基于积分方法的二维平行剪切层声远场预测

本文采用二维Ffowcs Williams＆Hawkings(FW-H)方程对平行剪切层远声场辐射特性进行了研究。近流场时间精确数据通过计算气动声学(Computational Aeroacoustics,CAA)技术数值模拟获得,声远场信息则通过FW-H方程对近流场内的可穿透积分面进行积分获得。该方法首先采用具有解析解的涡/尾缘干涉问题进行了校核,进一步采用CAA/FW-H匹配技术对二维平行剪切层声辐射问题进行了预测,计算结果表明,积分解与计算域内的CAA数值解吻合较好。     

胶束薄层色谱法测定食品及药用胶囊中的合成食用色素

在聚酰胶片上以13%SDBS(十二烷基苯磺酸钠)+7%Triton X-100〔聚乙二醇-对-(1.1,3,3-四甲基)丁基苯基醚〕+(2+3)氨水(1+5+1)为展开剂,用胶束薄层色谱法分离和测定了柠檬黄、亮蓝、苋菜红、胭脂红和赤藓红。测定波长分别为440、632、535、525和528 nm,线性范围分别为0.1～2、0.05～1、0.05～1、0.05～1和0.05～1μg/斑点。方法用于测定软饮料糖果及药用胶囊中的合成色素,获得了满意的结果。此外,还对展开剂的最佳组成进行了单纯形法优化。     

Asymptotic analysis and estimates of blow‐up time for the radial symmetric semilinear heat equation in the open‐spectrum case

We estimate the blow‐up time for the reaction diffusion equation u_t=Δu+ λf(u), for the radial symmetric case, where f is a positive, increasing and convex function growing fast enough at infinity. Here λ>λ^*, where λ^* is the ‘extremal’ (critical) value for λ, such that there exists an ‘extremal’ weak but not a classical steady‐state solution at λ=λ^* with ∥w(?, λ)∥_∞→∞ as 0<λ→λ^*?. Estimates of the blow‐up time are obtained by using comparison methods. Also an asymptotic analysis is applied when f(s)=e^s, for λ?λ^*?1, regarding the form of the solution during blow‐up and an asymptotic estimate of blow‐up time is obtained. Finally, some numerical results are also presented. Copyright © 2007 John Wiley & Sons, Ltd.     

Number albedo measurements from stratified layers of iron,concrete and aluminium

A layer of stratified combination composed of selected radiation shielding materials acquires better shielding property. Albedo is used in such measurements as an integral measure ofγ-ray scattering. The stratified slabs of alternating heterogeneous layers have been found to have a virtual homogeneous property with a definite effective atomic number. The angular distribution of back-scattered photons as well as the total number albedo values for iron, aluminium and concrete in stratified combination for 662 keV and 1250 keV photons are reported.     

Ge_x Si_(1-x)/Si超晶格中纵声学声子的喇曼散射强度研究

本文用光弹理论,在全面考虑了超晶格中两种材料的声速,质量密度和光弹常数存在差别的基础上,计算了Ge_xSi_(1-x)/Si超晶格中折迭纵声学声子的喇曼散射强度,在高达50cm~(-1)的频率范围内,理论值和实验符合得很好。     

Preparation and characterization of mesoporous silica thin films from polyethoxysiloxanes

Tetraethoxysilane (TEOS) and polyethoxysiloxanes (PEOSs; prepared by the acid‐catalyzed hydrolytic polycondensation of TEOS) were subjected to the sol–gel process in the presence of cetyltrimethylammonium bromide (CTAB), respectively. The PEOSs with M_w 700–26,000, as prepared by sol–gel coating of TEOS and PEOS under various conditions, were used. Uniform and crack‐free thin films of thickness 276–613 nm were prepared by spin‐coating of a PEOS solution containing CTAB. When the coating films were sintered at 400 °C, the combustion of ethoxy groups and CTAB took place to provide porous silica thin films. The structure of the thin films was found to be dependent on the molecular weight of PEOS and the molar ratio of CTAB/Si: lamellar or hexagonal phase was observed for M_w less than 15,000 and for CTAB/Si molar ratios greater than 0.10. Honeycomb structures were observed for M_w less than 5000 and for CTAB/Si molar ratios of 0.15. The honeycomb structure was also observed by atomic force microscopy and transmission electron microscope. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 2542–2550, 2006     

Influence of temperature-pressure treatment on heavily hydrogenated silicon surface

Microstructure and related properties of hydrogenated silicon samples, Si:H, treated at high-temperature (HT) up to 1270 K under hydrostatic argon pressure (HP) up to 1.1 GPa are investigated. To prepare Si:H, Czochralski grown 0 0 1 oriented single crystalline Si wafer with 50 nm thick surface SiO₂ layer was heavily implanted with hydrogen using the immersion plasma source of hydrogen ions with energy 24 keV.The surface of HT-HP treated Si:H was characterised by scanning electron microscopy. Reflectivity pattern measurements in the wavelength range of 350-2000 nm have been performed to analyse their surface and bulk properties. The volume averaging method for a model of layer-like structure has been used to simulate the HT-HP treated Si:H. The analysis of Si:H samples suggests the multi-layer structure composed of Si, Si:H, SiO, SiO₂, and of porous Si layers in the sub-surface region. The porous Si:H samples model is in good consistency with experimental data from reflectance measurements.     

A procedure for measuring the flexibility of single wood-pulp fibres

A way of determining the flexibility of wood-pulp fibres is developed, which involves i) a precise measurement of the topology of single-fibres by using a confocal laser scanning microscope and ii) the measurement of the elastic modulus of the fibres by using a single-fibre fatigue cell. Reported in this paper are the initial results of tests carried out on black spruce fibres, which have been subjected to three different levels of mechanical refining energy, namely ∼1100, 2300, and 3500 kWh/t. It is found that the fibre flexibility rises significantly between the first and second energy levels, but it does not change to the same degree between the second and third ones. The described procedure of measuring the flexibility of fibres may be used to establish the appropriate refiner energy necessary for the production of a specific grade of paper. Russian translation published in Mekhanika Kompozitnykh Materialov, Vol. 42, No. 1, pp. 115–128, January–February, 2006.     

半线性方程组边界层解的存在性

本文利用隐函数定理讨论了含小参数的半线性椭圆方程组边界层解的存在性．     

单层光学薄膜中薄膜－衬底体系的双重干涉效应及其应用

提出了单层光学薄膜中薄膜与衬底反射光之间的双重干涉效应的理论，实验结果证实了理论分析的正确性。双重干涉效应使薄膜－衬底体系的热致反射调制度高达８０％，这一效应可望有极广泛的应用