电化学方法研究I3^—和Ti^3＋在铂上的异相催化

用电化学方法研究了Ｉ－３和Ｔｉ３＋在还原铂表面上的电极反应，由此计算出Ｉ－３与Ｔｉ３＋在还原铂表面上的混合催化反应速率（νｍｉｘ）．当混合催化电位（Ｅｍｉｘ）位于极限电流区时，νｍｉｘ对［Ｔｉ３＋］为零级反应，对［Ｉ－３］为一级反应，且正比于电极旋转速率的平方根，Ｈ＋浓度影响不大．由动力学方法研究的结果证实了电化学研究结果的正确性，致使可用电化学方法解释溶液中的异相催化问题     

二甲醚电氧化及其阳极催化剂研究

Anode electro-catalysts for direct dimethyl-ether fuel cell (DDFC), Pt/C, PtRu/C (1∶1) and PtSn/C (3∶2), were prepared by chemical impregnation-reduction method with formaldehyde as the reductant. DME electro-oxidation and adsorption at Pt electrode and Pt electro-catalysts were investigated by Cyclic Voltammetry(CV), Quasi-steady state polarization and Gas Chromatography(GC). CV showed that there were two current peaks of DME electro-oxidation at Pt electrode around 0.8V (vs RHE); DME was adsorbed at Pt electrode more weakly and slowly than oxygen, methanol, even hydrogen; the onset potential of DME oxidation was 50mV less than that of methanol, and DME peak potential 110 mV lower, thus more advantageous for using in fuel cells than methanol. GC showed that small amount of HCHO was generated during DME electro-oxidation. The mechanism of DME electro-oxidation was proposed. Among the three electro-catalysts (Pt/C, PtRu/C and PtSn/C), Pt alloy catalysts, especially PtRu/C, showed a higher performance toward DME electro-oxidation, as in the case of methanol. Temperature experiments showed that both DME electro-oxidation and adsorption on Pt and Pt alloy catalysts were favored with increased temperature.     

贵金属对钴基催化剂上肉桂醛选择加氢反应的影响

 研究了贵金属改性的Co／γ－Al2O3催化剂上的肉桂醛选择加氢反应．结果表明，通过Pt，Pd和Ru贵金属改性，提高了催化剂的活性，但只有Pt改性的催化剂具有较高的选择性．w（Pt）＜0．5％时，催化剂的活性随着Pt含量的增加呈直线升高，当w（Pt）＝0．5％时，催化剂活性可提高近5倍，但催化剂的选择性变化很小．XRD结果表明，催化剂经还原后，γ－Al2O3上的钴主要为α－Co0．TPR结果表明，Pt的加入提高了Co3O4的还原性能，且Pt含量越高，Co3O4的还原温度越低．XPS结果表明，Pt改性的催化剂样品，其Co3O4大部分被还原为Co0．由于Pt与Co具有协同效应，故Pt改性的Co／γ－Al2O3催化剂既具有较高的活性，又具有很高的选择性．     

前驱体水解对纳米铂形状控制合成的影响

以聚丙烯酸钠(NaPA: M_w ≈ 2100)为保护剂，对比研究了H_2还原K_2PtCl_4 和K_2PtCl_6水溶液制备纳米铂晶粒的形状选择性，揭示了前驱体的水解对纳米铂 晶粒的形状控制合成具有显著影响。文献中通常采用的合成立方形状纳米铂的 K_2PtCl_4前驱体在水溶液中不稳定，避光静置一周会析出黑色沉淀。这种不稳定 性导致了以K_2PtCl_4为Pt前驱体的合成结果难以重复。相比而言，避光静墨的 K_2PtCl_6水溶液很稳定，以它为前驱体合成的纳米铂通常为削角八面体。 K_2PtCl_6水溶液暴露于室内光线中会出现[PtCl_6]~(-2)的光致水解。当[PtCl_6] ~(2-)的紫外特征吸收峰(260nm)由于光致水解完全消失后，以聚丙烯酸钠为保护剂 ，通过H_2还原可以有选择性地(约80%)合成由{100}晶面包裹的立方体形状的纳米 铂。     

溶剂浮选吸光光度法测定微量铂

本文应用溶剂浮选吸光光度原理,拟定了微量铂的分析方案。用CTMAB作捕收剂,捕收〔Pt(SnC1_3)5〕~(3-)离子,浮选至有机溶剂乙酸乙酯中,在398nm处用1cm的比色皿测定吸光度,可以测定ppb级的铂。富集比为40,表观摩尔吸光系数为2.6×10~5,铂的回收率接近100％。     

ICP-AES测定废Al2O3基催化剂中Pt、Pd

研究了废Al2O3基催化剂中Pt,Pd的ICP－AES测定新方法。以王水溶解样品，在HCl(5 95)介质中，用工作曲线法对废Al2O3基催化剂中的Pt,Pd直接进行测定，不需进行基体匹配。方法的检出限分别为：Pt 0.1μg/mL，P 0.045μg／mL；样品的加标回收率为Pt 95.2%-105.5%,Pd 95.3%-100.6%;RSD(n=6)均＜9％。     

纤维互基磁性聚偕胺肟树脂的研究

研究了纤维素基磁性聚偕胺肟树脂吸附氯铂酸的过程。接触２５ｍｉｎ时，吸附容量达２１７ｍｇＰｔ／ｇ℃Ｒ。吸附速度受控于粒内扩散和化学反应。在Ｈ２ＰｔＣｌ６溶液中添加酸或碱均使吸附容量急剧下降。     

Amperometric Determination of lndole-3-acetic Acid Based on Platinum Nanowires and Carbon Nanotubes

Platinum nanowire （PtNW） can be grown by electrodeposition in polycarbonate membrane, with the average diameter of the nanowires about 250 nm. The PtNW and multiwalled carbon nanotubes （CNT） are then dispersed into chitosan （CHIT） solution. The resulting PtNW-CNT-CHIT material brings new capabilities for electrochemical devices by using the synergistic action of the electrocatalytic activity of PtNW and CNT. By dropping the PtNW-CNT-CHIT film onto the glassy carbon （GO） electrode surface, and after evaporation an amperometric sensor for the determination of indole-3-acetic acid （IAA） was developed. The oxidation current of IAA increased significantly at the PtNW-CNT-CHIT film coated GC electrode, in contrast to that at the CNT-CHIT modified GC. The linear response of the sensor is from 50 ng/ml to 50 μg/ml with a detection limit of 25 ng/mL.