7,8-二氢-6,6-二甲基-7,8-环氧-6氢-吡喃[2,3-f]苯并-2,1,3-噁二唑的合成

本文给出了一条较好的制备7,8-二氢-6,6-二甲基-7,8环氧-6氢-吡喃[2,3-f]苯并-2,1,3-噁二唑的合成路线,即由对乙酰氨基苯酚经酯化、Fries重排、环合、还原、脱水、硝化、脱酰基、氧化、脱氧和催化环氧化等反应制得标题化合物,其结构经元素分析和光谱数据确证。     

负载型催化剂制备的聚丙烯等规度分布

负载型Ziesler－Natta催化剂中存在许多活性中心［'3，为了解其本质，需对其各自产生的聚合物进行分离，以往采用的溶剂抽提法［'－'j只能将聚合物大致分级．最近，升温淋洗分级法（TREF）已被运用于聚丙烯的分级卜，'，其原理是根据聚合物的结晶度分级D'，影响聚丙烯结晶性的主要因素是等规度，而分子量到达一定程度后其影响较小，故通过TREF分级可得到聚丙烯的等规度分布．TREF法的淋洗温度可控，故分级效果较好．该法在分级前需对样品进行等温结晶处理，以消除抽提法由于样品未必充分结晶而带来的误差．本文用TREF法对不同催化…     

聚合温度对聚甲基丙烯酸三丁基锡酯等规度的影响(Ⅰ)

本文测定了0—130℃温度范围内,由~(60)Co-γ射线和两种活性不同的引发剂引发聚合的聚甲基丙烯酸三丁基锡酯的等规度。利用~(13)C-NMR测定聚合物分子链的等规度,如预料的那样,以间同立构为主,并随着聚合温度的升高间同立构等规度降低。作者认为影响聚合物等规度的因素主要是取代基的极性效应。计算出的控制等规度的活化能参数与聚甲基丙烯酸甲酯和聚甲基丙烯酸三甲基锡酯的属同一数量级,可相互比较。     

旋流煤粉燃烧的一维综合数值模拟

发展了综合考虑气－固两相旋流流动，气相燃烧，颗粒相变与燃烧及两相辐射传热的旋流煤粉燃烧－维数学模型，给出了气－固两相能量方程中颗粒相就源项的计算表达式，应用这一模型对涡旋燃烧炉环形通道内多组工况的旋流气体燃烧和煤粉燃烧进行了数值模拟，计算得到的炉内温度分布和燃烧效率与实验数据基本相符，表明本文建立的模型可用于旋流煤粉燃烧的一维综合数值模拟。     

带有可调通道的嵌段共聚物胶束对药物的控制释放

用聚丙烯酸叔丁酯-b-聚乙二醇(PtBA45-b-PEG114)和聚丙烯酸叔丁酯-b-聚4-乙烯基吡啶(PtBA60-b-P4VP80)制备了复合胶束. 该胶束在pH=2.5的酸性水溶液中形成以PtBA为核, PEG和P4VP为壳的稳定球型结构. 在pH=12时, 壳层的P4VP链段变为疏水, 塌缩在PtBA的核上形成内壳, PEG链段继续保持溶解状态, 与成核的PtBA连接并穿过塌陷的P4VP内壳, 形成胶束的冠, 由于PEG处于溶解状态, 其分子链间有比较大的空隙, 可以控制一些小分子通过, 在胶束的表面形成通道. 该通道类似于生物膜的蛋白通道, 可以控制PtBA核与外界进行能量或物质交换的速度. 以布洛芬为模型分子, 负载在胶束内进行药物控制释放研究的结果表明, 胶束表面的通道可以起到明显控制布洛芬释放速度的作用, 并且药物的释放速度与通道在胶束表面的比例成正比.     

纳米Y2O3/钴基合金激光熔覆层的组织

利用5 kW CO2激光器,在Ni基高温合金表面,熔覆纳米稀土氧化物(Y2O3)/钴基合金复合材料,制备了涂层.利用光学显微镜、扫描电镜及透射电镜分析了熔覆层的组织结构.结果表明: 熔覆层的主要相组成为γ-Co,ε-Co,Cr23C6和Y2O3;加入纳米Y2O3,凝固组织由细长的柱状树枝晶转变为较短的树枝晶;纳米Y2O3含量增大至1%时整个断面获得等轴晶组织;纳米Y2O3作为异质形核的核心,细化了组织;纳米Y2O3在熔覆层中分布不均匀,促进了γ-Co向ε-Co的转变;熔覆层的亚结构为堆跺层错.对熔覆层等轴组织形成机制进行了分析.     

TEXTURE AND CRYSTALLINITY EVOLUTION IN ISOTACTIC POLYPROPYLENE INDUCED BY ROLLING AND THEIR INFLUENCE ON MECHANICAL PROPERTIES

The orientation and crystallinity evolution of isotactic polypropylene （iPP） induced by rolling were studied using wide angle X-ray scattering with an area detector. The tensile mechanical properties of rolled isotactic polypropylene sheets were also measured in this work. The texture component method was used to analyze the rolling texture. The rolling texture consists mainly of （010）[001], （130）[001] and [001]//RD fiber components in the sample with a rolling true strain of 1.5. The results reveal that crystallinity drastically decreases during rolling. It is suggested that amorphization is a deformation mechanism which takes place as an alternative to crystallographic intralamellar slip depending on the orientation of the lamellae. Both the orientation and crystallinity affect the tensile mechanical properties of rolled polypropylene. Crystallinity influences the elastic modulus on both directions and yield strength on transverse direction at the first stage of deformation. Orientation is the main reason for the changes of mechanical properties, especially at the latter part of deformation. The changes of both tensile strength and elongation percentage on rolling direction are larger than those on transverse direction, which results from the orientation. At last, the anisotropic mechanical properties occur on the rolling and transverse direction： high tensile strength with low elongation percentage on rolling direction and low tensile strength with high elongation percentage on transverse direction.     

298.15K下Li2B4O7-H2O体系水蒸汽分压及渗透系数的等压测定和离子相互作用模型

在已有研究含硼体系的文献中仅考虑了硼酸根B4O7^-2或B(OH)4^-和H3BO3的存在，而对Li2B4O7-H2O体系具有多种硼物种聚合平衡体系的热力学性质的研究尚未见报道．本文用等压法研究了Li2B4O7-H2O体系于298．15K下浓度由稀到过饱和溶液的平衡气相蒸汽压及渗透系数．考虑了水溶液中多种硼物种的存在，以Pitzer方程为基础，建立了可描述该含硼体系的离子相互作用模型。     

邻位吡啶自由基多通道分解反应的动力学和反应机理研究

Utilizing Gaussian94 program package, all species involved in decomposition reactions of o-pyridyl radical were optimized fully at B3LYP/6-311＋＋G^＊＊ level. Intrinsic reaction coordinate calculations were employed to confirm the connections of the transition states and products, and transition states were ascertained by the number of imaginary frequency （0 or 1）. The reaction mechanism was elucidated by the vibrational mode analysis and electronic population analysis, and the reaction rate constants were calculated with transition state theory.     

HPLC-ICP-MS在紫菜中砷形态分析的应用

通过HPLC－ICP－MS联用技术初步探讨了紫菜中砷的形态；选用了纯水萃取，再用甲醇稀释，用阴离子交换色谱柱经HPLC分离，再用ICP－MS测定，实验发现了2个未知形态色谱峰；该技术将液相色谱的分离技术与ICP－MS高灵敏度的检测方式相结合，具有分离效果好，灵敏度高，耗样量少，速度快，线性范围宽等优点。