Synthesis and burst strength of water‐swollen immunoisolatory tubules

A series of amphiphilic hydrogel tubules have been prepared by copolymerizing/crosslinking hydrophilic poly(dimethylacrylamide) segments with hydrophobic di‐, tri‐, and octamethacrylate‐telechelic polyisobutylene crosslinkers, and their elastic modulus and burst strength in the water‐swollen state were investigated. Because the burst characteristics of hydrogels have not yet been quantitatively investigated, equipment was designed and built to generate fundamental insight into the burst properties of thin‐walled (200–250 μm) narrow lumen (2–3 mm i.d.) water‐swollen tubules. The theory developed to describe quantitatively the inflation behavior of thin‐walled rubber tubules was adapted to treat our experimental observations. Changes in the burst strength, elastic modulus, and expansion during the inflation of hydrogel tubules were interpreted in terms of the molecular weight of the hydrophilic segments between crosslinking sites (M_{c,hydrophilic}), which in turn was calculated according to the rubber elasticity theory. According to these investigations, the burst strength of our water‐swollen amphiphilic tubules is in the 0.2–0.5 MPa range, which is sufficient for implantation and immunoisolatory applications. © 2002 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 40: 2075–2084, 2002     

Aging effect on the mechanical properties of hybrid gels

Sol-gel derived unsupported films and thin rods have been obtained from co-hydrolysis of triethoxysilane and methyldiethoxysilane. The materials are flexible, dense and transparent. Films and rods have been aged for different periods of time in air at room temperature. The elastic modulus has been measured by means of tensile or flexural tests. Measurements showed an increase of elastic modulus with aging time and showed different values for films and rods. The observed evolution of mechanical properties has been related to a corresponding structural modification as highlighted mainly by MAS-NMR studies. Analyses pointed out the crucial role of condensation processes and showed that the stiffness increase arises from the formation of relatively few bonds which link and constrain pre-existing mobile network regions.     

硅酸及其盐的研究 XX聚硅酸溶液中的酸强度与分子结构的关系

本文利用无机酸系列的酸强度(pKa值)与羟基上氧原子的亲电子超离域度S(E)成线性关系的规律性,找出聚硅酸系列的相应线性方程为:并由此推测低聚硅酸溶液中可能存在的硅酸结构:在三聚硅酸溶液中主要存在着六元平面环的三聚体;在四聚硅酸中则主要存在着三种环状的四聚体。     

Time-resolved ultraviolet laser-induced breakdown spectroscopy for organic material analysis

Ultraviolet pulses (266 nm) delivered by a quadrupled Nd:YAG laser were used to analyze organic samples with laser-induced breakdown spectroscopy (LIBS). We present characteristics of the spectra obtained from organic samples with special attentions on the emissions of organic elements, O and N, and molecular bonds CN. The choice of these atomic or molecular species is justified on one hand, by the importance of these species to specify organic or biological materials; and on the other hand by the possible interferences with ambient air when laser ablation takes place in the atmosphere. Time-resolved LIBS was used to determine the time-evolution of line intensity emitted from these species. We demonstrate different kinetic behaviors corresponding to different origins of emitters: native atomic or molecular species directly vaporized from the sample or those generated through dissociation or recombination due to interaction between laser-induced plasma and air molecules. Our results show the ability of time-resolved UV-LIBS for detection and identification of native atomic or molecular species from an organic sample.     

Laser-induced breakdown spectroscopy analysis of minerals: Carbonates and silicates

Laser-induced breakdown spectroscopy (LIBS) provides an alternative chemical analytical technique that obviates the issues of sample preparation and sample destruction common to most laboratory-based analytical methods. This contribution explores the capability of LIBS analysis to identify carbonate and silicate minerals rapidly and accurately. Fifty-two mineral samples (18 carbonates, 9 pyroxenes and pyroxenoids, 6 amphiboles, 8 phyllosilicates, and 11 feldspars) were analyzed by LIBS. Two composite broadband spectra (averages of 10 shots each) were calculated for each sample to produce two databases each containing the composite LIBS spectra for the same 52 mineral samples. By using correlation coefficients resulting from the regression of the intensities of pairs of LIBS spectra, all 52 minerals were correctly identified in the database. If the LIBS spectra of each sample were compared to a database containing the other 51 minerals, 65% were identified as a mineral of similar composition from the same mineral family. The remaining minerals were misidentified for two reasons: 1) the mineral had high concentrations of an element not present in the database; and 2) the mineral was identified as a mineral with similar elemental composition from a different family. For instance, the Ca–Mg carbonate dolomite was misidentified as the Ca–Mg silicate diopside. This pilot study suggests that LIBS has promise in mineral identification and in situ analysis of minerals that record geological processes.     

An investigation of dynamic mechanical, thermal, and electrical properties of housing materials for outdoor polymeric insulators

The present paper reports the results about a study of mechanical, thermal, dynamic mechanical and electrical properties of housing (weather shed) materials for outdoor polymeric insulators. Silicone rubber, ethylene-propylene-diene monomer (EPDM) and alloys of silicon-EPDM are known polymers for use as housing in high voltage insulators. The result of dynamical mechanical measurement shows that the storage modulus of blends enhances with increase EPDM in formulation. It can be seen from the result of TGA measurement that initial thermal degradation of silicone rubber improves by the effect of EPDM in blends. The blends of silicone-EPDM show good breakdown voltage strength compared to silicone rubber. Surface and volume resistance of silicone rubber improve by EPDM content. The mechanical properties of EPDM such as strength, modulus and elongation at break improve by silicone.     

Double pulse laser-induced breakdown spectroscopy of explosives: Initial study towards improved discrimination

Detecting trace explosive residues at standoff distances in real-time is a difficult problem. One method ideally suited for real-time standoff detection is laser-induced breakdown spectroscopy (LIBS). However, atmospheric oxygen and nitrogen contributes to the LIBS signal from the oxygen- and nitrogen-containing explosive compounds, complicating the discrimination of explosives from other organic materials. While bathing the sample in an inert gas will remove atmospheric oxygen and nitrogen interference, it cannot practically be applied for standoff LIBS. Alternatively, we have investigated the potential of double pulse LIBS to improve the discrimination of explosives by diminishing the contribution of atmospheric oxygen and nitrogen to the LIBS signal. These initial studies compare the close-contact (< 1 m) LIBS spectra of explosives using single pulse LIBS in argon with double pulse LIBS in atmosphere. We have demonstrated improved discrimination of an explosive and an organic interferent using double pulse LIBS to reduce the air entrained in the analytical plasma.     

Polarographic and voltammetric determination of trace amounts of 2-nitronaphthalene

The polarographic behaviour of 2-nitronaphthalene was investigated by DC tast polarography (DCTP) and differential pulse polarography (DPP), both at a dropping mercury electrode, and differential pulse voltammetry and adsorptive stripping voltammetry, both at a hanging mercury drop electrode. Optimum conditions have been found for the determination of 2-nitronaphthalene by the given methods in the concentration ranges of 2×10^–6–1×10^–4, 2×10^–7–1×10^–4, 1×10^–8–1×10^–4 and 2×10^–9–1×10^–8 M, respectively. Practical applicability of these techniques was demonstrated by the determination of 2-nitronaphthalene in drinking and river water after its preliminary separation and preconcentration using liquid–liquid and solid-phase extraction with limits of determination of 3×10^–10 M (drinking water) and 3×10^–9 M (river water).     

基于定向纳米碳管气体放电的气敏传感器研究

介绍了一种基于定向纳米碳管的气敏传感器,以生长定向纳米碳管的氧化铝模板作为阳极,铝板作为阴极,利用纳米碳管的尖端发射效应,在较低的电压下使气体产生放电现象。通过对纳米碳管在气体中击穿电压和放电电流的测量,实现对气体的定性定量检测。同时纳米碳管气敏传感器还具有体积小、灵敏度高、稳定性好、响应速度快、在常温常压下即可进行检测等优点,具有较好的应用前景。