两种计算吸光光度法同时测定钙镁

研究了在pH10．5的硼砂-氢氧化钾缓冲溶液和乙醇的增敏作用条件下，偶氮氯膦Ⅰ与钙、镁的吸收特性，建立了多波长光度法同时测定钙和镁的方法。采用两种矩阵算法对试验数据进行处理，并对结果进行比较和分析。钙和镁含量在0～25μg／25ml范围内用计算法Ⅱ能得到准确结果。     

二甲醚电氧化及其阳极催化剂研究

Anode electro-catalysts for direct dimethyl-ether fuel cell (DDFC), Pt/C, PtRu/C (1∶1) and PtSn/C (3∶2), were prepared by chemical impregnation-reduction method with formaldehyde as the reductant. DME electro-oxidation and adsorption at Pt electrode and Pt electro-catalysts were investigated by Cyclic Voltammetry(CV), Quasi-steady state polarization and Gas Chromatography(GC). CV showed that there were two current peaks of DME electro-oxidation at Pt electrode around 0.8V (vs RHE); DME was adsorbed at Pt electrode more weakly and slowly than oxygen, methanol, even hydrogen; the onset potential of DME oxidation was 50mV less than that of methanol, and DME peak potential 110 mV lower, thus more advantageous for using in fuel cells than methanol. GC showed that small amount of HCHO was generated during DME electro-oxidation. The mechanism of DME electro-oxidation was proposed. Among the three electro-catalysts (Pt/C, PtRu/C and PtSn/C), Pt alloy catalysts, especially PtRu/C, showed a higher performance toward DME electro-oxidation, as in the case of methanol. Temperature experiments showed that both DME electro-oxidation and adsorption on Pt and Pt alloy catalysts were favored with increased temperature.     

Identification of Different Cobalt Nucleation on Glassy Carbon

The nucleation mechanisms of cobalt from sulfate solutions were studied by utilizing the electrochemical technique, chronoamperometry. It was found that the recorded current-time transients introduced from 1.0mol/L CoSO4 solution were complexes with unusual shapes. All characteristic features were identified as separate process. The instantaneous or progressive nucleation with 2D or 3D growth exists during the cobalt deposition, depending on the applied potentials.     

室温固相反应一步合成N-亚水杨基-4-氨基安替比林

4-氨基安替比林与水杨酬醛通过室温固相反应合成N-亚水杨基-4-氨基安替比 林，反应无溶剂，15 min即可完成，产率达95%，用元素分析，IR，~1H NMR，X射 线粉末衍射和X射线单晶衍射对产物进行了表征。     

全硅MCM-41担载的加氢脱硫催化剂的TPR研究

用TRP技术研究了以全硅MCM-41(Si-MCM-41)和HNO3交换的全硅MCM-41(H-MCM-41)为载体制备的Ni-Mo、Co-Mo和Ni-W加氢脱硫(HDS)催化剂的还原性能，并以0．8(wt)％二苯并噻吩(DBT)的十氢萘溶液为模型化合物，在高压固定床反应器上考察了上述催化剂的加氢脱硫(HDS)反应性能。结果表明，Si-MCM-41经稀HNO3交换后，所担载的Ni-Mo和Ni-W催化剂还原性能、HDS活性和加氢活性有显著变化，但对Co-Mo催化剂影响不大。这说明在Ni-Mo／H-MCM-41和Ni-W／H-MCM-41中可能存在氢溢流现象，DBT的HDS活性与载体表面酸性和氢溢流有关。     

CuO/γ-Al2O3单分散催化剂的XAFS研究

采用XAFS方法研究浸渍法制备并于低温焙烧的CuO/γ-Al2O3催化剂的局域结构.对于CuO负载量小于单层分散阈值的CuO/γ-Al2O3(0.4mmol/100m2),结果表明,CuO物种是以层状分散的孤立原子簇存在于γ-Al2O3载体表面,其第一近邻Cu-O配位环境的结构与晶态CuO的相似,键长和配位数分别为0.195nm和4.对于CuO负载量等于单层分散阈值的CuO/γ-Al2O3(0.8mmol/100m2),已有少量的CuO纳米颗粒生成.对于CuO负载量大于单层分散阈值的CuO/γ-Al2O3(1.2mmol/100m2),其结构与多晶CuO的相近.基于CuO在γ-Al2O3载体上的三种不同分散状态的结构特点,我们提出了CuO/γ-Al2O3催化剂的结构模型.     

人参中总皂甙的超声波快速提取方法研究

建立了人参中总皂甙超声波半微量快速提取方法，与索氏提取法相比，此法提取时间由索氏法的1－2个工作日缩短到30min，节省大量试剂，综合提取效率提高数十倍，与索氏提取法对照分析表明，此法可完全满足人参中总皂甙的快速测定要求。     

Dispersion state and catalytic properties of vanadia species on the surface of V_2O_5/TiO_2 catalysts

The dispersion state and catalytic properties of anatase-supported vanadia species are studied by means of X-ray diffraction (XRD), laser Raman spectroscopy (LRS), H2 temperature-programmed reduction (TPR) and the selective oxidation of o-xylene to phthalic anhydride. The almost identical values of the experimental dispersion capacity of V2O5 on anatase and the surface vacant sites available on the preferentially exposed (001) plane of anatase suggest that the highly dispersed vanadium cations are bonded to the vacant sites on the surface of anatase as derived by the incorporation model. When the loading amount of V2O5 is far below its dispersion capacity, the dispersed vanadia species might mainly consist of isolated VOx species bridging to the surface through V-O-Ti bonds. With the increase of V2O5 loading the isolated vanadia species interact with their nearest neighbors (either isolated or polymerized vanadia) through bridging V-O-V at the expenses of V-O-Ti bonds, resulting in the increase of the ra     

新型仿生聚合物胶束用于纳米药物载体的研究

对两亲性聚合物进行设计和优化, 从细胞膜仿生的设计出发, 利用原子转移自由基聚合, 制备了一种以胆固醇为疏水段、以仿细胞膜磷酸胆碱基聚合物为亲水段的两亲性分子CMPC. 在对其溶液胶束自组装行为进行探索的基础上, 以水包油(O/W)溶剂挥发法制备了包含抗癌药物阿霉素(ADR)的纳米抗癌药物载体, 通过体外细胞培养, 研究了仿细胞膜两亲分子的细胞相容性, 并对抗癌纳米药物载体抗肿瘤细胞的药效进行了初步研究.     

稀土电解槽的研究现状及发展趋势

综述了国内外稀土电解槽的类型和特点,国内在稀土电解槽的电场、磁场、流场、熔盐性质、工艺条件、电阻常数以及电解槽的热平衡和电极材料等方面的研究现状。提出了槽电压与结构参数之间的关系以及结构参数的优化设计方法,根据槽容量进行优化设计可显著降低槽电压,达到节能降耗的目的。