复合生物材料的研究进展

从力学性能的改善和降解速率的可调度等角度,总结了复合生物材料与单一组分的材料相比,在生物医学领域应用中所表现出的综合使用性能的优越性。综述了复合生物材料,特别是用于骨修复的各类有机／无机复合材料近年来的研究进展状况。提出将与人骨中磷灰石微晶类似的羟基磷灰石纳米粒子与可降解聚酯材料进行复合,能够得到具有优越骨诱导性能并且能够降解的新型骨修复材料。这方面的研究代表了有机／无机复合生物材料领域新的发展方向。     

气相-质谱法测定粮谷中恶草酮的残留量

 应用微量化学法和固相萃取技术 ,建立了粮谷中恶草酮残留量的气相 质谱 (GC MS)测定方法。用苯 正己烷 (体积比为 1∶1)萃取 ,中性氧化铝小柱净化。净化液用GC MS测定 ,采用外标法定量。恶草酮在大米中的回收率为 90 4%～ 115 .7% ,RSD为 2 %～ 6 % ,在玉米中的回收率为 81 3%～ 10 9 7% ,RSD为 4%～ 9% ,最低定量检出限为 0 0 0 5mg/kg。该法快速、灵敏、准确 ,各项技术指标均满足农药残留检测的要求。     

Liquid–solid disk extraction followed by supercritical fluid elution and gas chromatography of phenols from water

A method combining the techniques of liquid – solid disk extraction (LSDE) and supercritical fluid elution (SFE) has been developed for the phenols regulated by the Clean Water Act. LSDE uses a disk or membrane made of polytetrafluoroethylene (PTFE) fibrils impregnated with small particles, e.g. styrene divinylbenzene (SDB) resin, to extract phenols from water. After disk extraction the retained analytes are eluted from the disk using SFE. SFE is used as an alternative to liquid solvent elution with an organic solvent. Analytes are separated, identified, and quantified using gas chromatography – ion trap detector mass spectrometry (GC-ITDMS). The method is capable of sub parts per billion detection limits, and precision of 5–28% RSD. Evaluation of various disks or membranes, such as C₁₈-silica disks, SDB disks, and ion exchange membranes, has also been performed for the extraction of phenols from water. The results obtained from the in-situ aqueous acetylation of phenols and extraction of their acetates are quantitative. The utilization of LSDE and SFE techniques has proven to be a more effective approach than liquid – liquid extraction in minimizing air pollution and solvent waste.     

LLDPE/纳米SiO_2复合材料的力学性能和光学性能研究

采用熔融共混方法制备了LLDPE 纳米SiO2 复合材料 ,并对该体系的力学性能和光学性能进行了系统研究 .结果表明 ,随着纳米SiO2 的加入 ,复合材料的弹性模量显著提高 ,冲击强度与拉伸强度呈峰形变化 ,且均在SiO2 含量为 3phr左右达到最大值 .加入少量的纳米SiO2 后 ,复合材料薄膜对长波红外线 (7～ 1 1 μm)的吸收能力较LLDPE膜有了显著提高 ,透光率略有下降但雾度提高 ,透光质量得到改善 .同时表明 ,纳米SiO2 的表面处理方法对膜的光学性能有显著影响     

SO_4~(2-)/TiO_2催化合成乙酸戊酯

以Ti(OBu)4为原料,采用溶胶-凝胶法制备了固体超强酸SO24-/TiO2,其结构经XRD,DRS及IR表征。以SO24-/TiO2为催化剂,通过乙酸与戊醇反应合成了乙酸戊酯。讨论了影响酯化率的主要因素。实验结果表明,当催化剂用量为0.6 g,乙酸87.3 mmol,醇酸摩尔比为1.4∶1.0,于115℃反应6 h时,平行实验的平均酯化率可达94.2%。     

高效液相色谱-串联质谱法同时测定表层水体中5类40种抗生素

建立了固相萃取-高效液相色谱-串联质谱（SPE-HPLC-MS/MS）同时检测表层水中5类40种抗生素的分析方法。水样经过滤、固相萃取柱富集净化后，以乙腈-0.2%（v/v）甲酸水溶液为流动相进行梯度洗脱，采用电喷雾电离源，在多反应监测、正离子模式进行定性定量分析。结果显示，40种抗生素在1~200 μg/L水平下线性关系良好，平均加标回收率为41.3%~112.6%。采用该方法对长江南京段表层水体进行检测，共检出13种抗生素，含量为13.4~780.5 ng/L，其中喹诺酮类抗生素恩诺沙星检出率达100%，大环内酯类抗生素克林霉素最高检出水平达739.4 ng/L。该法高效、灵敏、可靠，可用于实际水样中多种抗生素的分析。     

The phase diagram of KNO3-KClO3

The binary phase diagram of KNO₃-KClO₃ is studied by means of differential scanning calorimetry (DSC) and high-temperature X-ray diffraction. The limited solid solutions, K(NO₃)_1−x(ClO₃)_x (0<x<0.20) and K(NO₃)_1−x(ClO₃)_x (0.90<x<1.0), were formed in the KNO₃-based solid solutions and KClO₃-based solid solutions phase, respectively. For KNO₃-based solid solutions, KNO₃ ferroelectric phase can be stable from 423 to 223 K as a result of substituting of NO₃ by ClO₃-radicals. The temperatures for solidus and liquidus have been determined based on limited solid solutions. Two models, Henrian solution and regular solution theory for KNO₃-based (α) phase and KClO₃-based (β) phase, respectively, are employed to reproduce solidus and liquidus of the phase diagram. The results are in good agreement with the DSC data. The thermodynamic properties for α and β solid solutions have been derived from an optimization procedure using the experimental data. The calculated phase diagram and optimized thermodynamic parameters are thermodynamically self-consistent.     

Pt／钇稳定氧化锆固体电解质在高温下的电化学性质

用交流阻抗技术研究了二电极、三电极Ｐｔ／钇稳定氧化锆（简称ＹＳＺ）高温固体电化学体系．开路电位下，Ｐｔ／ＹＳＺ体系只有一个阻抗半圆，对应于电极体系的电化学活化控制过程，极化电阻随温度变化的表观活化能为１７１．５ｋＪ／ｍｏｌ．Ｐｔ／ＹＳＺ界面的双电层电容约为３００μＦ／ｃｍ２．阳极极化下，交流阻抗极化电阻显著减小；阴极极化下，极化电阻反而增大，并出现浓差控制现象．     

Sol-gel polyimide-silica composite membrane: gas transport properties

The effect of introduction of silica particles prepared by the sol-gel technique on the gas transport properties of a polyimide film was studied. The sorption and permeation of N₂, O₂, CO₂, H₂ and CH₄ were studied and correlated with morphological changes in the polymer structure. From sorption isotherms, we observed that the composite membrane presents higher solubility coefficients than the polyimide one. The solubility coefficient ratio between the composite and the polyimide is about 1.5–2.0. The isotherms were analyzed in terms of the dual mode sorption. The Henry's coefficient and the Langmuir's affinity and saturation constants were obtained allowing to calculate the Langmuir to Henry concentration ratios as function of the gas pressure. These ratios decrease until zero within a certain pressure range as long as the Langmuir's mode is acting and they are higher for the polyimide membrane when compared with the composite one. This study was completed with calorimetric measurements during the sorption. The gas interaction energy in kJ/mol decreases within the same pressure range as previously described. The measured energies are higher for the polyimide film when compared with the composite one because the polyimide membrane presents a stronger energetic effect caused by a higher Langmuir's contribution. From permeation studies at 3.15⁵ Pa, the composite membrane showed higher permeability coefficients and permselectivities than the polyimide one. All these results were explained, taking into account the difference on the imidization degree of both membranes and the morphological changes which may be induced by the silica nodules in the organic/inorganic interphases.     

邻苯二酚与乙醇单醚化反应用固体酸催化剂表面上的积炭行为

 研究了邻苯二酚与乙醇气固相单醚化反应用固体酸催化剂表面上的积炭行为，并用TG－DTA，BET，GC－MS，FT－IR和元素分析等手段对积炭物种进行了表征．结果表明，催化剂上有两种类型的积炭，一类属可溶性积炭，主要由二苯醚及其衍生物组成，可在低温燃烧除去；另一类属不可溶性积炭，主要为缺氢的芳烃类聚合物或类石墨碳，需在高温下才能烧除．积炭主要发生在4～8nm范围的中孔内，导致反应后的催化剂大孔范围的孔分布所占的分数增大．随着反应的进行，总积炭量逐渐增多．