介质靶表面的充电效应对等离子体浸没离子注入过程中鞘层特性的影响

针对等离子体浸没离子注入技术在绝缘体表面制备硅薄膜工艺，采用一维脉冲鞘层模型描述介质靶表面的充电效应对鞘层厚度、注入剂量及靶表面电位等物理量的影响.数值模拟结果表明：随着等离子体密度的增高，表面的充电效应将导致鞘层厚度变薄、表面电位下降以及注入剂量增加，而介质的厚度对鞘层特性的影响则相对较小. 关键词： 等离子体浸没离子注入 脉冲鞘层 绝缘介质 充电效应     

激光限制结晶技术制备nc-Si/SiO2多层膜

在等离子体增强化学气相淀积系统中，采用aSi:H层淀积和原位等离子体氧化相结合的逐层生长技术制备了aSi:H/SiO_2多层膜.在激光诱导限制结晶原理基础上，使用KrF准分子脉冲激光为辐照源，对aSi:H/SiO_2多层膜进行辐照，使纳米级厚度的aSi:H子层晶化.Raman散射谱和电子衍射谱的结果表明，经过激光辐照后纳米Si颗粒在原始的aSi:H子层内形成，晶粒尺寸可以根据aSi:H层的厚度精确控制.还研究了样品的光致发光（PL）特性以及激光辐照能量密度对PL性质的影响. 关键词： 脉冲激光 多层膜 限制结晶     

光纤光栅选频掺Yb3+双包层光纤激光器

利用相位掩模法 ,在D形内包层掺Yb3 双包层光纤一端直接写制出Bragg光栅 ,用作双包层光纤激光器的输出腔镜 .试验得到了线宽为 0 196nm ,波长为 10 5 8 2nm ,最高输出功率为 5 70mW的稳定激光输出 ,解决了激光器中模式竞争造成的输出不稳定现象 .从速率方程出发 ,对激光器的输出功率与抽运功率、光栅反射率的关系以及最佳光纤长度进行了理论分析 ,结果与实验符合很好     

纳米KMn8O16粉体的室温固相合成与表征

室温或近室温固相反应要求绿色化、清洁化[1,2]。我们以KMnO4和MnCl2·4H2O为原料,用室温固相氧化还原反应制备氧化锰粉体时,得到了一种对H2O2分解具有较高催化活性的纳米KMn8O16粉体,用XRD、SEM、IR等技术对其进行了表征,发现研磨时间对粉体性能有显著影响。1　实验部分1 1　粉体的制备按摩尔比(2∶3)准确称取一定量的分析纯KMnO4和MnCl2·4H2O,分别置于玛瑙研钵中充分研细,再混合研磨,固相反应立即发生,体系颜色逐渐加深,并有刺激性气体产生,充分研磨后70℃恒温12h,固相产物依次经水洗至中性、醇洗、抽滤,真空干燥得黑色粉…     

调节层状分子基磁体[NO2BzQ1][FeRuxFe（1-x）（ox）3]的合成与磁性研究

合成了组成不同的一类新的层状分子基磁体[NO2BzQ1][FeRuxFe(1-x)(ox)3]，并测定了它们的变温磁化率，结果显示，磁体磁性随着Ru^Ⅲ／Fe^Ⅲ比例的不同而发生变化。     

钌(Ⅱ)卟啉催化顺式二苯乙烯类化合物的选择性合成

由芳醛制得的腙盐在钌(Ⅱ)卟啉催化下发生自身偶合，以较高收率合成了二苯乙烯类化合物(～90％的顺式选择性)。部分中间体及目标化合物的结构经^1H NMR，^13C NMR和MS表征。     

Synthesis of 2-Acyl-2H-1,2,3-diazaphospholes and Their Diels-Alder Reaction with Cyclopentadiene

2H-1,2,3-Diazaphospholes 3a-3h were prepared from various ketone acylhydrazones and phosphorus trichloride in the presence of triethylamine. Compounds 3 underwent feasible hetero-Diels-Alder reactions with cyclopentadiene to afford the respective anellated [1,2,3]diazaphospholes 4a--4d as well as 4a‘--4d‘ in moderate yields. The endo rule in the reaction was observed under kinetic control conditions.     

Synthesis of 5,6-Dihydro-OSW-1 and Its Antitumor Activities

5,6-Dihydro-OSW-1 (1) was synthesized following our previous procedure for the total synthesis of OSW-1. This compound demonstrated slightly stronger potency than that of OSW-1 against the growth of cancer cells.     

Self-assembly of Carboxyl Functionalized Polystyrene Nanospheres into Close-packed Monolayers via Chemical Adsorption

The polyacrylic acid functionalized polystyrene nanospheres were synthesized and self-assembled into irregular, densely packed monolayers in non-aqueous media. The polymer nanoparticles were chemically adhered to substrates. The morphologies of the resulting films were investigated. The impact of the volume fraction of alcohol in the mixed solvents on the particle adsorption and fabrication of nanosphere assembled films was examined.     

New Approach to Synthesis of Tetrahydroisoquino[2,1-c] [1,3]benzodiazepine

A concise and efficient synthesis of the new compounds tetrahydroisoquino [2,1-c] [1,3]benzodiazepine 5 and 7 is reported.