正交相MoO3的制备、表征及其电化学嵌锂性质

用化学沉淀-水热法在较低的温度下制备了片状正交相MoO3,由XRD、FT-IR、XPS和SEM表征了产物的相态、结构、成分和形貌。电化学测试表明,在0.1mA.cm-2的电流密度和1.2~3.5V电压范围,其初始放电容量为663mA.h.g-1,有望成为理想的锂离子插层材料。     

熔融浸渍法制备锂离子电池正极材料LiMn2O4的研究

采用LiNO3和MnO2为原料,在650℃下制备了尖晶石型的LiMn2O4.通过X射线衍射、扫描电子显微镜、热重分析和电化学性能测试,发现该化合物具有很高的放电比容量和较好的循环性能,首次放电比容量可达到122 mA·h/g.并对循环性能衰减的各种因素进行了讨论.     

以PVA为分散介质制备纳米氧化铁颗粒及其ESR特征(英文)

利用金属离子在高分子配合物中独特的离子簇结构以及PVA对所制样品颗粒的良好保护和分散作用,通过配位转换的方法,在PVA介质中制备出超微氧化铁颗粒,并通过高温煅烧高分子金属氧化物复合体获得红褐色纳米氧化铁颗粒.XRD测试表明此氧化物为α Fe2O3和Fe3O4的混合物,粒径为40～65nm;样品的ESR结果表明该法制备的氧化铁颗粒具有较强的磁性.同时,还初步研究了PVA中氧浓度与Fe离子浓度的比及氨水浓度对产物粒径的影响.     

电化学超级电容器电极材料的研究进展

回顾了电化学超级电容器电极材料的研究进展，并对不同电极材料的储能原理和性能特点进行了简要的阐述。参考文献29篇。     

有序介孔材料SBA-15吸附Ru（bpy）3^2＋修饰电极的电化学发光研究

制备了具有高比表面积且二维六方高度有序的介孔分子筛SBA-15,并采用TEM和氮气吸附实验对其结构性质进行了表征.利用静电作用将三联吡啶钌[Ru(bpy)32 ]固定到表面带负电荷的SBA-15上,并将吸附有Ru(bpy)32 的SBA-15修饰到玻碳电极表面,研究了该固定化的Ru(bpy)32 的电化学发光行为.结果表明,随着三丙胺(TPA)的加入,氧化电流增加而还原电流减小,表明TPA对三价吡啶钌有催化作用,同时TPA的加入显著增强了发光强度.随着扫描速率的增加,发光强度逐渐降低.SBA-15较大的孔径和开放交联的孔结构体系促进了电极表面膜内的物质扩散和电子运动扩散.该修饰电极在5.0×10-5~1.0×10-2mol/LTPA浓度范围内,发光强度与浓度具有良好的线性关系,线性方程为y=71.7 41.2x,检出限为9.5×10-6mol/L.该电极在连续扫描下具有较好的稳定性.     

泡沫铅对VRLA电池负极活性物质结构及性能影响

0引言随着36V/42V汽车电源系统的提出,新一轮汽车用电池的竞争不断加剧。从目前情况看,铅酸电池由于具有成本低廉,使用可靠,原材料来源丰富,铅回收率可高达98%等优点,因此成为电动车电源最实际的选择之一[1]。但作为电动车用电池,需要克服其比能量低、充电接受能力差和负极硫酸盐化等缺点。为此各国科学家开展了大量的研究工作。最近报道用铸造多孔体作为敞口铅酸电池的集流体,它的比表面积为14cm2·cm-3,正极活性物质利用率上升到50%,远高于传统的铸造板栅[2]。在铅酸电池集流体研究领域里另一个重大进步,就是以R V C(R etic-ulated V i…     

ADVANCES IN STUDY OF A NEW CLASS OF PILLARED LAYERED MICROPOROUS MATERIALS?¤?¤POLYOXOMETALATE-TYPE HYDROTALCITE-LIKE CATALYSTS

In the present paper, on the basis of our work. advances in study of the catalysts of polyacid-type hydrotalcite-like are reported and reviewed. Using polyoxometalates (POM) as pillaring species and layered double hydroxides (LDH) as host matter, a new class of catalytic materials, LDHPOM, has been synthesized by five different methods. Their acidic and oxidative catalytic properties have been investigated by several research groups. The above mentioned information is given in this review.     

碱改性γ－Al_2O_3催化剂表面碱强度分布与COS水解活性的研究

用非水滴定法和Ｈａｍｍｅｔｔ系列指示剂测定了ＣＯＳ水解碱改性γ－Ａｌ_２Ｏ_３催化剂的表面碱强度分布．发现表面碱强度分布不均匀与表面能量分布不均匀相呼应．采用零点酸碱强度（Ｈ_（０，ｍａｘ））及碱中心区域分析法，Ｂｒｏｎｓｔｅｄ催化定律，进一步证实ＣＯＳ水解反应具有明显碱催化特征，较高活性催化剂的Ｈ_（０，ｍａｘ）一般为１０左右，对ＣＯＳ水解反应起主要作用的碱性中心的碱强度（Ｈ_０）为４．８≤Ｈ_０≤９．８．对碱金属氧化物改性后的γ－Ａｌ_２Ｏ_３催化剂，Ｂｒｏｎｓｔｅｄ规律在每个碱强度分区域内是适用的．     

Early-stage flocculation kinetics of polystyrene latex particles with polyelectrolytes studied in the standardized mixing: Contrast of excess and moderate polyelectrolyte dosage

Standardized mixing procedure was applied to the analysis of flocculation of polystyrene latex (PSL) particles with polyelectrolytes. After confirming the initial enhancement of flocculation rate in the very beginning followed by abrupt stop with excess dosage, attention was shifted to the system of moderate dosage. In the former, effects of ionic strength were further analyzed to find the consistency with adsorption isotherm. In the latter, flocculation started slowly in the beginning, sometime slower than salt-induced rapid coagulation, however, the rate gradually increases in the middle stage. Often, the increased rate exceeds that of salt-induced rapid coagulation. This behavior emerged more clearly in the case of lower ionic strength. This is the indication that the rate of relaxation of polymer on the colloidal surface is a function of surface coverage and ionic strength. The ultimate degree of flocculation is usually higher than that observed for excess dosage. The size distribution of flocs was also examined, however, no clear difference between different experimental conditions was confirmed for the same degree of flocculation.