Frequent oscillation in a nonlinear partial difference equation

This paper is concerned with a class of nonlinear delay partial difference equations with variable coefficients, which may change sign. By making use of frequency measures, some new oscillatory criteria are established. This is the first time oscillation of these partial difference equations is discussed by employing frequency measures.      

Synthesis of the D-Galactopyranoside Derivative of C_(60)

ThefascinatingsbocturesandpropertiesoffullereneshaveoPeneduPanewfieldofchendstry.Inparticular,F.Wudletal.l'2haveshownthatwatersofubleC6ocomPoundsinhibittheHITVen-zymesprotease(HIVP)andreversetranscriPtase(HIVRT).IthasbeenafocusofstUdytoinvestigatethebiologicalactivitiesofthesenovelsubstances.Fortheirpossiblemedicaluses,tolinkC6omoleculetonaturalProductssuchassugars,pephdes,amioacides,andsoonisanimPortantmethodinthisfield.Vasella3reportedthefirstglucosidederivativeofC6o'InthispaPer,w…     

D→Klv～l衰变过程的研究

用光锥QCD求和规则研究D→Klv～_l衰变过程，首先计算D→K跃迁形状因子，通过构造新的关联函数，消除了twist-3波函数的不确定性给计算结果所带来的影响，从而使计算结果更加精确. 计算得到的分支比与最近的实验数据相一致. 关键词： QCD光锥求和规则 D介子半轻衰变 分支比 形状因子     

气相色谱-质谱联用法测定维生素C泡腾片中的甜蜜素

采用气相色谱-质谱(GC-MS)选择离子监测法(SIM),建立了准确可靠、灵敏度高、快速简便的测定维生素C泡腾片中甜蜜素含量的新方法.样品中的甜蜜素衍生后用有机试剂提取,在选择离子模式下进行测定,以保留时间和特征离子比例进行定性,单离子定量.甜蜜素的线性范围为0.05-10mg/L,检出限为0.6mg/kg,回收率为90.5%-96.9%,相对标准偏差小于4.4%.方法分析所用时间短,结果准确可靠,选择性好,适用于维生素C泡腾片中甜蜜素含量的检验.     

二元合金微观偏析的相场法数值模拟

使用耦合溶质场的相场模拟研究了Ni-Cu二元合金枝晶生长过程中固相溶质扩散系数D_s 对枝晶形貌和微观偏析等的影响.计算结果表明，随着D_s的减少，固液界 面前沿溶质扩散层越薄，枝晶生长越有利，枝晶尖端生长的速度越大，侧向分支越发达；D< sub>s越小，固相中溶质成分的波动越强烈，随着D_s的增大，固相中溶质 成分的波动相应减小；溶质微观偏析程度随D_s的增大而减小. 关键词： 相场方法 微观偏析 固相扩散系数 数值模拟     

Phenylene vinylene‐based electroluminescent polymers with electron transport block in the main chain

We report a new route for the design of soluble phenylene vinylene (PV) based electroluminescent polymers bearing electron‐deficient oxadizole (OXD) and triazole (TZ) moieties in the main chains with the aryloxy linkage. Both series of the PV‐based polymers were prepared by Wittig reaction. By properly adjusting the OXD and/or TZ content through copolymerization, we can achieve an enhanced balance of hole‐ and electron injections, such that the device efficiency is significantly improved. Light‐emitting diodes fabricated from P1, P2, P3, P4, P5, P6, and P7 with the configuration of Indium–Tin Oxide (ITO)/Poly (styrene sulfonic acid) doped poly (ethylenedioxythiophene) (PEDOT)/polymer/Ca/Al, emit bright green light with the maximum peak around 500 nm. For the device using the optimal polymer (P4) as emitting layer, a maximum brightness of 1300 cd/m² at 20 V and a maximum luminance efficiency of 0.325 cd/A can be obtained. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 3469–3478, 2006     

垂直低温两相流管底液氮汽泡上升速度的实验研究

本文对垂直低温两相流管底部液氮汽泡的上升速度运用高速摄像机进行了可视化实验研究,对所采集的实时图像进行处理.在Cole和Mendelson汽泡上升速度经验公式的基础上,通过对液氮汽泡的上升速度的分析,提出了圆管管路底部液氮汽泡的上升速度的拟合公式,分析研究其变化规律,为进一步探求圆管内液氮弹状汽泡的生成机理提供依据.     

IR and XPS investigation of visible-light photocatalysis—Nitrogen-carbon-doped TiO2 film

To use solar irradiation or interior lighting efficiently, we sought a photocatalyst with high reactivity under visible light. Nitrogen and carbon doping TiO_2−x−yN_xC_y films were obtained by heating the TiO₂ gel in an ionized N₂ gas and then were calcined at 500 °C. The TiO_2−x−yN_xC_y films have revealed an improvement over the TiO₂ films under visible light (wavelength, 500 nm) in optical absorption and photocatalytic activity such as photodegradation of methyl orange. X-ray photoemission spectroscopy, infrared spectrum and UV-visible (UV-vis) spectroscopy were used to find the difference of two kinds of films. Nitrogen and carbon doped into substitutional sites of TiO₂ has been proven to be indispensable for band-gap narrowing and photocatalytic activity.     

Study of DNA coated nanoparticles as possible programmable self-assembly building blocks

Nanoparticles coated with single stranded DNA have been shown to efficiently hybridize to targets of complementary DNA. This property might be used to implement programmable (or algorithmic) self-assembly to build nanoparticle structures. However, we argue that a DNA coated nanoparticle by itself cannot be used as a programmable self-assembly building block since it does not have directed bonds. A general scheme for assembling and purifying nanoparticle eight-mers with eight geometrically well-directed bonds is presented together with some preliminary experimental work.