Experimental investigation of time-dependent cavitation in an oscillatory squeeze film

The occurrence of time-dependent cavitation and tensile stress in an oscillatory oil squeeze film were investigated experimentally. The test apparatus was a simple thrust bearing consisting of two parallel circular plates separated by a thin viscous oil film. During the test, one plate was at rest while the other (transparent) oscillated in a direction normal to its surface. This test configuration was chosen to avoid the rotational motion and complicated geometry of a squeeze film journal bearing. The frequency of oscillation was in the range of 5 to 50 Hz and was controlled by an electro-magnetic exciter. The process of cavity formation and its subsequent development was recorded by a high-speed video camera. Concomitant pressure in the oil film was measured both within and without the cavitation region. It was found that both tensile stress and cavities existed in a squeeze film under certain working conditions.     

蓝宝石R面上ZnO薄膜的NH3掺杂研究

以NH₃为掺杂源,利用金属有机化学气相沉积(MOCVD)系统在蓝宝石R面上生长出掺氮ZnO薄膜。通过XRD,SEM测量优化了其生长参数,在610℃和在80sccm的NH₃流量下生长出了〈1120〉单一取向的ZnO薄膜。经Hall电阻率测量,得知该薄膜呈现弱p型或高电阻率,并对其光电子能谱进行了研究。     

富勒烯(C_(60)/C_(70))与N,N,N′,N′-四-(对甲苯基)-4,4′-二胺1,1′-二苯硒醚(TPDASe)间光诱导电子转移过程的激光光解研究

富勒烯 (C60 /C70 )与N ,N ,N′ ,N′ 四 (对甲苯基 ) 4,4′ 二胺 1,1′ 二苯硒醚 (TPDASe)间在激光光诱导条件下 ,发生了分子间的电子转移过程 .在可见 -近红外区 ( 60 0～ 12 0 0nm) ,观测到了TPDASe阳离子自由基、富勒烯 (C60 /C70 )激发三线态和阴离子自由基 ,在苯腈溶液中 ,观测瞬态谱测定了电子从TPDASe转移到富勒烯 (C60 /C70 )激发三线态的量子转化产率(ΦTet)和电子转移常数 (Ket) .     

On the Application of the Auxiliary Problem Principle

The auxiliary problem principle (APP) derives from a general theory on decomposition-coordination methods establishing a comprehensive framework for both one-level and two-level methods. In this paper, the results of the two-level methods of APP are specialized for an efficient application to some engineering problems.     

Diffusion Structural Analysis Study of Titania Films Deposited by Sol-Gel Technique on Silica Glass

The diffusion structural analysis (DSA) was used to characterize microstructure changes of hydrous titania gel films under in situ conditions of heating. TG and DTA were used in order to elucidate the processes controlling the formation of anatase film during heating of hydrous titania gel film. The annealing of porosity and near surface structure defects of the dehydrated titania films was indicated by DSA in the temperature range 255–700°C as the decrease of radon release rate. It was demonstrated that the annealing was enhanced on heating in oxygen in comparison with heating in argon. The DSA experimental results were compared with model curves describing the radon diffusion mobility and the annealing of radon diffusion paths.     

基于CSCW的协同编著系统的设计

讨论了计算机支持的协同工作(CSCW)的主要技术，其中重点讨论了协同编著系统设计中的并发控制技术，指出了其与传统的并发控制技术的区别。根据CSCW的基本原理设计出了一个基于Browse／Server结构的协同编著系统的系统模型。该系统模型比传统的模型更加方便了用户之间通过Internet的浏览器进行协作。     

BEPCII直线加速器相控系统设计研究

为了补偿由于各种因素引起的微波相位漂移,BEPCII直线加速器需要建立微波相位反馈控制系统.能量最大法将用来确定每台功率源的最佳相位.沿直线加速器速调管长廊铺设相位稳定同轴线提供相位参考.现在已经完成了关键部件,如PAD单元、IfA 单元的开发.搭建了相控最小系统对系统进行了验证.     

温度对PSⅡCP4 7/D1/D2/Cytb559复合物荧光光谱特性的影响

采用激励光源为514.5 nm的分幅扫描单光子计数荧光光谱装置对经20℃、42℃和48℃不同温度处理后的反应中心复合物CP47/D₁/D₂/Cyt b559的荧光光谱特性进行了研究.经解析,获得不同温度处理后,CP47/D₁/D₂/Cyt b559复合物最大峰值未发生变化,均在682 nm,说明Chla670的能量都由Chla682接收,但损耗愈来愈小,在48℃时,损耗程度最小,而其荧光百分比未发生多大变化.振动副带～700 nm和～740 nm的中心波长都发生蓝移,在不同温度下分别为:20℃ 703 nm,749 nm;42℃ 697 nm,744 nm;48℃ 694 nm,740 nm.因此可以推测温度的升高,影响了CP47/D₁/D₂/Cyt b559色素蛋白的二级结构以及色素分子的空间位置,使最大峰值处的荧光强度逐渐降低,振动副带逐渐蓝移.42℃的温度已造成影响,48℃影响较大.