袁家骝和他的科学贡献

1 生平 美籍华人、世界著名高能物理学家袁家骝先生,于2003年2月11日下午在北京协和医院逝世,享年91岁[1].     

中国邮路问题的一个解法

本给出中国邮路问题的一个解法。虽然它仍只是初始方案，但因考虑了问题的足够信息，因而这种方案至少拉近了与最优解的距离。     

MC模式下顾客需求与厂商供应的纳什均衡

在大规模定制(MC，Mass Customization)模式下，基于市场需求的复杂化，厂商对个性化的顾客需求很难做出及时准确的反应，而且由于其自身生产能力的限制，不可能对所有的个性化用户进行一一地满足，只可能对已经存在的个性化需求，根据自身的生产能力和规模，以利润最大化及顾客对产品的满意度为目标，对个性化需求进行较准确地预测，从而正确指导生产。本通过博弈论的方法，提出了一个基于顾客对产品的满意度及企业的利润的一个非合作博弈模型，并给出求解纳什均衡的方法。     

Low Cost, High Efficiency, Gain Flattened L Band EDFA Using FBGs as C Band Seed Generators

A low cost, coolerless 980nm diode pumped, gain flattened L band EDFA with fast transient control, high pump efficiency and gain clamping effect was realized by using FBGs as C band seed generators.     

酪氨酸-溴酸钾-硫酸-丙酮在三邻菲啰啉合铁(Ⅱ)催化下的B-Z振荡反应

研究了酪氨酸 溴酸钾 硫酸 丙酮在三邻菲啉合铁 (Ⅱ )催化下的化学振荡反应 ,对振荡的影响因素进行了研究和讨论 .运用正交实验法确立了振荡反应进行的浓度范围 ,得到一个 4 0多次振荡寿命为 6 0min的振荡波 .获得振荡的诱导期和周期与反应物浓度之间的变化趋势曲线 ,以及振荡反应在诱导期和振荡期的表观活化能分别为Ein=4 9.0kJ/mol和E =5 7.0kJ/mol.根据反应过程中的现象和实验数据 ,建立了振荡反应的模型和反应机理 ,确定 [Br-]是振荡反应自发进行的关键因素 .     

In-Situ Intrinsic Interface Strength Measurement at Elevated Temperatures and its Relationship to Interfacial Structure

A previously developed laser spallation technique has been modified to measure the tensile strength of thin film interfaces in-situ at temperatures up to 1100°C. Tensile strengths of Nb/A-plane sapphire, FeCrAl/A-plane sapphire and FeCrAlY/A-plane sapphire were measured up to 950°C. The measured strengths at high temperatures were substantially lower compared with their corresponding strengths at ambient temperature. For example, at 850°C, the interface tensile strength for the Nb/sapphire (151 ± 17 MPa), FeCrAl/sapphire (62 ± 8 MPa) and FeCrAlY/sapphire (82 ± 11 MPa) interface systems were lower by factors of approximately, 3, 5, and 8, respectively, over their corresponding ambient values. These results underscore the importance of using such in-situ measured values under operating conditions as the failure criterion in any life prediction or reliability models of such coated systems where local interface temperature excursions are expected. The results on alloy film interfaces also demonstrate that the presence of Y increases the strength of FeCrAl/Al₂O₃ interfaces.     

70K温区混合工质分凝分离循环节流制冷机实验研究

混合工质节流制冷机正在许多方面获得越来越广泛的应用。文中设计了一种新型的混合工质分凝分离循环 ,建立了实验系统 ,并在 70 K温区进行了实验。实验结果表明 ,节流制冷机可以达到 6 5 .3K的低温 ,并在 72 K温度提供 1W的制冷量 ,输入功率为 5 0 0 W。     

Giant Magneto-Impedance of Co50Ni22Ga28 Alloy with High Chemical Ordering

The microstructure of CosoNi22Ga28 ribbon with the L10 structure is examined. The band-like morphology is observed. These bands with the width in a range of 40-200 nm appear along the transverse direction of the ribbon. The giant magnetoimpedance （GMI） effect in this alloy is measured. The results show that Co5oNi22Ga28 exhibits a sharp peak of the GAI effect. The maximum GAH ratio up to 360% is detected. The GMI effect measured versus temperature shows large jumps of the magnetoimpedance amplitude at the reversal martensitic transformation temperature 240℃ and Curie temperature 375℃C respectively. The jump ratios of the magnetoimpedance amplitude examined at these temperatures are about 5 and 10, respectively.     

复注及多孔注浆理论研究

针对柱面注浆方式，研究了有关渗透注浆的单孔复注及不同方式布孔时多孔注浆的相互影响等问题，推导出一些有价值的岩体注浆理论公式，可用于指导现场注浆工程的设计与施工．     

Experimental investigation and theoretical modeling of liquid entrainment in a horizontal tee with a vertical-up branch

This article describes a comprehensive literature review of liquid entrainment in horizontal pipes with vertical-up branches. Deficiencies in the available data and correlations were identified. The Air–water Test Loop for Advanced Thermal–hydraulic Studies (ATLATS) was constructed and entrainment onset and steady-state data were collected for a wide range of flow conditions. Using new insights gained from experimental testing, the authors developed a model for predicting the onset of entrainment and steady-state entrainment rate. Previously published correlations, along with the new model, are compared against all available data. The new model shows very good agreement with the onset data, but is not very good at predicting branch quality at high liquid flow rates.