压力淬火过程中锗的相结构研究

 应用高压原位差热方法，直接测量了压力下锗的固化参数─—固化温度与过冷度。高压差热信号表明，当压力大于3 GPa时，锗在凝固过程中可能发生结构相变。X射线结构分析表明，在最终的样品中除GeⅠ相外，还形成GeⅢ相和GeⅣ相。     

离心力场作用下多孔介质中强制对流换热的研究

对离心流化床中空气通过多孔物料层的强制对流换热进行了理论和实验研究。获得了气流和物料间强制对流换热的准则关联式。研究结果表明,在气流速度和温度梯度方向一致的条件下,强制对流换热比通常的边界层强制对流换热有所强化,其换热的准则关联式具有 Nu=CRePr的线性形式。从而验证了改变气流方向和热流密度矢量之间夹角可以强化换热的这一强化传热新原理。     

固体间界面的物理模型和界面对声波的反射

简要描述了模拟两固体间界面特性的弹簧模型，该模型最早是根据静力学方法提出的，后来用固体间界面薄层的声波反射方法加以改进，从界面弹簧模型可以方便地得到界面外近似边界条件，其中包含界面“弹簧”振子的劲度常数和质量，文章还给出了两相间固体中界面声反射系数的表达式，介绍了测量界面劲度常数的超声反射谱方法。最后讨论了仍关声波与界面相互作用研究领域中最近的一些研究进展。     

The Combinatorics of Laguerre,Charlier, and Hermite Polynomials

This paper describes several combinatorial models for Laguerre, Charlier, and Hermite polynomials, and uses them to prove combinatorially some classical formulas. The so-called “Italian limit formula” (from Laguerre to Hermite), the Appel identity for Hermite polynomials, and the two Sheffer identities for Laguerre and Charlier polynomials are proved. We also give bijective proofs of the three-term recurrences. These three families form the bottom triangle in R. Askey's chart classifying hypergeometric orthogonal polynomials.     

计量累积和控制图方案设计的选择

常规控制图已广泛应用于生产,国家标准<计数型累积和图>GB4887-85的实施,使得判断生产“过程”异常具有更高的灵敏度,能更经济地保证产品质量,它是常规控制图的改进与发展.在常规控制图中,为了使控制图能对小偏差有较快的反映,一般用缩小控制界线,如将3σ限改为2σ限,但会导致第一类误判率大大升高.而累积和方法可以通过对方案参数的适当选择使控制图在第一类误判率并不明显升高的情况下对小偏差反映敏感.此外,累积和方法还允许针对各种需要设计出特别适于发现某个偏差,例如1.5σ_e 的     

纳米级精度分光路双频干涉度量系统的设计

为完成快速、精确的外观轮廓度量,设计了一种新型纳米级精度分光路双频干涉度量系统。系统由低频差双频激光干涉度量模块和微探头及二维工作台两部分组成。微探针以轻敲式接近样品至几十纳米时,受原子力作用发生偏转,利用双频干涉模块度量其纵向偏转量,并对样品进行梳状式度量得到外观形貌。根据双频激光的实际光源,对原有双频干涉度量理论进行了改进提高。进行了系统组建和实验验证。结果表明:系统具有纳米级精度,可用于超精样品外观轮廓度量。     

机载稳瞄控制系统模型及仿真分析

瞄准线高精度稳定是机载光电稳瞄系统的主要指标和关键技术。根据四框架稳瞄系统的工作原理，以手动跟踪模式为主要研究对象，建立了稳瞄伺服控制系统模型。考虑到直升机扰动特点，对线扰动、角速率扰动、摩擦力矩、弹性力矩等各种扰动因素也建立相应的数学模型，同时在各种扰动因素作用下利用Matlab对机载高精度稳瞄系统的手动跟踪控制模式进行了仿真设计分析和理论研究，设计出适合的控制器。此模型在实际系统中获得验证，对稳瞄伺服控制系统的设计具有参考意义。     

HIRFL-CSRe二极铁积分磁场测量

 介绍了兰州重力加速器冷却储存环实验环二极磁铁积分长线圈测磁装置的构成，描述了实验环二极铁的分散性测量、横向分布测量、传递函数等测量内容及测量方法。实验环二极铁采用不断地加减硅钢铁片垫补和加调整线圈电流的方法来调整二极磁铁的有效长度来改变分散性。通过垫补和测量，二极磁铁的分散性在优化磁场时达到±2×10^-4。同时给出了二极铁的横向分布和传递函数的测量结果。对二极铁的设计和加工进行了修正。     

TCH-600氧、氮、氢分析仪在唐钢的应用

通过TCH-600氧、氮、氢分析仪在唐钢的实际应用,重点介绍了助熔剂、坩埚、样品熔解及空白和校正过程中应注意的问题,钢铁样品分析条件的选择.     

The acoustic characteristics of clause, sentence and paragraph boundaries in Chinese Putonghua

The acoustic and perceptive characteristics of discourse units, including clauses, simple sentences, compound sentences and paragraphs, were studied. The acoustic characteristics were based on the analysis of a speech corpus consisted of ten monologues. The Perceived Boundary Strength (PBS) of the monologues was labeled on a five-point scale by 25 participants. The main results are as follows: (1) There is a significant difference in the PBS of clauses (corresponding to intonational phrase), sentences (including simple sentences and compound sentences) and paragraphs. But the PBS of simple sentences and compound sentences is the same, and the pitch reset and pause are also not significantly different between these two kinds of boundaries. (2) The pitch-based cue used to distinguish clauses, sentences and paragraphs appears to be the difference between pre- and post-boundary syllables, but not simply the pitch value of either syllable alone. (3) Declination mainly occurs within intonational phrases, whereas there is no consistent global declination in sentences or in paragraphs. (4) Pauses are longer and more varied at the boundary of larger discourse units. Moreover, there is a significant positive correlation between pause duration and degree of pitch reset at clause boundaries, but not at sentence or paragraph boundaries.