无脂链磺化酞菁铜多层膜体系：电子非弹性平均自由程的研究

磺化酞菁铜多层膜体系是利用Langmuir-Blodgett技术制备的有序有机分子膜,它对于XPS测试有很好的稳定性,本文在固定电子出射角的条件下利用XPS方法研究了不同厚度的膜样品中Cu_((2(?))_(3/2))、Ni_(1(?))、S_(2p)峰强度的变化规律,讨论了膜内分子有序排列引起的散射效应对电子平均自由程的影响。     

锰（Ⅱ）—邻菲口罗啉配合物极谱吸附波及其应用

在ｐＨ９．５ＮＨ３ＮＨ４Ｃｌ缓冲溶液中，Ｍｎ（Ⅱ）与邻菲口罗啉形成的配合物在－１．３６Ｖ（ｖｓ．ＳＣＥ）处产生一灵敏的吸附波，一阶导数峰电流与Ｍｎ（Ⅱ）浓度在５×１０－８５×１０－６ｍｏｌ／Ｌ范围内呈线性关系，检出限为２×１０－８ｍｏｌ／Ｌ对极谱性质及反应机理进行了研究，用该法测定了大豆和茶叶中的微量锰，结果满意     

Chemical Constituents from the Stems of Mahonia Japonica

A new dihydroberberine alkaloid, 7,8‐dihydro‐8‐methoxyberberine ( 1 ), along with six known compounds including two dihydroberberine alkaloids, 7,8‐dihydro‐8‐hydroxyberberine ( 2 ) and oxyberberine ( 3 ) and four protoberberine alkaloids, berberine ( 4 ), palmatine ( 5 ), jatrorrhizine ( 6 ) and columbamine ( 7 ), were isolated from the stems of Mahonia japonica. These compounds were characterized and identified by physical and spectral evidence.     

烯烃的有机催化不对称环氧化反应

介绍了用手性酮，手性亚胺盐为催化剂以及手性胺为催化剂前体的新型有机催化不对称环氧化反应。     

溶液中芳香单酮的聚集态

本文对九种芳香单酮(苯乙酮、对氯苯乙酮、对甲氧基苯乙酮、对氨基苯乙酮、对硝基苯乙酮、间硝基苯乙酮、2.4-二甲基苯乙酮、1-萘乙酮和1-萘基苯基甲酮)在丙酮溶液中的吸收光谱进行了比较。发现芳香单酮在溶液中的分散是不均匀的, 随浓度增加, 有芳香单酮的聚集体生成。且芳香单酮分子的共轭体系越发达或苯环上电子云密度越犬, 分子就越易聚集。同时提出芳香单酮聚粲时的分子排列是苯环对苯环“面对面”取向的推断。     

气相色谱法测定三聚氰氯的研究

气相色谱法测定三聚氰氯的研究李秀梅赵树岚＊田锦霞＊孙维星（东北师范大学化学系长春１３００２４）关键词气相色谱法三聚氰氯三聚氰氯（ＣＮＣｌ）３是活性染料的重要中间体及合成树脂、橡胶、塑料等的防老剂，也常用于除草剂、增白剂、药物、炸药等的生产中。传统的分...     

铜在HOPG上电沉积过程的现场ECSTM研究

用自制的电化学扫描隧道显微镜（ＥＣＳＴＭ）现场研究Ｃｕ在ＨＯＰＧ上的电沉积过程．结果表明Ｃｕ在ＨＯＰＧ上的电沉积为三维成核的过程．当电位较低或Ｃｕ２＋离子浓度较低时，铜在本体金属生长主要沿着台阶方向．过电位较高时，铜的成核数目增加，沉积层的晶粒有所细化．同时，非现场ＥＣＳＴＭ比较研究表明，ＳＴＭ针尖对针尖局部区域的电沉积起屏蔽作用，针尖所在区域Ｃｕ的沉积速度比其它区域明显减小     

马来酸酐与1，2－环己烷二羧酸二异丁酯的气液平衡

采用小沸点仪测定了马来酸酐和1,2－环己烷二羧酸二异丁酯二元系统在不同配料组成条件下的温度与压力数据，并通过内插法得到不同压力下的温度与配料组成的数据.进一步采用单纯形法优化NRTL方程参数，推算了平衡气液相组成，发现该二元系统具有最高压力恒沸点，且该恒沸点随压力的变化显著.当压力降低至20 kPa时, 由温度随气相组成的变化趋势知该恒沸点将趋于消失.     

Synthesis of optically active 2-alkyl-3,4-iminobutanoic acids. Beta-amino acids containing an aziridine heterocycle

All four stereoisomers of 2-alkyl-3,4-iminobutanoic acid, a novel class of beta-amino acids bearing a chemically versatile aziridine ring, were synthesized starting with aspartic acid. The synthetic strategy involves the introduction of an alkyl group at the beta-position of fully protected optically active aspartic acid followed by the construction of an aziridine ring making use of the alpha-carboxylate and alpha-amino groups. The alpha-carboxylate was reduced to the corresponding alcohol, which was then subjected to cyclization to form an aziridine ring with the N-protected amino group. Removal of the protection groups yielded the target compounds.     

Failure of elastomeric polymers due to rate dependent bond rupture

A new cohesive zone model is developed in order to study the mechanisms of adhesive and cohesive failures of soft rubbery materials. The fracture energy is estimated here using a strategy similar to that of Lake and Thomas (LT) by considering the dissipation of stored elastic energy followed by the extension and relaxation of polymer chains. The current model, however, departs from that of LT in that the force needed to break an interfacial bond does not have a fixed value; instead, it depends on the thermal state of the system and the rate at which the force is transmitted to the bond. While the force required to rupture a chain is set by the rules of thermomechanically activated bond dissociation kinetics, extension of a polymer chain is modeled within both the linear and nonlinear models of chain elasticity. Closed form asymptotic solutions are obtained for the dependence of crack propagation speed on the energy release rate, which are valid in two regimes: (I) slow crack velocity or short relaxation time for bond dissociation; (II) fast crack velocity or long relaxation time for bond dissociation. The rate independent and the zero temperature limit of this theory correctly reduces to the fracture model of LT. Detailed comparisons are made with a previous work by Chaudhury et al. which carried out an approximate analysis of the same problem.