The structure of invertible substitutions on a three-letter alphabet

We study the structure of invertible substitutions on three-letter alphabet. We show that there exists a finite set of invertible substitutions such that any invertible substitution can be written as I_wσ₁σ₂σ_k, where I_w is the inner automorphism associated with w, and for 1jk. As a consequence, M is the matrix of an invertible substitution if and only if it is a finite product of non-negative elementary matrices.     

Investigation of the Property Constants of Both Al and Cu Complexes with Picramine Ca and Using Competition Coordination for the Selective Determination of Trace Amounts of Cu

The reactions between Cu(II) and picramine CA (PCA) and Al(III) and PCA were both sensitive at pH 7. The competition coordination between Cu and the Al–PCA complex was applied to the selective determination of Cu (CCSD) by the spectral correction technique. Results have shown that the complexes formed at pH 7 are Al₂(PCA) and Cu(PCA)₃, their cumulative stability constants are 4.43 × 10⁵ and 2.08 × 10¹⁵, respectively, and their real molar absorptivities are 5.78 × 10³ at 650 nm and 3.19 × 10⁴at 530 nm. At the analysis of the samples, the relative standard deviation (RSD) was 5.0% and the recovery rate of Cu was between 94 and 108%.     

Deposition of Hydrogen-Free Silicon Nitride Thin Films by Microwave ECR plasma Enhanced Magnetron Sputtering at Room Temperature

Hydrogen-free silicon nitride （SiNx） films were deposited at room temperature by microwave electron cyclotron resonance （MW-ECR） plasma enhanced unbalance magnetron sputtering system. Both Fourier-transform infrared spectroscopy and x-ray photoelectron spectroscopy are used to study the bonding type and the change of bonding structures of the silicon nitride films. The results indicate that the chemical structure and composition of SiNx films deposited by this technique depend strongly on the N2 flow rates, the stoichiometric SiNx film, which has the highest hardness of 22.9 GPa, could be obtained at lower N2 flow rate of 4 sccm.     

Control of LHCD on the HL-2A Tokamak

in order to study non-indutive plasma current production, the lower hybrid current drive（LHCD） experiment on the HL-2A tokamak is carried out. Simultaneously a microcomputer has been used to control the whole LHCD system. During the experiment this year, we can monitor and protect the LHCD system by use of the microcomputer control system, which will imediately switch off the microwave power to be launched into the tokamak if the plasma is disrupted. All this ensure that the microwave is injected into the equipment correctly.     

3,7-二硝基亚氨基-2,4-二氮杂双环[3,3,0]辛烷的放热分解反应动力学

在程序升温条件下 ,用DSC研究了标题化合物的放热分解反应动力学 .用线性最小二乘法、迭代法以及二分法与最小二乘法相结合的方法 ,以积分方程、微分方程和放热速率方程拟合DSC数据 .在逻辑选择建立了微分和积分机理函数的最可几一般表达式后 ,用放热速率方程得到相应的表观活化能 (Ea)、指前因子 (A)和反应级数 (n)的值 .结果表明 :该反应的微分形式的经验动力学模式函数、Ea 和A值分别为 (1-α) 0 .44、2 30 .4kJ/mol和 10 18.16s-1.借助加热速率和所得动力学参数值 ,提出了标题化合物放热分解反应的动力学方程 .该化合物的热爆炸临界温度为 30 2 .6℃ .上述动力学参数对分析、评价标题化合物的稳定性和热变化规律十分有用 .     

函数一致连续的一个充要条件

给出了一元函数在区间上一致连续的一个充分必要条件,举例说明了使用它来讨论函数在区间上的一致连续性将更为简单.     

奇妙的惯性力

实际的参考系都不是惯性系，因此必须考虑惯性力．     

碳纳米管阵列、捆束的三步升温工艺制备及其形貌与结构

使用结构简单的单温炉设备，通过三步升温热解二茂铁、三聚氰氨混合物方法，在二氧化硅、多晶陶瓷基底上分别合成了碳纳米管阵列、碳纳米管捆束.使用扫描电子显微镜、透射电子显微镜、电子能量损失谱和x射线光电子能谱对合成样品进行了结构和成分分析.结果显示：两种基底上合成的纳米管均为多壁纯碳管；生长于光滑二氧化硅表面的碳纳米管具有高度取向性和一致的外径，长度为10—40μm.碳纳米管采取催化剂顶端生长模式并展示出类杯状形貌；生长于粗糙多晶陶瓷表面的碳纳米管捆束随机取向，碳纳米管直径为15—80nm，长度在几百微米，展示 关键词： 碳纳米管 热解法 三步升温工艺     

基于遗传算法和指标满意度求解的第三方物流企业物流中心选址方法

本利用AHP和模糊综合评价法评价物流中心选址的定性指标、用量化选址模型结合遗传算法计算定量指标，再藉助指标满意度求解把定性和定量的指标进行综合，从而为决策对物流中心选址做出科学的决策提供支持。     

成分和厚度的依赖

通过调整Mn的成分，系统地研究了Ni81Fe19/Ni100-xMnx双层膜的磁学性质，特别是交换偏置场(Hex)的变化.当Ni100-xMnx中Mn的原子百分比在534%到600%之间时，对于150nm的Ni81Fe19，得到了最大的交换偏置场175kA/m，同时由于Mn对Ni81Fe19层的扩散所造成的磁矩的降低小于20%；高角x射线衍射证明Ni100-xMnx的晶格常数随着Mn成分的改变而变化，Mn含量越多，其晶格常数越大；制备态Ni100-xMnx膜晶格常数与θ相NiMn膜晶格常数的接近程度与NiMn膜θ相形成的容易程度相对应.也研究了交换偏置场随着Ni１００-xMnx厚度的变化，第一次得到了当Ni100-xMnx中Mn的原子百分比为706%时，Ni81Fe19(150nm)/Ni100-xMnx(90nm)双层膜在经过240℃，5h退火后，可以有80kA/m的交换偏置场，此时铁磁层磁矩的大小几乎不变. 关键词： Ni81Fe19/Ni100-xMnx 交换偏置场