表面含磷酸的介孔分子筛P-SBA-15的合成及其性能评价

采用后合成法，将磷酸固载在纯硅介孔分子筛SBA-15表面上。利用X射线衍射（XRD）、红外光谱（IR）、氮气吸附 脱咐法（BET）分析方法表征催化剂的物理性能。结果表明，催化剂P-SBA-15在高温焙烧后保持了稳定的介孔分子筛SBA-15结构，该催化剂的比表面积和孔径分别为605.45m2/g和5.576nm（磷硅摩尔比5%）。选用十一碳烯酸与异丙醇的酯化反应对催化剂P-SBA-15的催化反应性能进行评价，同时与其他几种微孔沸石分子筛催化剂催化性能相比表明，磷酸改性的介孔分子筛P SBA 15是合成十一烯酸异丙酯较为理想的固体酸催化剂，考察了催化剂的稳定性。     

明胶中α组分含量对明胶/羟基磷灰石复合材料力学性能的影响

选用α组分含量分别为20.5%,41%和50%的A、B、C 3种明胶作为原料,采用同时加入法制备了明胶/羟基磷灰石(HAP)复合材料.通过对干态复合物膜拉伸性能的测试和对比,发现,明胶α组分含量的变化对复合材料的弹性模量影响较大,而对拉伸强度和断裂伸长率的影响则相对较小,但总的来说,三者均随α组分含量的增加而增大.其中,α组分含量最高的复合物C的拉伸强度为86.40 MPa,弹性模量为2682.35 MPa,断裂伸长率为8.65%.另外,对复合物C基本性质的表征结果表明,该材料具有类似于自然骨的组成和结构性质,因此有望成为一种具有优异力学性能的骨替代材料.     

Effect of Enzyme Modification of Corn Grits on their Properties as an Adsorbent in a Skarstrom Pressure Swing Cycle Dryer

Corn grits have been tested as a desiccant in a pressure swing adsorption (PSA) system to produce dry air. Two sizes of unmodified corn grits were tested in the PSA system: 2.16 and 0.978 mm in diameter, which dried moist air to dew points of –42°C and –69°C, respectively. A modification technology has been developed for the corn grits that gives an increase in the operational adsorptive capacity in a pressure swing adsorption system, so that they remove as much moisture from air as molecular sieves at the same conditions. After modification, 2.16 mm corn grits dry moist air to a –56°C dew point and the 0.978 mm corn grits dry air to a –80°C dew point. The modification process creates surface modifications on the corn grits apparently making more adsorption sites easily available. The modification procedure increases the specific surface area of the grits and possibly decreases the crystallinity, which would make more hydroxyl groups available for adsorption of water. Possible applications of using corn grits in the pressure swing adsorption system include industrial gas dryers, sorptive cooling air conditioners, and recycling equipment for industrial solvents.     

Preparation and characterization of aliphatic/aromatic copolyesters based on 1,4-cyclohexanedicarboxylic acid

A series of biodegradable aliphatic/aromatic copolyesters, poly(butylene terephthalate)-co-poly(butylene cyclohexanedicarboxylate)-b-poly(ethylene glycol) (PTCG), were prepared by a two-step melt polycondensation method and characterized by means of GPC, FTIR, NMR, DSC, TGA, etc. The effects of aliphatic ester content on the physical, mechanical and thermal properties, as well as in vitro and in vivo degradation behaviors were investigated. The decrease in mechanical strength was observed with an increase in poly(butylene cyclohexanedicarboxylate) (PBC) molar fraction. DSC results showed one melting point and two glass transition temperatures in all samples, and the melting temperature was found to go down gradually as more cyclohexanedicarboxylic acid (CHDA) was added. During the in vitro and in vivo degradation processes, erosion of the surface was dominant as evidenced by scanning electron microscopic observations. The copolyesters containing many CHDA units were featured by the higher water uptake and faster degradation due to much richer amorphous phase within them.     

CdS/SiO2复合材料的低频Raman散射研究

对用溶胶凝胶法制备的ＣｄＳ／ＳｉＯ２复合材料进行低频Ｒａｍａｎ散射研究，结果表明可从其低频Ｒａｍａｎ散射峰位计算出ＣｄＳ微晶的粒径，两种不同的低频振动模式由激发光的两种偏振方向加以区分，低频Ｒａｍａｎ散射射的二级散射峰根据实验结果加以指认，所得平均粒径结果与透射电镜观察结果有较好的对应关系，复合材料吸收光谱吸收边蓝移与ＣｄＳ纳米子粒径之间存在着密切的关系，实验证明，样品吸收边能量与ＣｄＳ平均粒径的     

Scattering spectra and colour of disperse systems of low-absorptive particles

In this article, the results of calculations of scattering spectra of low-absorptive spherical particles are presented. It was obtained using different approximate and numerical methods. The comparative evaluations of application of single scattering approximation, the average field approximation and of the methods of computer modeling on the basis of Monte-Carlo method on various scattering multiplicity were performed. The comparison demonstrates the good agreement of calculated results with experimental scattering spectra of eye lens. By using the obtained spectral data the colour coordinates are calculated. The regularities of changes in colour characteristics in dependence of disperse system parameters are analyzed.     

纤维素/甲壳素共混膜的结构表征与抗凝血性能

以 6wt %NaOH 4wt%尿素为纤维素的新溶剂 ,采用溶液共混法制备出纤维素 甲壳素共混膜 ,为甲壳素在碱性溶液中制膜提供了新的方法 .红外光谱、X 射线衍射、扫描电镜和力学性能、抗凝血性能测试结果表明 ,共混膜中甲壳素含量低于 4 0wt%时 ,纤维素与甲壳素分子间具有良好的相容性 ;在纤维素中引入适量甲壳素可提高共混膜的抗张强度 ,共混膜的干、湿态抗张强度在甲壳素含量 10wt%时最大 ,其值分别为 89 1MPa和 4 3 7MPa ,比纯态纤维素膜的干、湿态抗张强度分别提高了 6 7%和 11 5 % ;甲壳素的引入可明显降低血小板在共混膜表面的粘附、凝聚与变性 ,增大共混膜的抗凝血参数 ,甲壳素含量达到 5 0wt%时 ,该共混膜具有良好的抗凝血性能     

STUDIES ON TUNG OIL COATED REGENERATED CELLULOSE FILMS WITH WATERRESISTANCE

Regenerated cellulose films with water-resistance were obtained by an improved method ofpreparing cellulose cuoxam solution from pulps of agricultural wastes (linters, wheat straw, reedand Bamao). Experimental results showed that the mechanical properties of both the dry. and wetfilms were excellent. Data from IR, SEM and tensile strength measurements implied that thesignificant improvement of water-resistance of the films was due to the cohesion between the thinTung oil covers with hydrophobicity and the regenerated cellulose films. The films werecompletely biodegraded after being buried in soil for 100 days. The transmittance of the filmsderived from linter and reed in visible band range were 80-90%.     

EFFECT OF CRYSTALLIZATION TEMPERATURE ON MCM-41 SYNTHESIS

在Ｎａ２ＯＳｉＯ２ＣＴＡＢＨ２Ｏ四元水热体系中系统地考察了晶化温度对中孔ＭＣＭ４１分子筛合成及其骨架结构的影响。实验结果表明，提高晶化温度虽然能明显加快晶化速率，缩短晶化时间，但同时样品的结晶度和中孔骨架结构的有序度却被迅速破坏。这些特点与传统沸石的合成过程完全不同，其原因主要是合成ＭＣＭ４ｌ时所用的模板剂及其在合成中所起的模板作用与传统沸石完全不同。相对低的晶化温度（如１００℃）有利于高质量和高热稳定性的中孔ＭＣＭ４ｌ分子筛的合成。     

Thermal characterization and thermal degradation of poly(norbornene-2,3-dicarboxylic acid dialkyl esters) synthesized by vinyl addition polymerization

The thermal properties and degradation behaviors of poly(norbornene-2,3-dicarboxylic acid dialkyl esters) (PNB-dialkyl esters) (alkyl = Me (PNB-Me), Et (PNB-Et), Pr (PNB-Pr), and Bu (PNB-Bu)) were investigated by thermogravimetric analysis (TGA) in dynamic conditions and by infrared (IR) spectroscopy. The PNB-dialkyl esters show good thermal stability up to 350 °C, and the thermal stability decreases in the order Me > Et > Pr > Bu with the increase in size of side chain. The effect of side-chain size on the thermal degradation behaviors of PNB-dialkyl esters is evidenced by one-step thermal degradation profile for PNB-Me while two-step thermal degradation profile for PNB-Et, PNB-Pr, and PNB-Bu. Transformation is deduced to undergo β-hydrogen elimination and formation of anhydride group in the first stage of thermal degradation reaction according to TGA and IR results for PNB-Et, PNB-Pr, and PNB-Bu. The apparent activation energy and thermal degradation model of PNB-dialkyl esters are estimated by means of Ozawa-Flynn-wall method and Phadnis-Deshpande method, respectively.