水杨酸分子印迹分离介质的水相制备及色谱行为

以水杨酸为模板分子,2-乙烯基吡啶为功能单体,在甲醇/水体系中制备了水杨酸分子印迹聚合物,并将其作为高效液色谱分离介质研究了其对水杨酸及水杨酸的位置异物体———对羟基苯甲酸的色谱行为。结果表明,该聚合物固定相表现出良好的分离选择性,能够使水杨酸与对羟基苯甲酸快速基线分离。通过对流动相组成与色谱分离效果关系的探讨,证实溶质与印迹固定相的疏水相互作用是分子识别的主要作用力。     

氰氟草酯及其代谢物在稻田水、土壤和稻株中的残留分析方法

研究并建立了氰氟草酯及其 4种代谢物在稻田水、土壤及稻株中的残留分析方法。在同一色谱分析条件下 ,同时检测 5种化合物 ,样品前处理过程简单 ,方法准确可靠 ,灵敏度和准确度达到了农药残留检测的要求。氰氟草酯及 4种代谢物在上述样品中的最低检知浓度在 0 .0 2～ 0 .0 0 4mg kg之间 ,方法的添加回收率(0 .0 1～ 5mg kg)在 80 .2 %～ 1 0 1 .2 %之间     

Overwhelming electrochemical oxygen reduction reaction of zinc-nitrogen-carbon from biomass resource chitosan via a facile carbon bath method

Developing high efficiency and low cost electrocatalysts is critical for the enhancement of oxygen reduction reaction (ORR), which is the fundamental for the development and commercialization of renewable energy conversion technology. Herein, zinc-nitrogen-carbon (Zn-N-C) was prepared by using biomass resource chitosan via a facile carbon bath method. The obtained Zn-N-C delivered a high specific surface area (794.7 cm²/g) together with pore volume (0.49 cm³/g). During the electrochemical evaluation of oxygen reduction reaction (ORR), Zn-N-C displayed high activity for ORR with an onset potential E₀ = 0.96 V_RHE and a half wave potential E_1/2 = 0.86 V_RHE, which were more positive than those of the commercial 20 wt% Pt/C benchmark catalyst (E₀ = 0.96 V_RHE and E_1/2 = 0.81 V_RHE). In addition, the Zn-N-C catalyst also had a better stability and methanol tolerance than those of the Pt/C catalyst.     

Trace determination of nitrated polycyclic aromatic hydrocarbons using liquid chromatography with on-line electrochemical reduction and fluorescence detection

An efficient clean-up procedure coupled with a high performance liquid chromatography (HPLC) with on-line electrochemical (EC) reduction and fluorescence detection (FLD) was developed to quantify nitrated polycyclic aromatic hydrocarbons (NPAHs) in the airborne particulate. In this process, NPAHs were extracted ultrasonically followed by analysis by using a reversed phase column with an aqueous eluent containing 70% aqueous acetonitrile and sodium monocholoroacetate as a buffer solution. The extraction efficiencies were above 83% for 1-nitropyrene and 1,3-dinitropyrene (1,3-DNP) 1,6-DNP, and 1,8-DNP, and calibration graphs were linear with very good correlation coefficients (r>0.999) and the detection limits were in the range of 1.0-2.2 pg for dinitropyrenes and nitropyrene. The proposed method provides a relatively simple and convenient procedure for determining the NPAHs samples in airborne particulate.     

The characterization of silica microparticles by electrophoretic mobility measurements

Summary Electrophoretic mobility measurements in the pH 2‐10 range are described for several commercial HPLC silica microparticles and a laboratory-produced product. The content of metal impurities for the silicas was also determined by AAS. An acidic/hydrothermal treatment was used to generate a more homogenous surface for some of the silicas. The zero points of charge (zpc) for both a native and a treated silica plus several commercial HPLC silicas were compared. The electrophoretic mobility method may be useful in predicting the utility of certain types of silica supports for chromatographic separations.     

MH—Ni电池封口化成及其性能

在硼氢化钾碱性溶液中对金属氢化物（ＭＨ）电极的表面进行化学还原处理，提高了ＭＨ电极的放电容量、活化性能和电催化活性．用其为负极组装的ＡＡ型ＭＨ－Ｎｉ电池进行了封口化成，电池放电容量达到１１５０ｍＡｈ，５Ｃ下电池的放电容量达到０．２Ｃ下容量的８０％以上，电池在１Ｃ１００％ＤＯＤ（放电深度）充放电条件下，循环寿命由原来的１００次左右提高到２００次以上     

高富勒烯的提取,分离和分析

采用二硫化碳重结晶富勒烯混合物或二硫化碳二次抽提烟灰以提取高富勒烯（ｈｉｇｈｅｒｆｕｌｅｒｅｎｅｓ，Ｃｎ，ｎ＞７０）。产物经高效液相色谱分析，高富勒烯的含量从１％分别提高到４％和６％；经激光飞行时间质谱证明，产物中除含主要成分Ｃ６０和Ｃ７０以外，还含有Ｃ７６、Ｃ７８、Ｃ８２、Ｃ８４以及更高碳原子的富勒烯。     

横向加热石墨炉的分析性能研究

研究了横向加热石墨炉的恒温性能和分析性能，并与Ｍａｓｓｍａｎｎ型炉进行了比较，结果表明，横向加热石墨炉具有较好的恒温性能，其原子化时间短，原子化温度低，原子吸收信号的占有时间短，特征质量ｍ０值低。     

Synthesis and properties of new crystalline poly(arylene ether nitriles)

Crystalline poly(arylene ether nitrile) could be prepared by the polycondensation of 2,6-dihalobenzonitrile with resorcinol at 200°C in N-methylpyrrolidone in the presence of sodium carbonate. A reaction temperature of at least 200°C was necessary to attain high molecular weight polymer. Spectral data indicated that the polymer had the structure of a poly(meta-phenylene ether) with pendent nitrile groups on every other phenylene unit. Despite this structure, the crystallinity and the crystallization rate of the polymer were greater than those of the corresponding polymer with a para-linked structure. The glass transition temperature and the melting temperature of the polymer were almost the same as those of poly(etheretherketone) (PEEK^TM). A series of other new poly(arylene ether nitriles) were also examined. The polymers derived from 4,4′-biphenol, dihydroxytetra-phenylmethane, dihydroxydiphenylsulfone, and 1,5-isoquinolinediol had high glass transition temperatures. The poly(arylene ether nitriles) exhibited excellent tensile strength compared with the corresponding ketone- or sulfone-containing polymers. Comparing the three different kinds of polymers containing the same bisphenol units, the order of glass transition temperature was found to be sulfone- > nitrile- > ketone-containing polymers, while the order of tensile strength was nitrile- > ketone- > sulfone-containing polymers. The excellent mechanical properties are attributable to dipole-dipole interactions of nitrile groups. © 1993 John Wiley & Sons, Inc.     

纳米SrTiO3对高铁酸盐电化学性能影响研究

Two ferrates, K₂FeO₄ and BaFeO₄, had been prepared and characterized by XRD, IR and SEM. The electrochemical tests of the samples were carried out in the voltage range of 0.8～2.0 V and current density of 0.5～3.0 mA·cm^-2. The results indicated that performance of Zn-BaFeO₄ battery was superior to that of Zn-MnO₂ and Zn-K₂FeO₄ batteries. Nanometer SrTiO₃ prepared by Sol-gel methode with different ratio was added to the BaFeO₄ cathode in order to improve the discharge performance. The discharge capacity of the BaFeO₄ cathode was increased from 224 mAh·g^-1 to 246 mAh·g^-1 by addition of 5% nanometer SrTiO₃. The reason of enhancing BaFeO₄ electrochemical performance was discussed.