll-off.     

QEPAS系统中石英音叉模态仿真计算与研究

对石英音叉增强型光声光谱(QEPAS)系统中常用的石英音叉进行了有限元模态计算，获得石英音叉前6阶振型与模态频率，认知了第4阶对称摆动振型为有效振动，利用单因素法分析了石英音叉的音臂长度l₁、音臂宽度w₁、音臂厚度t、音臂切角θ、音臂圆孔直径d及音臂圆孔高度h对低阶有效共振频率(Fre)的影响，敏感度依次为： l₁> w₁>d>θ>t>h，考虑实际设计情形，筛选出了l₁，w₁，d与h四个石英音叉设计变量，采用Box-Behnken实验设计方案与RSM(response surface methodology)方法，以Fre为函数目标，建立l₁，w₁，d与h的二次回归响应面模型，得到了参数之间的交互作用，利用Design-Expert软件对响应面模型进行设计参数反求，结果表明，在15 000 Hz≤Fre≤25 000 Hz计算区域内误差较小，基本满足QEPAS系统的计算需求，所提出的研究与设计方法具有一定通用性，可为QEPAS系统中石英音叉结构参数设计提供参考。     

氢化丁苯共聚物结构的核磁共振波谱表征Ⅱ.微观结构的定量计算

在氢化丁苯共聚物¹³C-NMR谱脂肪碳部分谱带归属的基础上,根据各谱带的主要来源,推导出六个二单元浓度的计算公式。计算出二单元、一单元的相对含量,各结构单元的数均序列长度、嵌段含量和其它结构参数。加氢前后的¹H-和¹³C-NMR谱的组成计算结果基本一致。初步探讨了作为粘度指数改进剂的氢化丁苯共聚物微观结构与性能的关系,为合成提供了依据。     

Equivalence of variational inequality problems to unconstrained minimization

In this paper we propose a class of merit functions for variational inequality problems (VI). Through these merit functions, the variational inequality problem is cast as unconstrained minimization problem. We estimate the growth rate of these merit functions and give conditions under which the stationary points of these functions are the solutions of VI. This work was supported by the state key project “Scientific and Engineering Computing”.     

Improved spacer design and cost reduction in an electrodialysis system

In electrodialysis using thin membranes and spacers, the compactness of the membrane cell-pairs leads to a small potential drop, and hence to energy saving. The spacer design itself has a great effect on the cost of the plants, since spacers act as turbulence promoters. A careful design, to increase the mass transfer coefficients, can reduce the membrane surface area required for a given application. Limiting current measurements, cell-pair resistance and pressure losses are presented for several thin spacers, for different flow-velocity values and feed water concentrations. It was possible to find an advantageous geometry of the separating mesh leading to substantial savings on investment and operation costs.     

固体力学有限元体系的结构拓扑变化理论

本文是文[1]的继续.文[1]提出了杆件系统的结构拓扑变化理论和拓扑变化法本文将这一理论和方法推进到连续体有限元体系;且在此基础上揭示出有限元体系的一个新性质,称为基本位移之梯度的正交性定理,从而给出一套设计敏度的显式表达式,可直接用于计算.     

Preliminary Contribution to the Quantification of HMF in Honey by Electrochemical Biosensor Chips

Several hydroximethylfurfural (HMF) microbiosensors, based on a microelectrode configuration built by photolithographic techniques, have been developed. Two different biosensors based on the aldehyde dehydrogenase (ALDH) enzyme coupling with NADH oxidase (NOD) or diaphorase (Diaph) are described. Experimental variables were optimized using experimental design methodology, by central composite designs, taking the intensity registered for a given HMF solution as response. Given the reproducibility (residual standard deviation (RSD), 7.20%), repeatability (RSD=3%) and limit of detection (LOD)=1.68×10^?4 mol dm^?3 (α=β=0.05 and a replicate) reached by the ALDH‐Diaph microbiosensor under the optimum conditions, the analysis of HMF in honey was successfully accomplished.     

A profit-maximizing supply chain network design model with demand choice flexibility

We present a profit-maximizing supply chain design model in which a company has flexibility in determining which customers to serve. The company may lose a customer to competition if the price it charges is too high. We show the problem formulation and solution algorithm, and discuss computational results.     

k-树的补图的最小填充和树宽

一个图的最小填充问题是寻求边数最少的弦母图,一个图的树宽问题是寻求团数最小的弦母图,这两个问题分别在稀疏矩阵计算及图的算法设计中有非常重要的作用．一个k-树G的补图G称为k-补树．本文给出了k-补树G的最小填充数f(G) 及树宽TW(G)．     

Well-Posedness by Perturbations of Variational Problems

In this paper, we consider the extension of the notion of well-posedness by perturbations, introduced by Zolezzi for optimization problems, to other related variational problems like inclusion problems and fixed-point problems. Then, we study the conditions under which there is equivalence of the well-posedness in the above sense between different problems. Relations with the so-called diagonal well-posedness are also given. Finally, an application to staircase iteration methods is presented.