新型卤代羟基三苯醚的合成与抑菌活性研究

设计合成了对(间、邻)苯二酚二(4-氯-2-羟基苯基)醚(4a～4c)及对(间、邻)苯二酚二(4-氯-5-溴-2-羟基苯基)醚(5a～5c)共6个卤代羟基三苯醚类化合物,其结构均经1H NMR,IR,MS和元素分析证实,并且对其抑菌活性进行了初步测试.结果表明:此类化合物大多在低浓度下对大肠杆菌、金黄色葡萄球菌、白色念珠菌、白色葡萄球菌、变形杆菌、卡他双球菌、青枯假单胞菌等具有良好的抗菌活性.     

新型分子筛Ti-MMM-1的合成及其催化性能的研究

通过控制TEOS的水解，在不同时间添加与MCM-41和MFI相应的有机模板剂合成出了一种新型分子筛，Ti-MMM-1，采用XRD、FT-IR和低温N2吸附对其进行表征，并用H2O2氧化环己烷和环己醇对其催化活性进行评价．结果表明，Ti-MMM-1是一种具有MCM-41和MFI结构的两相混合的微孔／介孔材料，IR分析表明钛原子已进入分子筛骨架，并在环己烷和环己醇的氧化中表现出较好的催化活性和较高的选择性．     

含噻二唑环苯甲酰脲化合物的合成及杀虫活性

用活性亚结构连接法设计合成了6个新的含1，3，4-噻二唑杂环苯甲酰脲类化合物，其结构经红外光谱、核磁氢谱、元素分析方法确证。同时对其杀虫活性进行了初步研究，发现该类化合物在普筛浓度下对淡色库蚊幼虫具有较好的杀虫活性。化合物Ⅲb(R1=Cl,R2=n-C5H11),Ⅲd(R1=CH3,R2=n-C5H11),Ⅲf(R1=2,6-difluoro,R2=-C5H11)在10mg/L浓度下对淡色库蚊幼虫的杀虫死亡率大于90％。     

Preparation and characterization of nitrogen-doped TiO2 photocatalyst in different acid environments

Nitrogen-doped TiO₂ powders were successfully prepared by a wet method, i.e., a micro-emulsion-hydrothermal method, in different acid environments. Several characterization techniques, X-ray diffraction (XRD), X-ray photoelectron spectroscopy (XPS) and UV-visible diffuse reflectance spectra, were combined to determine the crystal phase, concentration and chemical states of the nitrogen doped in TiO₂. The high photocatalytic activity of the nitrogen-doped TiO₂ was evaluated through the decomposition of rhodanmine B under visible light irradiation. It was suggested that the doped nitrogen formed oxynitride (NO) and produced impurity states at higher above the valence band of TiO₂. Therefore, the nitrogen doping could enhance the response of photocatalyst to the visible light and improve the photocatalytic activity because of the narrowing of band gap of TiO₂.     

Neutral oxygen atom density in the MESOX air plasma solar furnace facility

The density of neutral oxygen atoms in the MESOX set-up, one device of the PROMES-CNRS solar facilities, was determined by a fiber-optics catalytic probe (FOCP). Plasma was created in a flowing air within a quartz tube with the outer diameter of 5 cm by a 2.45 GHz microwave generator with the output power up to 1000 W. The flow of air was varied between 4 and 20 l/h. The O-atom density was found to increase monotonously with the increasing discharge power, and it decreased with the increasing flow rate. The degree of dissociation of oxygen molecules in the plasma column depended largely on the flow rate. At the air flow of 4 l/h it was about 80% but it decreased to about 20% at the flow of 20 l/h.     

Polymerization of vinyl acetate in fatty acids and properties of poly (vinyl alcohols) derived from the poly (vinyl acetates)

Polymerization of vinyl acetate (VAc) in various fatty acids (carbon numbers 4–18) was carried out. Chain transfer constants to the acids were determined to be 20–35×10^–4, from which the constant to a methylene group was obtained to be 0.73×10^–4. Viscometry in aqueous solution of derived poly (vinyl alcohol) (PVA) showed the usual behavior in terms of Huggins constant obtained by the Schulz–Blaschkes equation for PVAs derived from fatty acid systems lower than hexadecanoic acid. PVA derived from octadecanoic acid system showed abnormality, indicating association of alkyl groups. Contact angles on surfaces of PVAs cast from aqueous solutions were measured. While those of PVA derived from lower acid systems were 62°, those of PVAs derived from higher aids were higher and increased to 92° with increase in carbon number to octadecanoic acid. Alkyl groups in the PVAs were estimated to appear on the surfaces. Surface tension of aqueous solution of the PVA derived from octadecanoic acid showed high surface activity, and depended on pH of the solution, indicating the presence and cleavage of lactone ring at the combined portion between PVA and the acid.     

目视催化褪色计时法测定超痕量钒的研究

本文基于在酸性介质中钒(V)催化溴酸钾氧化酸性铬蓝K褪色的新指示反应,建立了一个催化褪色计时法测定超痕量钒的新方法。在体系中引入活化剂抗坏血酸,灵敏度达2×10~(-12)ng/ml,测定范围在0.0l～3.0ng/ml,同时探讨了反应机理。确立了反应速率方程,方法简便经济,已用于天然水中痕量钒的测定。     

甲烷部分氧化制合成气：Ⅲ.镍系催化剂物性及与催化性能间的关联

使用ＴＰＲ和Ｈ２－ＴＰＤ技术对镍铝系催化剂的还原和氢脱附性能进行了研究，并与其催化性能相关联。结果发现，镍铝系催化剂的氢脱附能力与其催化性能之间有一定联系，脱附氢能力越强，催化剂的甲烷部分氧化反应性能就越好，但催化性能与还原性能无直接关联。     

Evaluation of Photocatalytic Activity of Transparent Anatase Nanocrystals-Dispersed Silica Films Prepared by the Sol-Gel Process with Hot Water Treatment

Anatase nanocrystals were precipitated mainly at the surface of the silica-titania gel films with hot water treatment, whereas the addition of poly(ethylene glycol) (PEG) in the films led to the dispersion of anatase nanocrystals in the whole of the films after the treatment. Both films with and without PEG showed high photocatalytic activities for acetaldehyde, NO _x and stearic acid in the gas-solid system, and for methylene blue and potassium iodide in the liquid-solid system. The addition of PEG improved the photocatalytic activities of the resultant films due to the smaller anatase crystallites and the porous film structure. The residual silica under-layer of the superficially anatase-precipitated films is expected to act as a protective one for an organic polymer substrate against the photocatalytic degradation.     

A Method for the Acetylation of Alcohols Catalyzed by Heteropolyoxometallates

Summary. Esterifications of acetic acid with some linear, secondary, tertiary, and benzylic alcohols mediated by catalytic amounts of Keggin, Wells–Dawson, and Preyssler type heteropolyacids were carried out under reflux at mild reaction conditions with good to excellent yields. Among the examined catalysts, H₃PW₁₂O₄₀ and H₁₄NaP₅W₃₀O₁₁₀ revealed better results than other heteropolyacids. This work was performed with the aim of simplifying the esterification process by omitting any solvents and mineral acid catalysts. Easy work-up, low cost, and acidic waste reduction, which are all important features from the environmental and economical points of view, are distinct aspects of this protocol. Heteropolyacid catalysts could be separated after a simple work-up and reused for several times.