氧化钙对流化床燃煤飞灰中砷的淋滤特性影响

在实验室小型流化床实验装置上,利用添加氧化钙研究了原煤中钙硫比变化对燃煤过程中砷在飞灰中的富集规律和飞灰中砷的浸出特性的影响。实验结果表明,增加钙硫比能有效促进砷在飞灰中富集,降低砷的排放。砷与氧化钙的反应受制于钙的硫化反应控制。飞灰中砷的浸出与滤液pH值关系显著,碱性飞灰导致滤液pH值增大,能有效抑制飞灰中砷的浸出。碱性飞灰中砷的浸出历程为飞灰中砷在短时间内快速溶出;随着滤液pH值增大,溶出的砷与钙发生二次反应形成钙砷化合物沉淀,降低滤液中砷浓度。     

循环流化床富氧气化实验研究

在循环流化床富氧气化实验台上,通过调节水蒸气流量使气化温度基本稳定在910℃,研究了不同氧气浓度及气化当量比对煤气组分、产气率、冷煤气效率及碳转化率的影响。结果表明,氧气浓度从25%增加至40%时,N2体积分数从48.82%降低至33.83%,H2从21.47%不断增加至27.59%,CH4基本不变;受水蒸气流量影响,氧气浓度高于35%时,CO体积分数降低,CO2体积分数增加;氧气浓度40%时的煤气热值为空气气化煤气热值的1.84倍,产气率随氧气浓度增加从2.35 m3/kg降至2.13 m3/kg,冷煤气效率和碳转化率不断增大;当气化当量比从0.20增加至0.29时,N2体积分数先降低后升高,H2体积分数从24.01%增加到25.46%后基本保持不变,CO和CH4持续减小,CO2不断增加,产气率由1.94 m3/kg升高到2.29 m3/kg;受水蒸气和气化当量比综合影响,冷煤气效率先增大后减小,碳转化率持续增加。     

油页岩固定床热解反应器中内构件强化作用

在内构件(传热板和中心集气管)外热式固定床反应器中研究了油页岩热解产物生成特性,并与无内构件的相同常规固定床反应器内的油页岩热解行为对比,考察了两反应器中油页岩升温特性、热解产物分布、页岩油品质以及气体产物组成的变化规律.结果表明,内置传热板和中心集气管显著强化了反应器内的传热,相对于无内构件常规固定床反应器,料层升温速率提高了约2倍.对于依兰油页岩,其热解页岩油产率明显提高,最高达11.1 wt%(干燥基),明显高于无构件常规固定床反应器获得的页岩油产率.随着外加热炉温度的升高,内构件固定床反应器的页岩油产率逐渐增加,而无内构件常规固定床反应器的页岩油产率则明显降低.当外加热炉温度为1000℃时,前者页岩油产率是后者的2.3倍,并且内构件固定床反应器的热解水产率较低.两反应器中热解气产物组成相近,其H2与CH4之和占气体总量的70 vol%左右,热值为4406~5400 kcal/Nm3.     

Sorptive elimination of fluoride from contaminated groundwater in a fixed bed column: A kinetic model validation based study

The current investigation involves a continuous adsorption experiment in a packed bed column for the sorptive elucidation of fluoride from contaminated groundwater using an activated soil-clay mixture. Through the combination of naturally accessible laterite soil with silica enriched clay (3:1 ratio), a low-cost Al–Si heterogeneous material has been developed. Following detailed characterization, the developed materials were employed in a long-time column process to achieve a high degree of fluoride separation from real-world groundwater. In a packed bed column investigation, the effect of bed height, initial fluoride concentration, and flow rate on the breakthrough properties of the adsorption system were investigated. By using a non-linear regression equation, three model kinetics, such as the Thomas Model, Adams-Bohart Model, and Yoon-Nelson Model, were fitted to validate the column-based experimental data, by analysing the breakthrough curves profiles, and distinct kinetic parameters. The Bed Depth Service Time Analysis (BDST) model was tested to express the effect of bed height on breakthrough curves, as well as to predict the time for breakthrough, and material depletion under optimal conditions. The Thomas and Yoon-Nelson models were identified to be the most appropriate ones for describing the entire breakthrough curve, whereas the Adams-Bohart model was only utilised to predict the first half of the dynamic process. With correlation coefficients (R²) 0.96, the experimental results were well suited to Thomas, Yoon-Nelson, and Adams-Bohart models. Finally, regeneration assessment was carried out where even after four cycles of operation, regenerated adsorbent showed a rejection efficacy of 78% to fluoride that proves the viability of the material and methodology.     

改进蚁群PID-神经元解耦的CFB锅炉燃烧系统控制

床温和主汽压都是循环流化床锅炉生产运行中的重要参数,会直接影响机组的安全性和经济性。但由于这两者对象存在非线性、大时延、强耦合等特点,其现场控制效果一直不太理想。本文首先采用自适应神经元将床温和主汽压解耦,再利用具有分工特征的蚁群算法优化参数的PID控制器对两者进行独立控制。采用该算法优化常规PID控制参数,能够实现控制参数的快速寻优。该方案应用于循环流化床锅炉燃烧系统仿真,结果表明能有效实现系统解耦,且具有响应快、超调量小等优点,有效地提高了控制品质。     

基于AHP权重和灰色服务器负载预测的云计算On-line迁移策略

为了克服云计算环境下由于实时用户任务的不确定性到来和服务器性能差异而导致的云计算环境的负载不均衡问题,提出了一种AHP权重获取和灰度算法预测服务器负载的云计算on-line虚拟机迁移策略。首先,设计了基于AHP和灰色服务器预测的虚拟机on-line迁移模型,提出了采用AHP获取虚拟机各资源需求权重,然后,采用灰色模型预测下一时刻的服务器负载,采用此权值向量与各无需迁移的服务器的空闲资源向量进行加权得到加权和,将具有最小加权和的物理服务器作为迁移的目标宿主机。最后,定义了基于AHP权重和灰色服务器负载预测的云计算on-line迁移算法。在CloudSim环境下进行实验,结果表明文中的迁移策略使得云计算在响应用户任务时,具有任务失败次数少、SLA违约率低和迁移成功率高的优点,同时与其它方法相比,具有负载均衡程度高的优点,具有较强的可行性。     

中温热解焦油重馏分悬浮床加氢裂化的研究

以中温热解煤焦油为原料,对其性质进行了分析,其中,350℃重质馏分中胶质含量30.88%,沥青质含量37.27%,四氢呋喃不溶物3.36%,属于常规固定床加氢裂化难以直接处理的馏分。合成了一种Mo系超分散催化剂,采用FT-IR、XPS、XRD、SEM和TEM等对催化剂进行了表征,催化剂中含有Mo=O和Mo-S特征结构,活性金属的硫化率为84.34%,在体系中具有优良的分散性,在反应体系内原位分解为超分散MoS_2颗粒;在0.25 t/d连续装置上进行了热解重油悬浮床加氢裂化实验研究,考察了反应条件对产物分布情况和结焦率的影响,得出适宜的反应条件为19 MPa,440℃,催化剂的添加量为300 mg/kg;此条件下石脑油收率24.47%,柴油馏分收率49.71%,结焦率1.32%。     

大气环境下的钢筋混凝土桥梁时变可靠度分析

为了探究钢筋混凝土桥梁抗力退化对桥梁可靠性能的影响,综合考虑一般大气环境下混凝土强度、钢筋强度、混凝土与钢筋黏结性能的降低,建立普通钢筋混凝土桥梁的抗力退化时变模型,分析规范车辆荷载作用的桥梁时变可靠度。研究结果表明,(1)一般大气环境下,桥梁抗力随着服役时间的增加而减小,其中钢筋强度退化对桥梁抗力的影响最大,其次是钢筋与混凝土黏结性能降低,而混凝土强度退化对桥梁抗力的影响相对较小; (2)桥梁可靠指标随着服役时间的增加而减小,密集行车占比越大,桥梁承载能力失效的概率就越大;非平稳车载作用下的桥梁可靠指标小于平稳车载,桥梁需要维修补强的时间比平稳车载提前; (3)多梁式简支梁桥在建造时应该提高边梁的安全储备,在管养时可以采取限载措施进行干预。     

Effect of Gaussian size distribution width on minimum fluidization velocity in tapered gas–solid fluidized beds

This paper investigated the effect of Gaussian distribution width, average particle diameter, particle loading, and the tapered angle on minimum fluidization velocity (U_mf) by conducting extensive experiments in tapered fluidized beds. Three powders with Gaussian size distribution and different distribution widths were used in the experiments. An increase in U_mf with increasing the average particle diameter, particle loading, and the tapered angle was observed. There was also a nonmonotonic behavior of U_mf as the Gaussian distribution width increased. An empirical correlation including dimensionless groups for predicting U_mf in tapered beds was developed in which the effect of distribution width was considered. The proposed correlation predictions were in good agreement with the experimental data, with a maximum deviation of 16.5% and average and standard deviations of, respectively, 6.4% and 7.4%. The proposed correlation was also compared with three earlier models, and their accuracy was discussed.     

Experimental investigation on the distribution uniformity and pressure drop of perforated plate distributors for the innovative spray-type packed bed thermal storage

As an innovative thermal energy technology, the spray-type packed bed has advantages of high efficiency and low cost. A liquid distributor is the key component for the spray-type packed bed for scattering heat-transfer liquid drops evenly. In this study, the distribution performance and pressure drop of the perforated plate distributors of different orifice diameters were studied experimentally. The experimental results indicate that orifice diameter has a greater effect on the distribution performance compared to flow rate. With an increase in flow rate, the flow pattern through the distributor changes from the uncovered drop to the covered drop and then to the jet flow. The covered drop pattern shows the best performance with a good distribution and a small pressure drop simultaneously, which is the design and optimization principle of the distributor for a spray-type packed bed.