Fiber-Optic Chemical Sensor for Detection of NO2 Using Poly (3-Octylthiophene)

A fiber-optic chemical sensor (FOCS) for detection of nitrogen dioxide (NO₂) molecules is reported. The FOCS presents an optropode structure because of the transmission properties of the sensitive material. The NO₂ FOCS is activated by using the semiconductor polymer: regioregular head-to-tail poly(3-octylthiophene-2,5-diyl). The operation wavelength of the sensor is 543.5 nm such that a simple LED and detector can be used for the design of this device. The sensor response decreases after each exposure, demonstrating the reduction in sensitivity as well as irreversibility lower than 5%. However, its properties such as rapid response, high selectivity, high sensitivity (0.43 ± 0.01 muW/ppm), hygroscopic properties, and its operation at room temperature make this kind of FOCS a good alternative for NO₂ toxic gas detection.     

Resistivity－temperature characteristics of sol gel YBa2Cu3Oy samples synthesized in flowing oxygen atmosphere

The relationship of resistivity versus synthesizing temperature of sol gel YBa_2Cu_3O_y samples was studied when prepared under flowing oxygen conditions. A set of high-temperature ρ－T curves was obtained for the whole process. After the sample finished the test measuring, its resistivity was ρ_{300}=9.83×10^{-3 }Ω·cm at room temperature. The ρ－T curve also showed that the orthorhombic－tetragonal phase transformation of sol-gel YBa_2Cu_3O_y sample occurred at 581℃ for the sample in the rising temperature process, but at 613℃ in the cooling process, lower than that of the samples made by using the conventional powder metallurgy methods.     

Compositionally modulated Fermi surfaces, structured diffuse scattering and ternary derivatives of 1T-TaS2

Ternary derivatives of 1T-TaS₂ have been synthesized and the variation in the highly structured diffuse intensity distributions characteristic of such materials carefully monitored to investigate the effect that such substitution has upon the band structures and Fermi surfaces (FSs) of the materials. Removal of d electrons via the replacement of Ta ions with lower valent transition metal ions leads to a systematic increase in the radii of the characteristic structured diffuse intensity distribution. Extended Hückel tight binding calculations of the FSs of the doped samples are carried out and used to predict possible nesting wave-vectors. The results are in reasonably good agreement with the radii of the experimentally observed diffuse intensity distributions.     

变系数(2+1)维Broer-Kaup方程的精确解

利用齐次平衡原则,导出了变系数(2+1)维Broer-Kaup方程的B?cklund变换(BT),并由该BT,求出了(2+1)维Broer-Kaup方程的各种形式的精确解.     

Estimation of growth rate in unidirectionally solidified multicrystalline silicon by the growth-induced striation method

Multicrystalline silicon was grown by unidirectional solidification method using the accelerated crucible rotation technique. The application of the accelerated crucible rotation technique in unidirectional solidification method induced growth striations across the axial direction of the grown crystal. This striation pattern was observed from carbon concentration distribution, obtained by using Fourier transform infrared spectroscopy. The generated striation pattern was found to be weak and discontinuous. Some striations were absent, probably due to back melting, caused during each crucible rotation. From the growth striations and applied time period in crucible rotation, the growth rate was estimated by using Fourier transformation analysis.     

Alkylation of 2,3,6,11-tetrahydroanthra[2,1-d]isothiazole-3,6,11-trione and its S-oxide

The reactions of 2,3,6,11-tetrahydroanthra[2,1-d]isothiazole-3,6,11-trione with dimethyl sulfate, benzyl chloride, and allyl bromide afforded the corresponding 2-alkyl-2,3,6,11-tetrahydroanthra[2,1-d]isothiazole-3,6,11-triones and 3-(alkoxy)-6,11-dihydroanthra[2,1-d]isothiazole-6,11-diones. The reactions of 2,3,6,11-tetrahydroanthra[2,1-d]isothiazole-3,6,11-trione and its S-oxide with a formaldehyde—secondary amine system yielded 2-[(alkylamino)methyl]-2,3,6,11-tetrahydroanthra[2,1-d]isothiazole-3,6,11-triones and 2-[(alkylamino)methyl]-3,6,11-trioxo-2,3,6,11-tetrahydroanthra[2,1-d]isothiazole 1-oxides, respectively.     

温度对PSⅡCP4 7/D1/D2/Cytb559复合物荧光光谱特性的影响

采用激励光源为514.5 nm的分幅扫描单光子计数荧光光谱装置对经20℃、42℃和48℃不同温度处理后的反应中心复合物CP47/D₁/D₂/Cyt b559的荧光光谱特性进行了研究.经解析,获得不同温度处理后,CP47/D₁/D₂/Cyt b559复合物最大峰值未发生变化,均在682 nm,说明Chla670的能量都由Chla682接收,但损耗愈来愈小,在48℃时,损耗程度最小,而其荧光百分比未发生多大变化.振动副带～700 nm和～740 nm的中心波长都发生蓝移,在不同温度下分别为:20℃ 703 nm,749 nm;42℃ 697 nm,744 nm;48℃ 694 nm,740 nm.因此可以推测温度的升高,影响了CP47/D₁/D₂/Cyt b559色素蛋白的二级结构以及色素分子的空间位置,使最大峰值处的荧光强度逐渐降低,振动副带逐渐蓝移.42℃的温度已造成影响,48℃影响较大.     

Excess molar enthalpies of binary mixtures of 1-hexene with some cyclic and aromatic hydrocarbons at 298.15 K

Microcalorimetric measurements of excess molar enthalpies, at 298.15 K, are reported for the four binary systems formed by mixing 1-hexene with the cycloalkanes: cyclohexane and methylcyclohexane, and with the aromatic hydrocarcons: benzene and toluene. Smooth Redlich-Kister representations of the results are presented. It was found that the Liebermann-Fried model also provided good representations of the results.     

1H and 13C NMR spectroscopic study of oxidation of D,L‐cystine and 3,3′‐dithiobis(propionic acid) with hydrogen peroxide in aqueous solution

The oxidation of symmetrical disulfides [D ,L ‐cystine ( 1 ) and 3,3′‐dithiobis(propionic acid) ( 2 )] with hydrogen peroxide in D₂O–NaOH solution (pH 10–11) was studied by NMR spectroscopy. Assignments of the proton and carbon NMR signals of starting materials ( 1 and 2 ) and products of oxidation are based on conventional 1D NMR methods (DEPT, selective spin decoupling). Formation of C—S bond cleavage products or, in case of 2 , partially oxidized intermediates was not detected. The accelerating effect of Cu²⁺ cations, but not Fe³⁺ cations, on the oxidation rate of 1 in basic medium was demonstrated. Copyright © 2002 John Wiley & Sons, Ltd.     

Synthesis of thieno[2,3-d]pyrimidine and quinazoline derivatives from monothiooxamides

A method for syntheses of previously unknown derivatives of thieno[2,3-d]pyrimidines and quinazolines from monothiooxamides was proposed.