Definition and detection of data-based uniqueness in evaluating bilinear (two-way) chemical measurements

Multivariate curve resolution methods, frequently used in analyzing bilinear data sets, result in ambiguous decomposition in general. Implementing the adequate constraints may lead to reduce the so-called rotational ambiguity drastically, and in the most favorable cases to the unique solution. However, in some special cases, non-negativity constraint as minimal information of the system is a sufficient condition to resolve profiles uniquely. Although, several studies on exploring the uniqueness of the bilinear non-negatively constrained multivariate curve resolution methods have been made in the literature, it has still remained a mysterious question. In 1995, Manne published his profile-based theorems giving the necessary and sufficient conditions of the unique resolution. In this study, a new term, i.e., data-based uniqueness is defined and investigated in details, and a general procedure is suggested for detection of uniquely recovered profile(s) on the basis of data set structure in the abstract space. Close inspection of Borgen plots of these data sets leads to realize the comprehensive information of local rank, and these argumentations furnish a basis for data-based uniqueness theorem. The reported phenomenon and its exploration is a new stage (it can be said fundament) in understanding and describing the bilinear (matrix-type) chemical data in general.     

Salting‐out‐assisted liquid–liquid extraction with acetonitrile for the determination of trimetazidine in rat plasma using liquid chromatography–mass spectrometry

A high‐throughout bioanalytical method based on salting‐out‐assisted liquid/liquid extraction (SALLE) method with acetonitrile and mass spectrometry‐compatible salts followed by LC‐MS/MS analysis of trimetazidine in rat plasma is presented. It required only 50 μL of plasma and allows the use of minimal volumes of organic solvents. The seamless interface of SALLE and LC‐MS eliminated the drying‐down step and the extract was diluted and injected into an LC‐MS/MS system with a cycle time of 2.5 min/sample. The retention times of trimetazidine and IS were approximately 1.1 and 1.7 min, respectively. Calibration curves were linear over the concentration range of 0.1–100 ng/mL, which can be extended to 500 ng/mL by dilution. The intra‐ and inter‐batch precision, accuracy and the relative standard deviation were all <15%. This method was successfully applied to determine trimetazidine concentrations in rat plasma. Copyright © 2014 John Wiley & Sons, Ltd.     

Metabolic profiles of dioscin in rats revealed by ultra‐performance liquid chromatography quadrupole time‐of‐flight mass spectrometry

Dioscin (DIS), one of the most abundant bioactive steroidal saponins in Dioscorea sp., is used as a complementary medicine to treat coronary disease and angina pectoris in China. Although the pharmacological activities and pharmacokinetics of DIS have been well demonstrated, information regarding the final metabolic fates is very limited. This study investigated the in vivo metabolic profiles of DIS after oral administration by ultra‐performance liquid chromatography quadrupole time‐of‐flight mass spectrometry method. The structures of the metabolites were identified and tentatively characterized by means of comparing the molecular mass, retention time and fragmentation pattern of the analytes with those of the parent compound. A total of eight metabolites, including seven phase I and one phase II metabolites, were detected and tentatively identified for the first time. Oxidation, deglycosylation and glucuronidation were found to be the major metabolic processes of the compound in rats. In addition, a possible metabolic pathway on the biotransformation of DIS in vivo was proposed. This study provides valuable and new information on the metabolism of DIS, which will be helpful for further understanding its mechanism of action. Copyright © 2015 John Wiley & Sons, Ltd.     

Simultaneous quantification of leukotrienes and hydroxyeicosatetraenoic acids in cell culture medium using liquid chromatography/tandem mass spectrometry

Leukotrienes (LTs) and hydroxyeicosatetraenoic acids (HETEs) are important bioactive lipid mediators that participate in various pathophysiological processes. To advance understanding of the mechanisms that regulate these mediators in physiological and pathological processes, an analytical method using liquid chromatography/tandem mass spectrometry for the simultaneous quantification of LTB₄, LTC₄, LTD₄, LTE₄, 5‐HETE_, 8‐HETE, 12‐HETE and 15‐HETE in cell culture media was developed. A Supel?‐Select HLB solid‐phase extraction cartridge was used for sample preparation. The compounds were separated on a C₁₈ column using gradient elution with acetonitrile–water–formic acid (20:80:0.1, v/v/v) and acetonitrile–formic acid (100:0.1, v/v). The calibration curves of LTB₄, LTD₄, LTE₄ and HETEs were linear in the range of 0.025–10 ng/mL, and the calibration curve of LTC₄ was linear in the range of 0.25–10 ng/mL. Validation assessment showed that the method was highly reliable with good accuracy and precision. The stability of LTs and HETEs was also investigated. Using the developed method, we measured LTs and HETEs in the culture supernatant of the human mast cell line HMC‐1. The present method could facilitate investigations of the mechanisms that regulate the production, release and signaling of LTs and HETEs. Copyright © 2014 John Wiley & Sons, Ltd.     

Thermally induced solid-state transformation of cimetidine. A multi-spectroscopic/chemometrics determination of the kinetics of the process and structural elucidation of one of the products as a stable N3-enamino tautomer

Exposure of cimetidine (CIM) to dry heat (160–180 °C) afforded, upon cooling, a glassy solid containing new and hitherto unknown products. The kinetics of this process was studied by a second order chemometrics-assisted multi-spectroscopic approach. Proton and carbon-13 nuclear magnetic resonance (NMR), as well as ultraviolet and infrared spectroscopic data were jointly used, whereas multivariate curve resolution with alternating least squares (MCR-ALS) was employed as the chemometrics method to extract process information. It was established that drug degradation follows a first order kinetics.     

气体压强对纳秒激光诱导空气等离子体特性的影响

环境气体的压强对激光诱导等离子体特性有重要影响.基于发射光谱法开展了气体压强对纳秒激光诱导空气等离子体特性影响的研究,探讨了气体压强对空气等离子体发射光谱强度、电子温度和电子密度的影响.实验结果表明,在10-100 kPa空气压强条件下,空气等离子体发射光谱中的线状光谱和连续光谱依赖于气体压强变化,且原子谱线和离子谱线强度随气体压强的变化有明显差别.随着空气压强增大,激光击穿作用区域的空气密度增加,造成激光诱导击穿空气几率升高,从而等离子体辐射光谱强度增大.空气等离子体膨胀区域空气的约束作用,增加了等离子体内粒子间的碰撞几率以及能量交换几率,并且使离子-电子-原子的三体复合几率增加,因此造成原子谱线OⅠ777.2 nm与NⅠ821.6 nm谱线强度随着气体压强增大而增大,在80 kPa时谱线强度最高,随后谱线强度缓慢降低.而离子谱线N Ⅱ 500.5 nm谱线强度在40 kPa时达到最大值,气体压强大于40 kPa后,谱线强度随压强增加而逐渐降低.空气等离子体电子密度均随压强升高而增大,在80 kPa后增长速度变缓.等离子体电子温度在30 kPa时达到最大值,气体压强大于30 kPa后,等离子体电子温度逐渐降低.研究结果可为不同海拔高度的激光诱导空气等离子体特性的研究提供重要实验基础,为今后激光大气传输、大气组成分析提供重要的技术支持.     

Simultaneous determination of major components of Huangqi–Honghua extract in rat plasma using LC–MS/MS and application to a pharmacokinetic study

A sensitive and reliable LC–MS/MS method was developed and validated for simultaneous quantification of the major components of Huangqi–Honghua extact in rat plasma, including hydroxysafflor yellow A (HSYA), astragaloside IV (ASIV), calycosin‐7‐O‐β‐d ‐glucoside (CAG), calycosin, calycosin‐3′‐O‐glucuronide (C‐3′‐G) and calycosin‐3′‐O‐sulfate (C‐3′‐S). After extraction by protein precipitation with acetonitrile and methanol from plasma, the analytes were separated on a Hypersil BDS C₁₈ column by gradient elution with acetonitrile and 5 mM ammonium acetate. The detection was carried out on a triple quadrupole tandem mass spectrometer equipped with electrospray ionization source switched between negative and positive modes. HSYA was monitored in negative ionization mode from 0 to 4.9 min, and ASIV, CAG, calycosin, C‐3′‐G and C‐3′‐S were determined in positive ionization mode from 4.9 to 10 min. The lower limits of quantification of the analytes were 6.25 ng/mL for HSYA, 0.781 ng/mL for CAG and 1.56 ng/mL for ASIV and calycosin. The intra‐ and inter‐assay precision (RSD) values were within 13.43%, and accuracy (RE) ranged from ?8.75 to 9.92%. The validated method was then applied to the pharmacokinetic study of HSYA, ASIV, CAG, calycosin, C‐3′‐G and C‐3′‐S in rat after an oral administration of Huangqi–Honghua extract.     

Cycloparaphenylene (CPP) series are molecular models for graphene armchair edges: trends in their aromaticity and cyclic conjugation are evaluated

Cycloparaphenylene ([r]CPP) and cyclacene ([r]CA) series are models for short carbon nanotubes. It is shown that armchair edges in model cycloparaphenylenes possess greater aromaticity and cyclic conjugation than do zigzag edges in model cyclacenes. According to Aihara’s bond resonance energy (BRE) and Bosanac and Gutman energy effect (ef) measurements, cycloparaphenylenes are twice as aromatic as cyclacenes. The general solution of all eigenvalues of all members of the cycloparaphenylene series is given. The origin of the recurrence of some eigenvalues are determined.     

Rational Molecular Design towards Vis/NIR Absorption and Fluorescence by using Pyrrolopyrrole aza‐BODIPY and its Highly Conjugated Structures for Organic Photovoltaics

Pyrrolopyrrole aza‐BODIPY (PPAB) developed in our recent study from diketopyrrolopyrrole by titanium tetrachloride‐mediated Schiff‐base formation reaction with heteroaromatic amines is a highly potential chromophore due to its intense absorption and fluorescence in the visible region and high fluorescence quantum yield, which is greater than 0.8. To control the absorption and fluorescence of PPAB, particularly in the near‐infrared (NIR) region, further molecular design was performed using DFT calculations. This results in the postulation that the HOMO–LUMO gap of PPAB is perturbed by the heteroaromatic moieties and the aryl‐substituents. Based on this molecular design, a series of new PPAB molecules was synthesized, in which the largest redshifts of the absorption and fluorescence maxima up to 803 and 850 nm, respectively, were achieved for a PPAB consisting of benzothiazole rings and terthienyl substituents. In contrast to the sharp absorption of PPAB, a PPAB dimer, which was prepared by a cross‐coupling reaction of PPAB monomers, exhibited panchromatic absorption across the UV/Vis/NIR regions. With this series of PPAB chromophores in hand, a potential application of PPAB as an optoelectronic material was investigated. After identifying a suitable PPAB molecule for application in organic photovoltaic cells based on evaluation using time‐resolved microwave conductivity measurements, a maximized power conversion efficiency of 1.27 % was achieved.