Synthesis,Structure and Luminescence of a Novel 2D Cadmium Coordination Polymer with a Ligand Generated in situ

The hydrothermal reaction of 1,2-dicyanobenzene with NaN3 in the presence of Cd(NO3)2 affords a novel 2D cadmium tetrazolyl-benzoate,{Cd(tzbz)(H2O)}n (H2tzbz is 2-(5-tetrazolyl)-benzoate). The tzbz ligand is generated in situ through the 2+3 Sharpless cycloaddition reaction and hydrolyzation. Its crystal structure was determined by single-crystal X-ray diffraction method. The crystal crystallizes in the orthorhombic system,space group Pbca with a=9.6659(19),b=7.6366(15),c=25.964(5) ,V=1916.5(7) 3,Z=8,Mr=318.57,Dc= 2.208 g/cm3,F(000)=1232 and μ=2.276 mm-1. The Cd(Ⅱ) atom is coordinated by four tzbz ligands and one water molecule to form a severely distorted pentangle bipyramid. While each tzbz ligand connects to four Cd(Ⅱ) atoms in a μ4-η1,η2,η1,η1,η1 coordination mode to construct a 2D architecture of the title complex. Additionally,the title complex exhibits strong fluorescence at room temperature in the solid state.     

四甲基锡在MCM-41分子筛表面的接枝反应及产物性能

研究了真空条件下SnMe4在MCM-41分子筛表面的接枝反应，并用元素分析、ICP、GC-MS、XRD、FTIR、DRS、13C及119Sn MAS NMR、XPS、BET、TPD、TPR等方法对产物的组成、结构和性质进行了表征.结果表明, 两者可以定量地进行化学反应，将确定数目的甲基锡基团接枝在分子筛表面, 形成SnMe3/MCM-41物种；接枝反应发生在分子筛表面上, 不破坏MCM-41分子筛骨架结构；改性分子筛的BET比表面积有所降低，孔体积变小, 表面性质发生变化.四甲基锡在MCM-41上接枝反应的温度为343 K,比它与HY沸石的反应温度(193 K)高得多，并且产物SnMe3/MCM-41的热稳定性也高于SnMe3/HY.     

Formation of Ultrafine Apatite Fibers by Sol-gel/Electrospinning

Ultrafine apatite fibers were prepared by electrospinning of sol-gel precursor/poly（ vinyl pyrrolidone） （PVP） solutions followed by subsequent calcination. The as-electrospun and calcinated fibers were observed under a scanning electron microscope and an optical polarizing microscope. Results show that the morphology and the diameter of as-electrospun fibers strongly depend on the viscosity and the surface tension of sol-gel precursor/PVP solutions. After calcination, the smooth as-electrospun fibers shrink and the fiber diameter decreases because of the removal of the polymer. The chemical evolution upon the transformation of the precursor from a gel to the final apatite fibers was investigated by thermogravimetric-differenfial thermal analysis, X-ray diffraction, and Fourier transform infrared spectroscopy. It is thus suggested that the crystalline structure of the calcined fibers is largely influenced by the calcination temperature. After being calcined at 600 ℃, the apatite fibers with a diameter of about 280 nm containing β-tricalcium phosphate were obtained.     

Synthesis and Crystal Structure of (2S,2'S,4'R)-2-(1-Hydroxy-1-ethylpropyl)-1-[(1'-p-tosyl-4'-hydroxypyrrolidin-2'-yl)methyl]pyrrolidine

1 INTRODUCTION In recent years, chiral β-amino alcohols have attracted much attention due to their special bio- logical functions and catalytic activities. Chiral β- amino alcohol moieties are usually found not only in natural products (e.g., cinchona alkaloids, ephe- drine, toxal, etc.) with special biological activities[1, 2], but also critical structural segments of some syn- thesized biologically active compounds, such as adrenergic agonists or antagolist[3, 4] and inhibitors for HI…     

原位红外光谱法研究La/TiO2对有机污染物的光催化降解

本工作采用改进的溶胶-凝胶法和浸渍法制备了TiO₂掺杂稀土离子La³⁺的La/TiO₂光催化剂，运用XRD、N₂吸附脱附、紫外可见漫反射光谱(DRS)、表面光电压谱(SPS)等手段进行表征，同时利用原位红外技术考察了La/TiO₂样品光催化降解乙烯、丙酮、苯的气-固相光催化氧化反应，对其光催化降解有机污染物的过程进行了研究。结果表明，TiO₂经适量La³⁺掺杂后，锐钛矿晶型的含量增加，晶粒度减小，比表面积增大，禁带宽度增加，表面光电压信号增强，光生电子-空穴对有效分离；La/TiO₂样品对乙烯、丙酮、苯的光催化性能与纯TiO₂相比均有不同程度的改善，乙烯可以被光催化氧化完全矿化生成CO₂，而丙酮被光催化氧化可能生成中间产物丙酸，苯被光催化氧化可能生成中间产物苯酚和苯醌。     

缬沙坦类似物合成中间产物的捕获(Ⅱ)

In this article we mainly discuss the effect of anion of Lewis acid on the structure of the intermediate in synthesis of valsartan analogue. The crystal belongs to monoclinic system with space group P2₁/c, and a=1.099 9(3) nm, b=1.913 4(5) nm, c=0.977 8(3) nm, β=104.806(4)°, V=1.989 5(9) nm³, D_c=1.708 g·cm^-3, Z=18. CCDC: 629931.     

异喹啉酸衍生物刷型手性键合固定相的制备及在联萘酚衍生物拆分中的应用

在(S)-THIQCA环上引入π 酸基团, 制备了一种新型的刷型手性固定相(CSP), 并用于联萘酚及其衍生物的拆分, 探讨了改性剂对色谱行为的影响.     

双－（3－烷基／芳基）－7H－1，2，4－三唑并[3,4-b]-1,3,4-噻二嗪类化合物的合成及波谱性质

利用1，4－二溴丁二酮（1）分别与3－烷基／芳基－4－氨基－5－巯基－1， 2，4－三唑（2a-2n）反应，合成了14种新的双－（3－烷基／芳基）－7H－1，2， 4－三唑并[3,4-b]－1，3，3-噻二嗪类化合物（3a-3n），并利用EA、IR，~1H NMR和MS确定了其结构。     

3-苯基-1-丁炔-3-醇质谱碎裂中[C8H7]^+的结构及分子内质子迁移反应

报道了3-苯基-1-丁炔-3-醇的常规电子轰击质谱(EIMS)。利用碰撞诱导解离(CID)技术研究了质谱碎裂过程中产生的[C8H7]^+的气相离子结构。同时, 氘代同位素交换、亚稳(MI)和CID实验进一步证实了m/z 103离子的形成并不是分子离子的质谱碎裂中顺次失去甲基自由基和中性CO分子的直接氢迁移的协同反应, 而是在失去CO分子前后发生了二次质子迁移反应的逐步过程。在此基础上提出了一种独特的双分子质子键合复合物中间体的碎裂机理。     

基于Al6Ge2O13还原制备Ge纳米粒子及其光致发光性能研究

以3-三氯锗丙酸和硝酸铝为原料，通过共沉淀法合成了Al₆Ge₂O₁₃陶瓷粉体，并利用TG-DSC、FTIR、XRD等研究了其形成过程。采用选择还原技术对Al₆Ge₂O₁₃进行还原处理，还原产物观察到发光峰位于564、611、681、730和774 nm的室温光致发光现象。比较不同温度下还原的样品，发现550 ℃保温3 h还原制备的样品发光强度最强，通过XRD、XPS和Raman光谱研究表明样品在可见和近红外光区的发光是源于平均粒径为1.98 nm且未能形成完整晶格的Ge纳米粒子团簇。