ICP-AES测定彩涂前处理表面调整转化层中Ti、Ni含量及钝化膜中Cr含量

采用电感耦合等离子体-原子发射光谱法同时测定彩涂前处理表面调整转化层中Ti、Ni含量及钝化膜中Cr含量.以表征表面调整转化层厚度及钝化膜厚度,采用本方法准确度高、快速简便,经试验结果令人满意.     

一类非线性方程解的存在和唯一性及在图像中的应用

本文我们给出一个修正的非线性扩散方程模型，与Cotte Lions和Morel的模型相比该模型有许多实质上的优点。主要的想法是把原来去噪声部分：卷积Gauss过程替代为解一个有界区域上的线性抛物方程问题，因此避开了对初始数值如何全平面延拓的问题。我们从数学上的证明该问题解的存在性和适定性，同时给出对矩形域情况的解的级数形式。最后我们给基于本模型的数值计算差分模型，并且给出几个具体图像在该模型下处理结果。     

Widely tunable long-period fiber grating with nm-thick higher refractive index film overlay

By introducing a four-layer step-index waveguide modeling, the characteristics of long-period fiber grating (LPFG) with an nm-thick film overlay, which has higher refractive index than that of fiber cladding are investigated in detail. The influence of both the overlay thickness and refractive index on the tuning ability of LPFG is analyzed. The numerical results demonstrate that spectral response of LPFG is divided into three distinct regions as the overlay deposition increases and the shift of resonant wavelength is drastic in some special thickness range. In conjunction with higher-order cladding mode coupling and fiber cladding etching, the sensitivity of LPFG to the overlay refractive index is enhanced significantly and over 120 nm resonant wavelength tunable range is achieved.     

The effect of microscopic features upon the transmissivity of enclosed laser ablated laminated metallised polymer films

A vacuum-deposited aluminium layer (20 nm) is sandwiched between two layers of laminated oriented polypropylene (OPP) film whose thickness varies from 20 to 40 μm. Selected areas of this sealed system were transparentised by the redistribution of the aluminium layer without breaking the seal or causing damage to the OPP film using a 75 W Q-switched Nd:YAG laser. The resultant transparentised films contain aluminium particles, distorted polymer areas and intact areas of the vacuum-coated aluminium layer. This paper investigates the effect of microscopic features upon the overall transmissivity of the laser-treated films and hence the quality of the transparentisation process.     

Atomistic packing models for experimentally investigated swelling states induced by CO2 in glassy polysulfone and poly(ether sulfone)

Atomistic packing models have been created, which help to better understand the experimentally observed swelling behavior of glassy polysulfone and poly (ether sulfone), under CO₂ gas pressures up to 50 bar at 308 K. The experimental characterization includes the measurement of the time‐dependent volume dilation of the polymer samples after a pressure step and the determination of the corresponding gas concentrations by gravimetric gas‐sorption measurements. The models obtained by force‐field‐based molecular mechanics and molecular dynamics methods allow a detailed atomistic analysis of representative swelling states of polymer/gas systems, with respect to the dilation of the matrix. Also, changes of free volume distribution and backbone mobility are accessible. The behavior of gas molecules in unswollen and swollen polymer matrices is characterized in terms of sorption, diffusion, and plasticization. © 2006 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 44: 1874–1897, 2006     

一类非经典扩散方程整体解的存在唯一性及长时间行为

本文讨论非经典扩散方程第一初边值问题整体解的存在唯一性及长时间行为，建立了一系列新的结果，较好地改进许多已有的结论．     

Very high coercivities of top-layer diffusion Au/FePt thin films

The Au/FePt samples were prepared by depositing a gold cap layer at room temperature onto a fully ordered FePt layer, followed by an annealing at 800 °C for the purpose of interlayer diffusion. After the deposition of the gold layer and the high-temperature annealing, the gold atoms do not dissolve into the FePt Ll₀ lattice. Compared with the continuous FePt film, the TEM photos of the bilayer Au(60 nm)/FePt(60 nm) show a granular structure with FePt particles embedded in Au matrix. The coercivity of Au(60 nm)/FePt(60 nm) sample is 23.5 kOe, which is 85% larger than that of the FePt film without Au top layer. The enhancement in coercivity can be attributed to the formation of isolated structure of FePt ordered phase.     

Wait-and-switch stochastic model of the non-Debye relaxation. Derivation of the Burr survival probability

Stochastic mechanism of relaxation, in which a dipole waits until a favourable condition for reorientation exists, is discussed. Assuming that an imposed direction of a dipole moment may be changed when a migrating defect reaches the dipole, we present a mathematically rigorous scheme relating the local random characteristics of a macroscopic system to its effective relaxation behaviour. We derive a relaxation function (the Burr survival probability) that is characterized by the stretched exponential or the power-law behaviour.     

Application of the finite Hankel transform to a diffusion problem without azimuthal symmetry

The problem treated in this paper concerns calculating the evolution of the pressure in a single-phase, slightly compressible fluid in a porous medium consisting of communicating layers. The fluid is produced through a point sink located on the side of an otherwise sealed cylindrical wellbore. This location of the sink causes the flow around the wellbore to be azimuthally asymmetric.The problem is solved through successive application of Laplace, finite Fourier and finite Hankel transforms. Although apparently straightforward, this approach leads to serious numerical difficulties. The published form of the inversion formula for the finite Hankel transform leads to inaccurate computation for the higher azimuthal modes even with 128 bit arithmetic. An alternative form is developed which enables accurate evaluation of the solution with the more practical 64 bit arithmetic. The technique for two-layer solution presented here can be directly extended to a problem with a larger number of communicating layers. This is the first instance of successful application of the finite Hankel transform to an azimuthally asymmetric diffusion problem.     

Na2CO3调质钙基脱硫剂硫化机理实验研究

对经Na2CO3溶液调质石灰石煅烧产物CaO的物理结构及硫化特性进行了研究,发现同等条件下调质后石灰石煅烧产物CaO(M-CaO)比未经调质的CaO(N-CaO)具有更高的钙转化率.利用XRD技术对CaO晶体结构进行了测定,通过比较二者的晶胞参数和晶格畸变度等并结合其孔特性,证实M-CaO之所以比N-CaO具有更高的钙转化率,是由于M-CaO比N-CaO具有更高的晶体缺陷浓度,使得在硫化反应过程中通过产物层的扩散具有更高的离子扩散率.