Effect of particle size of activated clay on the adsorption of paraquat from aqueous solution

This paper describes the effect of particle size on the process of paraquat adsorption from aqueous solution onto an activated clay surface at 25 degrees C and initial pH 11.0. Measurements of the pore properties of the clay adsorbents with three different particle sizes (0.053-0.074 mm, 0.037-0.053 mm, and <0.037 mm) were carried out. The rates and isotherms of adsorption have been also investigated by batch methods under the controlled conditions. From the experimental results obtained, the adsorption process can be well described with the pseudo-second order model and Freundlich model for adsorption kinetics and adsorption isotherm, respectively. In addition, the effect of the particle size of the clay adsorbent on the adsorption kinetics was found to be of considerable significance; namely, the rate constant (k) of paraquat adsorption by the clay adsorbent decreased with increasing particle size. It was concluded that the pore properties (i.e., surface area and total pore volume) and particle size of the clay adsorbent played a significant role in determining adsorption capacity and adsorption rate, respectively.     

A simple and versatile method for the synthesis of acetals from aldehydes and ketones using bismuth triflate

Acetals are obtained in good yields by treatment of aldehydes and ketones with trialkyl orthoformate and the corresponding alcohol in the presence of 0.1 mol % Bi(OTf)3.4H2O. A simple procedure for the formation of acetals of diaryl ketones has also been developed. The conversion of carbonyl compounds to the corresponding 1,3-dioxolane using ethylene glycol is also catalyzed by Bi(OTf)3.4H2O (1 mol %). Two methods, both of which avoid the use of benzene, have been developed.     

Preparation and chiral recognition of a novel chiral stationary phase for high-performance liquid chromatography, based on mono(6A-N-allylamino-6A-deoxy)-perfunctionalized beta-cyclodextrin and covalently bonded silica gel

A novel chiral stationary phase (CSP) was prepared by immobilizing mono(6A-N-allylamino-6A-deoxy)-perphenylcarbamoylated beta-cyclodextrin onto the surface of silica gel via hydrosilylation. The chromatographic properties of this column were tested with a wide range of structurally diverse racemic compounds and drugs under reverse phases. Separation mechanisms involved are also discussed.     

水相中乙醇对胶体泡沫性质的影响

用不同比例的水-乙醇混合物作水相制备了胶体泡沫（CLA）,实验观察并测定了CLA的形态、粒径分布、半衰期、Zeta电位、水相溶液的粘度和水相/油相之间的界面张力等性质.结果表明，水相中加入乙醇会影响CLA的稳定性和粒径大小,但对CLA的Zeta电位影响不大.乙醇对CLA稳定性的影响主要是由于乙醇分子嵌入到界面膜中导致膜的强度变化以及水相粘度发生变化导致CLA粒子间隙的排液过程发生变化.     

Effects of antimony on the surface tension of molten silicon

The effect of antimony concentration (C(Sb)/mass%) on the surface tension of molten silicon has been determined with the sessile drop method in the temperature range from 1693 to 1773 K and in the range of the oxygen partial pressure, Po(2), in an Ar atmosphere from 10(-23) to 10(-21) MPa. The results show that the surface tension of molten silicon decreases with increasing Sb concentration in the range of C(Sb)<0.9 mass%, which indicates positive adsorption of Sb in molten silicon and can be fairly described with the Szyszkowski's equation. The maximum decrease rate of surface tension is about 65 mN m(-1) (mass% C(Sb))(-1), and the temperature coefficient of surface tension, (partial differential sigma/ partial differential T)C(Sb), increases with increasing C(Sb). The evaporation of the systems was only observed between the melting points of antimony (904 K) and silicon (1683 K), and the surface tension presents no dependence on measuring time above the melting point of silicon.     

An improved procedure for the conversion of indolines into indoles

The addition of a sacrificial enamine (such as indole), or of a vinyl ether (like dihydropyran) to an indoline during dehydrogenation by phenylseleninic anhydride dramatically improves the yield of the corresponding indole. This is due to scavenging of Se¹¹ phenylselenenating species.     

Effects of mixed H2O‐CH3CN solvents on the rate of hydrazinolysis of N‐phenylphthalimide: Spectral and kinetic evidence for the occurrence of N‐aminophthalimide on the reaction path

Kinetic study on the cleavage of N‐phenylphthalimide (NPhPT) in the presence of 0.05 M NH₂NH₂ and mixed H₂O‐CH₃CN solvents reveals the occurrence of reaction scheme where A, B, C, C₁, An, E, and F represent NPhPT, o‐CO^?₂C₆H₄CONHC₆H₅, o‐CONHNH₂C₆H₄‐ CONHC₆H₅, N‐aminophthalimide, aniline, o‐CO^?₂C₆H₄CONHNH₂, and o‐CONHNH₂C₆H₄‐CONHNH₂, respectively. But, in the presence of either nonbuffered ?0.20 M NH₂NH₂ hydrazine buffer of pH ～7.30–8.26 with total buffer concentration ([Buf]_T) of >0.02 M, further conversion of F to 2,3‐dihydrophthalazine‐1,4‐dione (DHPD) has been detected depending upon the length of the reaction time (t), the values of [Buf]_T, and pH. It has been shown that the rate of conversion of C₁ to F is much faster than that of C to C₁ which is much faster than that of F to DHPD. The reaction step A → C involves general base (GB) catalysis, while step C → C₁ seems to involve specific base–general acid (GA) and GB‐GB catalysis. © 2005 Wiley Periodicals, Inc. Int J Chem Kinet 37: 147–161, 2005