Probing the Catalytic Activity of Reduced Graphene Oxide Decorated with Au Nanoparticles Triggered by Visible Light

Hybrid materials in which reduced graphene oxide (rGO) is decorated with Au nanoparticles (rGO–Au NPs) were obtained by the in situ reduction of GO and AuCl₄^?_(aq) by ascorbic acid. On laser excitation, rGO could be oxidized as a result of the surface plasmon resonance (SPR) excitation in the Au NPs, which generates activated O₂ through the transfer of SPR‐excited hot electrons to O₂ molecules adsorbed from air. The SPR‐mediated catalytic oxidation of p‐aminothiophenol (PATP) to p,p′‐dimercaptoazobenzene (DMAB) was then employed as a model reaction to probe the effect of rGO as a support for Au NPs on their SPR‐mediated catalytic activities. The increased conversion of PATP to DMAB relative to individual Au NPs indicated that charge‐transfer processes from rGO to Au took place and contributed to improved SPR‐mediated activity. Since the transfer of electrons from Au to adsorbed O₂ molecules is the crucial step for PATP oxidation, in addition to the SPR‐excited hot electrons of Au NPs, the transfer of electrons from rGO to Au contributed to increasing the electron density of Au above the Fermi level and thus the Au‐to‐O₂ charge‐transfer process.     

介质的非均匀性对高次谐波影响的研究

讨论了气体介质的非均匀性对飞秒激光高次谐波产生过程的可能影响.计算结果表明,采用喷阀技术所提供的气体介质的密度梯度和气体原子运动速度的影响很小,不会产生实验上可观测的效果.这一结果支持了喷气靶在高次谐波产生中的广泛应用 关键词： 高次谐波 气体介质 各向异性 飞秒激光     

纳米累托石-TiO2光催化剂的制备及表征

以TiCl4和累托石为主要原料，制备出纳米累托石-TiO2粉末，并用X-衍射、透射电镜等对其进行表征．结果表明：纳米累托石-TiO2粉末平均直径为17．5nm当焙烧温度从500℃升至800℃时，累托石-TiO2粉末的比表面积从65．7m^2／g下降至3．3m^2／g，单位质量吸附剂的孔体积从0．1430cm。／u降到0．0213cm^3／g；当焙烧温度从300℃上升至500℃时，孔径变化不大，属中孔范围；当焙烧温度升至800℃时，一些孔道出现坍塌，不利于纳米累托石-TiO2粉末的光催化活性．     

Photocatalytic Synthesis of Oxygenates from Gaseous CO2 and CH4 over Semiconductor

Photoinduced synthesis of CO2 and CH4 was investigated using a batch reaction system on several photoactive materials supported on silicon dioxide. Single semiconductor showed higher selectivity to C1 compounds. The production of C2-C3 oxygenates took place preferentially on composite semiconductor photocatalysts. In particular, it was found that acetone was the primary product over Cu/CdS-TiO2/SiO2.     

Simulation of the instability of an accelerating gaseous envelope

The development of perturbations of the parameters of a dense gaseous envelope traveling with an acceleration driven by a difference in the pressures on either side is investigated numerically. Plane and axisymmetric time-dependent flows of a compressible medium are considered. The effect of both the density of the envelope and the form of the initial perturbations of its shape and motion on the mass cumulation in the compactions formed is studied. The evolutions of the perturbations of a layer and the surface of a contact discontinuity accelerated by an impinging plane shock wave are compared.     

TiO2 粉末催化剂光催化降解室内 空气中有机污染物

本文制备了一系列 TiO2粉末催化剂, 用光催化法降解室内空气中各种微量有机污染物,最终降解率 接近 100%. 考察了晶型对光催化剂性能的影响, 结果表明,锐钛矿型 TiO2 的催化性能最好. 最后,分析了 TiO2 光催化反应机理.     

二氧化钛光催化杀灭肿瘤细胞的研究

应用二氧化钛光催化的方法在体外对宫颈癌细胞进行了杀灭试验,结果显示,二氧化钛在光照下对宫颈癌细胞有明显的杀灭作用。当二氧化钛浓度为２００μｇ／ｍｌ,紫外光照时间为５０ｍｉｎ时,其杀灭肿瘤细胞的效果最好。     

空气中苯系物的TiO2光催化降解研究进展

本文对近年来空气中挥发性苯系物的TiO2光催化降解机理、TiO2光催化降解苯系物的主要影响因素以及TiO2的失活与再生方法等的研究进展进行了较详尽的评述,并对今后的研究工作进行了展望。     

CoOx改性TiO2光催化剂的制备、优化及其光催化分解水析氢性能研究

利用热分解法制备了不同掺杂量的CoO_x-TiO₂系列光催化剂, 并优化了制备方法。在用XRD、TEM和XPS等技术对催化剂表征的基础上，探讨了乙醇作为电子给体时CoO_x改性对P25-TiO₂光催化分解水析氢性能的影响。本文还利用连续瞬态电流-时间响应和循环伏安法等电化学方法，考察了CoO_x-TiO₂改性系列光催化剂光照条件下电流响应强度、起始光电响应特性差别及光催化析氢电位变化等光电化学性能。光催化性能实验结果表明，适当掺杂CoO_x(110～400 ℃焙烧时最佳掺杂量约为0.4wt% Co，500 ℃焙烧时最佳掺杂量约为0.6～0.8wt% Co)能够显著地提高TiO₂析氢光催化性能，产氢速率提高2个数量级。另外在适当温度下的热处理，能够改善催化剂光催化性能(最佳处理温度为300～400 ℃)。光电化学性能评价结果表明，适当掺杂CoO_x和适当温度下焙烧能在催化剂表面形成较多的析氢活性物种——含钴复合物，能有效增强催化剂光电流响应强度，并使得析氢光还原电位向有利于析氢方向位移。高含量掺杂CoO_x会在催化剂表面形成某种碳化物物种，大量含钴复合物活性中心的出现会降低光吸收效率，增加TiO₂表面光生电子-空穴复合率而使催化剂失去析氢光催化性能。     

半导体氧化物光催化裂解水制氢

本文综述了半导体氧化物光催化裂解水制氢的反应机理,以及近年来半导体光催化裂解水制氢的研究进展。讨论了各种因素对材料光催化性能的影响以及改性方法,并对今后的研究方向提出了一些建议。