铁铝复合柱撑粘土的制备、柱结构和稳定性(I)

用两种方法合成了一系列不同Fe/Al比的铁铝复合柱撑牯土(FeAl-PlLC). 用~(27)Al-NMR、UV、ESR等手段考察了柱溶液的结构和状态, 用XRD、DTA、UV-DRS 等技术对其结构、稳定性进行了研究. 结果表明, 铁铝柱撑粘土的底面间距为1.98～1.55 nm, Fe/Al比对其柱结构、比表面积、热稳定性均有较大影响. Fe/Al<0.5时, 层间柱主要呈现Keggin结构, Fe/Al≥0.5时, 可能为三聚结构. 随Fc/Al比的增加, d(001)值, 比表面面、热稳定性逐渐下降.     

Manipulating the electronic structures of silicon carbide nanotubes by selected hydrogenation

We show that the electronic and atomic structures of silicon carbide nanotubes (SiCNTs) undergo dramatic changes with hydrogenation from first-principles calculations based on density-functional theory. The exo-hydrogenation of a single C atom results in acceptor states close to the highest occupied valence band of pristine SiCNT, whereas donor states close to the lowest unoccupied conduction band appear as a Si atom being hydrogenated. Upon fully hydrogenating Si atoms, (8,0) and (6,6) SiCNTs become metallic with very high density of states at the Fermi level. The full hydrogenation of C atoms, on the other hand, increases the band gap to 2.6 eV for (8,0) SiCNT and decreases the band gap to 1.47 eV for (6,6) SiCNT, respectively. The band gap of SiCNTs can also be greatly increased through the hydrogenation of all the atoms.     

环己烷催化氧化制取顺酐和醋酸的催化剂研究

为研究气态环己烷催化氧化制取顺酐及醋酸的新反应，采取不同的方法制备了系列固体VPO催化剂.借助XRD、FT-IR对催化剂进行了主体晶相确定，用氧化还原滴定方法测定了不同晶相催化剂中钒的平均氧化数.结合催化反应的活性评价，发现催化剂主体晶相、结晶度、活化气氛和催化剂的V4＋/V5＋比均对目标反应的催化活性产生影响，5种催化剂中以(VO)2P2O7晶相催化剂的活性为最高.     

A combinatorial approach to study solvent-induced self-assembly of mixed poly(methyl methacrylate)/polystyrene brushes on planar silica substrates: effect of relative grafting density

This article reports the study of the effect of relative grafting densities of two polymer chains on solvent-induced self-assembly of mixed poly(methyl methacrylate) (PMMA)/polystyrene (PS) brushes through a combinatorial approach. Gradient-mixed PMMA/PS brushes were synthesized from a gradient-mixed initiator-terminated monolayer by combining atom transfer radical polymerization (ATRP) and nitroxide mediated radical polymerization (NMRP) in a two-step process. The gradient-mixed initiator-terminated monolayer was fabricated by first formation of a gradient in density of an ATRP initiator through vapor diffusion followed by backfilling of an NMRP-initiator-terminated trichlorosilane. After treatment of a gradient-mixed brush whose PS Mn was slightly lower than that of PMMA with glacial acetic acid, a selective solvent for PMMA, relatively ordered nanodomains were observed in the region where the ratio of PS to PMMA grafting density (number of polymer chains/nm2) was in the range from 0.67 to 2.17 and the overall grafting density was approximately 0.85 polymer chains/nm2. Contact angle hysteresis were high (> or =40 degrees ) in this region and XPS studies confirmed that the PMMA chains were enriched at the outermost layer. The nanodomains are speculated to be of a micellar structure with PS chains forming the core shielded by PMMA chains.     

沙林酸印迹聚邻苯二胺纳米膜制备及结构表征

采用电化学聚合法合成了对有机磷毒剂沙林具有特异识别的聚邻苯二胺(PPD)分子印迹纳米膜(iPPD).利用石英晶体微天平(QCM)证实了印迹效应的存在，并用循环伏安法(CV)、AFM、XPS进行了系统的结构表征.结果表明，分子印迹膜的膜厚约20 nm，膜的表面呈“石林”状，疏松多孔，具有良好的吸附性能.分子印迹主要影响聚合物的三维排列，而聚合物的化学组成没有发生改变.该种分子印迹纳米膜在选择性检测军用毒剂沙林中具有良好的应用前景.     

Structural and physical properties of the 6H BaRuO3 polymorph synthesized under high pressure

The single-phase 6H BaRuO₃ with the hexagonal BaTiO₃ structure was synthesized at 5 GPa and 1000 °C. Rietveld refinement of the powder X-ray data for the 6H phase resulted in the lattice parameters to be a=5.7127(1) Å and c=14.0499(2) Å; the average Ru-O distance and direct Ru-Ru distance in the Ru₂O₉ dioctahedron being 1.992(6) and 2.5658(14) Å, respectively. The electrical resistivity of the 6H BaRuO₃ follows a relationship of ρ versus T^3/2 below 60.0 K, a signature deviation from the Fermi-liquid behavior. Both magnetic susceptibility and specific heat data indicate that the 6H BaRuO₃ is an exchange-enhanced Pauli paramagnet due to the electron correlation effect with large Wilson ratio R_W and Stoner enhancement factor. The comprehensive evolution of transport and magnetic properties from 9R across 4H to 6H BaRuO₃ was discussed.     

有限群极大子群的θ-子群偶

N.P.Mukherjee和 P.Bhattacharya在“On theta pairs for a maximal sub-group”(Proc.Amer.Math.Soc,Vl09N3(1990))一文中定义了有限群的极大子群的θ-子群偶概念,研究了极大子群的极大θ-子群偶对群结构的影响,得到了一系列结果.本文在进一步探究θ-子群偶性质的基础上,对该文中一系列主要结果作出了本质性的改进,并给出了可解性、幂零性的一些新刻划.     

IMPACT MODEL RESOLUTION ON PAINLEVE’S PARADOX

Painlev&#233;‘s paradox is one of the basic difficulties for solving LCP of dynamic systems subjected to unilateral constraints. A bi-nonlinear parameterized impact model, consistent with dynamic principles and experimental results, is established on the localized and quasi-static impact model theory. Numerical simulations are carried out on the dynamic motion of Painlev&#233;‘s example. The results confirm ““““impact without collision““““ in the inconsistent states of the system. A ““““critical normal force““““ which brings an important effect on the future movement of the system in the indeterminate states is found. After the motion pattern for the impact process is obtained from numerical results, a rule of the velocity‘s jump that incorporates the tangential impact process is deduced by using an approximate impulse theory and the coefficient of restitution defined by Stronge. The results of the jump rule are quite precise if the system rigidity is big enough.     

Magnetic Properties of Pt-Based Nanoalloys: A Critical Review

In recent years, magnetic nanoalloys (MNAs) have attracted many attentions from all over the world, due to their potential applications in the broad fields of magneto-optics, data storage, engineering, and biology. Among these MNAs, Pt–M (M = Fe, Co, Ni) MNAs have been considered to be the most promising ones, due to their superparamagnetism and response to a magnetic field. Here, we firstly review the experimental work on the synthesis, characterization, and magnetic properties of Pt–Fe, Pt–Co, and Pt–Ni MNAs. Then, we discuss the recent theoretical work on Pt–Fe, Pt–Co, and Pt–Ni MNAs. Moreover, we also review the main applications of Pt–Fe, Pt–Co, and Pt–Ni MNAs in the fields of biology, information storage, and magnetic separation. It is found that the size, shape, and composition of Pt–Fe, Pt–Co, and Pt–Ni MNAs play a critical role on their fundamental magnetic properties from both the experimental and theoretical points of view. It is expected that this review could be a valuable resource for both experimental and theoretical researchers, who are interested in Pt-based MNAs.