PVK∶DBVP掺杂体系的能量转移及发光性质的研究

研究了不同比例的PVK与齐聚PPV衍生物DBVP掺杂体系的能量转移和发光特性.通过对PVK,DBVP及PVK:DBVP掺杂体系的UV-vis,PL和PLE光谱的研究,分析了PVK与DBVP之间的能量转移过程.利用PVK在体系中类似于溶剂的分散作用,制备了结构为ITO/PEDOT/PVK:DBVP/LiF/Al的电致发光器件,研究了掺杂体系的电致发光性能.结果表明,在掺杂体系的光致发光和电致发光中,PVK的发射被有效地抑制,PVK与DBVP之间发生了非常有效的能量转移,通过调节PVK与DBVP的比例,可以获得蓝色和绿色发光,同时可以改善器件的发光性能,当PVK与DBVP的重量比为1∶2时,器件的绿色发光效率达到1·06cd/A,此时发光亮度为52cd/m2.     

光学低通滤波器的光学传递函数分析

光电成像系统的抽样过程会引起图像频谱在频谱空间上的多次复制,如果抽样过程不满足系统的奈奎斯特条件,相邻的频谱项就会产生混叠.光学传递函数可以反映系统中光学成像,抽样和重建等各个过程对图像信号频谱的响应.通过对使用光学低通滤波器(OLPF)光电成像系统的光学传递函数的分析,表明光学低通滤波器可以有效地限制图像的频谱宽度,使抽样满足奈奎斯特条件,达到消除频谱混叠,改善重建图像质量的目的.     

催化剂薄层内甲烷水蒸气重整反应强化管内对流换热的数值模拟

本文以竖直圆管内壁催化剂薄层内发生甲烷水蒸气重整反应强化对流换热作为研究对象,对其进行了数值模拟．结果发现,催化剂薄层内的吸热化学反应可以有效地强化对流换热,降低流体和壁面温度,从而对壁面起到保护作用;极限热流密度的大小与流体的入口温度有关,存在最佳入口温度使极限热流密度最大．     

微光像增强器图像传递信噪比的测试研究

图像传递信噪比是微光像增强器的重要特性参数．能够全面定量地表征像增强器在探测弱辐射图像时的综合性能，对于确定像增强器的图像探测灵敏闽具有重要意义。针对其测试原理．采用高灵敏度低噪声CCD器件作为像管输出图像的探测接收器．并引入数字图像处理技术。利用设计的测试系统实现了典型目标图像传递信噪比的自动测试．多次实验结果表明．陔测试系统具有测试过程自动快速及测试数据准确稳定的优点．相同测试条件下的不确定度优于±3%。     

Preparation of rhodium–phyllosilicate catalysts without leaching in liquid-phase 1-hexene hydrogenation

Rhodium catalysts have been prepared on palygorskite and montmorillonite (clay) supports by reduction with hydrogen (1 atmosphere) at room temperature of a cationic organometallic rhodium compound anchored to the support. The activity of these catalysts for the hydrogenation of liquid-phase 1-hexene remains constant with increase of prehydrogenation time and with re-use for several runs. No rhodium leaching is observed.     

Numerical simulation of thermally and chemically nonequilibrium flows and heat transfer in underexpanded induction plasmatron jets

The results of numerical simulation are presented for thermally and chemically nonequilibrium air plasma flows in a plasmatron discharge channel and underexpanded dissociated and partially ionized air jets flowing past a cylindrical model with a blunt leading edge and cooled copper surface under the experimental conditions realized in a VGU-4 100 kW induction plasmatron (Institute for Problems in Mechanics of the Russian Academy of Sciences) (see, for example, [1, 2]). The nonequilibrium excitation of the vibrational degrees of freedom of the molecules in the modal approximation and the difference between the electron and translational heavy-particle temperatures are taken into account in the calculations. The calculated data on the heat transfer and pressure at the stagnation point are compared with the results obtained within the framework of the thermally equilibrium model. Comparison with the experimental data obtained in the Institute for Problem in Mechanics of the Russian Academy of Sciences (Laboratory for interaction between plasma and radiation and materials) and kindly provided for comparison purposes gives satisfactory agreement.     

A novel tridentate nitrogen donor as ligand in copper catalyzed ATRP of methyl methacrylate

A tridentate ligand, BPIEP: 2,6‐bis[1‐(2,6‐diisopropyl phenylimino) ethyl] pyridine, having central pyridine unit and two peripheral imine coordination sites was effectively employed in controlled/“living” radical polymerization of MMA at 90°C in toluene as solvent, Cu^IBr as catalyst, and ethyl‐2‐bromoisobutyrate (EBiB) as initiator resulting in well‐defined polymers with polydispersities M_w/M_n ≤ 1.23. The rate of polymerization follows first‐order kinetics, k_app = 3.4 × 10^?5 s^?1, indicating the presence of low radical concentration ([P*] ≤ 10^?8) throughout the reaction. The polymerization rate attains a maximum at a ligand‐to‐metal ratio of 2:1 in toluene at 90°C. The solvent concentration (v/v, with respect to monomer) has a significant effect on the polymerization kinetics. The polymerization is faster in polar solvents like, diphenylether, and anisole, as compared to toluene. Increasing the monomer concentration in toluene resulted in a better control of polymerization. The molecular weights (M_n,SEC) increased linearly with conversion and were found to be higher than predicted molecular (M_n,Cal). However, the polydispersity remained narrow, i.e., ≤1.23. The initiator efficiency at lower monomer concentration approaches a value of 0.7 in 110 min as compared to 0.5 in 330 min at higher monomer concentration. The aging of the copper salt complexed with BPIEP had a beneficial effect and resulted in polymers with narrow polydispersitities and higher conversion. PMMA obtained at room temperature in toluene (33%, v/v) gave PDI of 1.22 (M_n = 8500) in 48 h whereas, at 50°C the PDI is 1.18 (M_n = 10,300), which is achieved in 23 h. The plot of lnk_app versus 1/T gave an apparent activation energy of polymerization as (ΔE^≠_app) 58.29 KJ/mol and enthalpy of equilibrium (ΔH⁰_eq) to 28.8 KJ/mol. Reverse ATRP of MMA was successfully performed using AIBN in bulk as well as solution. The controlled nature of the polymerization reaction was established through kinetic studies and chain extension experiments. © 2005 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 43: 4996–5008, 2005     

Förster energy transfer from poly(arylene–ethynylene)s to an erbium–porphyrin complex

We study the infrared emission at 1.54 μm of an organolanthanide complex, Er(III)-tetraphenylporphyrin [Er(TPP)acac], both as a result of direct optical excitation and via energy transfer from host π-conjugate polymers of type poly(arylene–ethynylene) [PAE]. In the first case, the emission of the neat complex is characterized in inert transparent materials and a value of the quantum yield at 1.54 μm φ_IR=4×10⁻⁴ is measured. Then, fluorescence resonance transfer is investigated in blends of Er(TPP)acac with PAEs by monitoring the quenching of the polymer fluorescence along with the enhancement of both the visible emission of the ligand and the near-infrared band of Er³⁺. These different procedures allow a detailed analysis of the transfer efficiency within a specific implementation of the Förster model for polymeric donors. The experimental values of the critical radius R₀, ranging from 1.3 to 2.5 nm for the different blends, are in good agreement with theory for a wide interval of the physical and spectroscopic parameters. This suggests that other mechanisms for excitation transfer do not play a significant role in these materials.     

辐射传递蒙特卡洛法精度分析及数值试验

本文建立了蒙特卡洛法模拟散射参与性介质内辐射传递计算模型。对蒙特卡洛法的计算精度及运行时间进行了较为详细的分析,提出了几种判断计算精度的方法。同时,借助蒙特卡洛法模拟辐射传递过程,进行数值“辐射实验”。利用该“实验结果”进行了物性反问题研究。在已知光学厚度的前提下,得到散射反照率与后半球辐射热流之间的单值函数关系。