全文获取类型
收费全文 | 564篇 |
免费 | 197篇 |
国内免费 | 93篇 |
专业分类
化学 | 367篇 |
晶体学 | 53篇 |
力学 | 4篇 |
综合类 | 15篇 |
数学 | 2篇 |
物理学 | 413篇 |
出版年
2024年 | 3篇 |
2023年 | 6篇 |
2022年 | 13篇 |
2021年 | 32篇 |
2020年 | 30篇 |
2019年 | 14篇 |
2018年 | 29篇 |
2017年 | 45篇 |
2016年 | 51篇 |
2015年 | 28篇 |
2014年 | 44篇 |
2013年 | 61篇 |
2012年 | 58篇 |
2011年 | 67篇 |
2010年 | 44篇 |
2009年 | 37篇 |
2008年 | 41篇 |
2007年 | 40篇 |
2006年 | 34篇 |
2005年 | 31篇 |
2004年 | 26篇 |
2003年 | 9篇 |
2002年 | 29篇 |
2001年 | 10篇 |
2000年 | 8篇 |
1999年 | 5篇 |
1998年 | 3篇 |
1997年 | 2篇 |
1996年 | 13篇 |
1995年 | 4篇 |
1994年 | 7篇 |
1993年 | 7篇 |
1992年 | 9篇 |
1991年 | 2篇 |
1990年 | 2篇 |
1989年 | 4篇 |
1988年 | 2篇 |
1985年 | 1篇 |
1983年 | 1篇 |
1982年 | 1篇 |
1981年 | 1篇 |
排序方式: 共有854条查询结果,搜索用时 15 毫秒
81.
在活性炭还原气氛下高温固相法合成了Ba3(PO4)2:Ce3+,Dy3+紫外发射荧光粉。XRD图谱表明,烧结温度为1100℃时保温处理3 h,样品为单相的Ba3(PO4)2型六方晶系结构。荧光光谱显示:单掺Ce3+样品中,Ce3+掺杂浓度为8%(摩尔分数)时样品的发光最强,发射峰的位置处在350 nm附近(Ce3+的2D→2F5/2和2D→2F7/2跃迁发射)。适量的Sr2+取代部分Ba2+离子,改变了基质晶格环境,使样品的发光强度得到提高且发射峰向长波方向红移。引入Dy3+作为敏化剂,样品发射峰红移到386 nm,亮度增强,主要是由于Dy3+和Ce3+之间发生了有效的能量传递过程。确定了Dy3+的最佳掺杂浓度为3%,发光强度提高了27%。 相似文献
82.
高效液相色谱-串联质谱法同时测定食品中五种黄色化工染料 总被引:5,自引:0,他引:5
采用高效液相色谱-串联质谱法(HPLC-MS/MS)建立了食品中非法添加的碱性橙、碱性嫩黄、酸性橙I、酸性橙II和酸性黄36这5种黄色工业染料的定量定性分析方法。使用Agilent ODS C18分离柱(50 mm×2.0 mm, 1.8 μm),以5 mmol/L乙酸铵水溶液(0.1%甲酸)-乙腈(3:2, v/v)为流动相,流速为0.3 mL/min。采用电喷雾离子化源,以多反应监测(MRM)方式分别在正、负离子模式下进行检测。在最佳检测条件下,得到了较宽的线性范围和较低的定量检出限。碱性橙和碱性嫩黄的线性范围均为5.0~80.0 mg/L;酸性橙I、酸性橙II及酸性黄36的线性范围均为10.0~160.0 μg/L。食品中碱性橙、碱性嫩黄、酸性橙I、酸性橙II及酸性黄36的定量限分别为20、20、40、40、40 ng/g。该方法重现性较好,保留时间和峰面积的相对标准偏差分别不大于0.50%和2.14%。本研究还测定了鸡肉、豆制品和黄鱼中添加的5种化工染料,回收率在79.8%~95.2%之间,结果令人满意。 相似文献
83.
84.
Javed Iqbal Feroza Hamid Wattoo Muhammad Hamid Sarwar Wattoo Rukhsana Malik Syed Ahmad Tirmizi Muhammad Imran Allah Bux Ghangro 《Arabian Journal of Chemistry》2011,4(4):389-395
Chitosan flakes, extracted from prawns and labeo rohita scales, with high adsorption capacity were prepared after chemical treatment and were used to remove acid yellow dye from water. The results showed that adsorption capacity is dependent on pH, initial concentration of dye, BET, Langmuir surface area and pore volume of the adsorbent. In acidic conditions, the polymer amino groups were protonated (positively charged polymer chain), which showed attraction with negative ions of anionic dye. Chitosan from prawns scales showed higher dye adsorption under the same experimental conditions. Adsorption isotherms were developed and equilibrium data fitted well to Langmuir and Freundlich isotherm models. 相似文献
85.
Elbert van der Klift Alexandre Villela Goverdina C. H. Derksen Peter P. Lankhorst Teris A. van Beek 《Molecules (Basel, Switzerland)》2021,26(13)
Detailed knowledge on natural dyes is important for agronomy and quality control as well as the fastness, stability, and analysis of dyed textiles. Weld (Reseda luteola L.), which is a source of flavone-based yellow dye, is the focus of this study. One aim was to reduce the required amount of dyed textile to ≤50 μg for a successful chromatographic analysis. The second aim was to unambiguously confirm the identity of all weld flavones. By carrying out the extraction of 50 μg dyed wool with 25 μL of solvent and analysis by reversed-phase UHPLC at 345 nm, reproducible chromatographic fingerprints could be obtained with good signal to noise ratios. Ten baseline separated peaks with relative areas ≥1% were separated in 6 min. Through repeated polyamide column chromatography and prepHPLC, the compounds corresponding with the fingerprint peaks were purified from dried weld. Each was unequivocally identified, including the position and configuration of attached sugars, by means of 1D and 2D NMR and high-resolution MS. Apigenin-4′-O-glucoside and luteolin-4′-O-glucoside were additionally identified as two trace flavones co-eluting with other flavone glucosides, the former for the first time in weld. The microextraction might be extended to other used dye plants, thus reducing the required amount of precious historical textiles. 相似文献
86.
The present paper reports that TL glow curve and kinetic parameter of Eu3+ doped SrY2O4 phosphor irradiated by beta source. Sample was prepared by solid state preparation method. Sample was characterized by XRD analysis and particle size was calculated by Debye–Scherrer formula. The sample was irradiated with Sr-90 beta source giving a dose of 10 Gy and the heating rate used for TL measurements are 6.7 °C/s. The samples display good TL peaks at 106 °C, 225 °C and 382 °C. The corresponding kinetic parameters are calculated. The photoluminescence excitation spectrum at 247 and 364 nm monitored with 400 nm excitation and the corresponding emission peaks at 590, 612 and 624 nm are reported. 相似文献
87.
目前粉末ACEL器件有三类:玻璃屏、塑料软屏和搪瓷屏.目前商品化的电致发光材料,每炉料大约在100~200克之间,粒度在10μm左右,不能满足产业化的需求.影响发光材料亮度、寿命、粒度的主要因素有Cu的浓度、灼烧时间、退火方式和灼烧气氛[1,2,3]... 相似文献
88.
V. P. Grankin N. D. Grankina Yu. V. Klimov V. V. Styrov 《Journal of Applied Spectroscopy》1995,62(3):578-581
Priazovskii State Technical University, Pereulok Respubliki 7, Mariupol 341000, Ukraine. Translated from Zhurnal Prikladnoi
Spektroskopii, Vol. 62, No. 3, pp. 210–214, May–June, 1995. 相似文献
89.
90.
The photo (PL) and electro (EL) luminescence in ZnS: MnLa and ZnS: La have been studied. The enhancement and quenching of
emission bands have been observed on the simultaneous application of sinusoidal field and photons. The wave shape, voltage,
frequency and temperature dependence of EL brightness have been reported. A study of the phosphorescence and thermoluminescence
of these phosphors is also carried out and it is observed that the trap-depth changes slowly with temperature and activator
concentration. An attempt has been made to calculate the trap depth by studying temperature dependence of EL brightness. The
results are reported and discussed. 相似文献